Which of the following flow meters is of positive displacement type? mass gas flow meter rotameter O pitot tube bourdon tube nutating disk vortex shedding flow meter

Q: From the below given graph for venturimeter experiment the value of A is 5.05 and the value of B is…

A:

Q: 9. Liquid benzene at 20°C is to be pumped from a storage tank to a chemical reactor through 165 ft…

A: Given: The length of pipe 1, L1 = 165 ft The diameter of pipe 1, d1 = 2 in The length of pipe 2, L2…

Q: List any four advantages of the Vertical Axis Wind turbine.

A: Four advantages of vertical axis wind turbine - 1) Omnidirectional Natural of the Rotor Vertical…

Q: The coefficient of orifice meter depends on the ratio of pipe diameter to the orifice. False True

A:

Q: TRUE or FALSE Pitot tube is an insertion meter. When this is located at the center, the flow that…

A: Solution is attached below:

Q: The air is measured at 30 deg. C and 518mm Hg. The duct diameter is 585 mm while the discharge…

A:

Q: List any four advantages of the Horizontal Axis Wind Turbine.

A:

Q: ong Stag 2. The following data relate to an inclined venturimeter: Diameter of the pipe line = 400…

A:

Q: Determine the discharge at pipeline 3 in lit/sec assuming f=0.02 for all pipes.

A: Given data Discharge (Q)=0.86m^3/s  Friction factor (f) =0.02

Q: Explain the principle of operation of the mag flow meter using a clearly labelled schematic diagram…

A: A magnetic flow meter is basically a transducer that measures fluid flow by the voltage induced…

Q: he ratio of actual discharge to theoretical discharge through an orifice is coefficient of discharge…

A: Answer is True.

Q: Effect of vane angle of a pump head against discharge,using equation and diagram 12:16

A: following is the answer to above question-

Q: Pressure measuring devices liké manometers are used to measure discharge in pipes. Select one: O…

A: Solution:

Q: The venturimeter is a discharge measuring instrument. Select one: O True O False

A: Venturimeter is a device works on the principal of Bernoulli theorem, used in measuring flow rate or…

Q: In turbine flowmeters, the flow rate is proportional to the frequency of magnetic pulses. a. True…

A: Turbine flowmeters - It is a device which is used to measure the volume flow rate of turbine with…

Q: 5. What is the total flow from a Venturi system if one jet neb is set on .6 FIO2 with a flowmeter…

A:

Q: Q. Define coefficient of discharge and write equation for actual discharge.

A: Coefficient of dischargeCoefficient of discharge is defined as the ratio of  the actual flow…

Q: The pitot tube is used to measure the velocity of flow at the required point in a pipe Select one:…

A: The pitot tube is a velocity measuring device that is used to measure the velocity of the flow at…

Q: 10 m3/min of free air is to be compressed to 8 bar gauge in two stages. Assuming an intercooler…

A: Apply the relation of the polytropic index.

Q: TTT 2" 3/4" 2" 3/4 3/4" 3/4" Determine the required purging flow through the following manifold.…

A: PURGING FLOW Purge liquids are brought into the instrument drive lines, complex valves, or the…

Q: Which of the following flow meters is not suitable for very low flow rate? magnetic paddle wheel…

A: Given Flow meters To find Determine the flow meter among the option which are not suitable for very…

Q: coefficient of discharge=

A: Given: h1=314 mm h2= 286 mm Q=165 ltter/s A1=338.6 mm2 A2=84.6 mm2 To determine: The coefficient of…

Q: The effect of introducing orifice plate in the flow meter is

A:

Q: Determine the pump head (unit: meter or kPa), using the following parameters

A:

Q: Jet water in Pipe with chameter equal to Somn to velocity-30 - divided into two branches with…

A: The velocity will remain the same in both the pipes. V=V1=V2 Now,

Q: The velocity measurement observation manometer readings are 44.5 cm , 48.5 cm . The pipe diameter is…

A: Given      h1 = 44.5 cm     h2 = 48.5 cm       d = 139 mm

Q: Pitot tube is an instrument is not used for measuring the velocity at any point in a pipe Select…

A: Basically, Pitot tube is a slender tube, which is used to measure the velocity of fluid flow at any…

Q: Which expression is used for calculation of head losses? AL a D b L V? 2 v2 SP = 2

A:

Q: The air is measured at 48 deg. C and 647mm Hg. The duct diameter is 545 mm while the discharge…

A: As per the guidelines, I can solve only one question at time. And, by default, I am solving first…

Q: Lukewarm water at 60 °C in a storage tank is being pumped at 300 L/min from the tank. The line from…

A: Water temperature, T=60oCWater flow rate, Q=300 L/min=300*10-360m3/s=0.005 m3/sLength of suction…

Q: he flow emperati

A: Given: Fluid flow rate and inlet temperature for a counter flow, concentric tube heat exchanger of…

Q: What are the relative advantages of using a Venturi meter to measure flow compared with an orifice…

A:

Q: Cheaper and simpler device for measuring discharge is: * a) Venturi b) Orifice…

A: OPTION b IS CORRECT ORIFICE.

Q: The velocity of the liquid flowing through the divergent portion of a Venturimeter is increases…

A: Solution:

Q: Question 25 Cross sectional area variations in pipes have to be accounted for when designing fluid…

A: Cross sectional area variations in pipes have to be accounted for when designing fluid motive…

Q: نقطة واحدة Flow of air through a tapering-10 * pipe is steady uniform unsteady non-uniform steady…

A: 10) Consider a point A at some distance in the tapered pipe. The main flow parameters such as…

Q: A pump has a 100 mm diameter suction pipe and a 75 mm discharge pipe. The capacity is 15 L/s of…

A:

Q: when fluid flows through venturimeter there will be a pressure difference at the inlet part and…

A: When fluid flows through venturimeter there will be a pressure difference at the inlet part and…

Q: A venturi meter is to be installed in a schedule 40, 6-inch line to measure the flow of water. The…

A: Given data: *The maximum rate of the flow is Q=800 gpm=1.7825 ft3/s *The length of the manometer is…

Q: The ratio of theortical discharge to actual discharge through an orifice is coefficient of discharge…

A: The ratio of actual discharge to theoretical discharge is the coefficient of discharge of orifice.…

Q: Lukewarm water at 60 degree c in a storage tank is being pumped at 300 L/min from the  tank. The…

A:

Q: Real operating diffuser throat area in a wind tunnel should be less than A_y^

A: Real operating diffuser condition is applying in the wind tunnel

Q: Air, 4 psi Air, 3 psi 5 ft 2ft Water Water 4 in. dia C-0.85 FIG. 9.43 27. Calculate the discharge…

A: Orifice meter are those devices which are used to calculate the rate of flow of a fluid. Given,…

Q: 3. A pump steadily circulates oil used for lubricating heavy machine tools. The volume flow rate and…

A:

Q: In Lobe pump small sized particles can be pumped much effectively than in other positive…

A: It is true that in lobe pump small sized particles can be pumped much effectively than in other…

Q: _______ flowmeters measure by measuring the speed of its rotor blades as it rotates. a. turbine…

A: _______ flowmeters measure by measuring the speed of its rotor blades as it rotates. a. turbine b.…