Which of the following statements is true about routing functions? A router uses network addresses to forward messages. A router forwards DHCP frames at Layer 2. Both (A) and (B) are correct. None of the above are correct. 2) A WiFi access point is responsible for the following: Flow and error control. Identifying Network protocols. Multiple-access resolution. All of the above.

Which of the following statements is true about routing functions? A router uses network addresses to forward messages. A router forwards DHCP frames at Layer 2. Both (A) and (B) are correct. None of the above are correct. 2) A WiFi access point is responsible for the following: Flow and error control. Identifying Network protocols. Multiple-access resolution. All of the above.

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

9th Edition

ISBN:9781305266452

Author:Jean Andrews

Publisher:Jean Andrews

Chapter8: Connecting To And Setting Up A Network

Section: Chapter Questions

Problem 2TC

See similar textbooks

Similar questions

THINKING CRITICALLY Which of the following hosts on a corporate intranet are on the same subnet? a. b. c. d.
Which two of the following hosts on a corporate intranet are on the same subnet? a.192.168.2.143255.255.255.0b.172.54.98.3255.255.0.0c.192.168.5.57255.255.255.0d.172.54.72.89255.255.0.0
I NEED ONLY CORRECT OPTION NO NEED TO EXPLAIN IN DEPTH,PLEASE SOLVE ALL THE QUESTION, DON'T LEAVE ANY QUESTION AND IF YOU DON'T KNOW THE CORRECT ANSWER THEN PLEASE LEAVE IT OTHERWISE I WILL DOWNVOTE IT.... 1. Which of the following statements are correct?I. The User Datagram Protocol (UDP) is used for applications that requires constantdata flow.Il.The header size in Transmission Control Protocol (TCP is small when compared tothe header size of User Datagram Protocol (UDP).I!.The Transmission Control Protocol (TCP) is byte oriented.IV. The User Datagram Protocol (UDP) is used for routing.(a) I, II, and III only(b) II, Ill, and IV only(c) I, Ill, and IV only(d) I, Il, and IV only 2. Which of the following statements are true when the block size in a fixed block size filesystem is increased?1. disk throughput is increased2. disk throughput is decreased3. disk space utilization is increased4. disk space utilization is decreased 3. What is the output of below…
Assume that Computer A, which is connected through an Ethernet cable to the Switch S1, is just powered on. The user opens a browser and then types a website address to receive the website from the Server (as shown in Figure 1). Write down all the important protocols that come into play by the time the first frame containing HTTP request reaches R1. (Note: Before HTTP frame, other frames have already been sent by other protocol(s).) Write down all the protocols with reference to the TCP Model as follows? Application Layer: Transport Layer: Internet Layer: Link Layer:
Given an IP address 94.0.0.0/20, answer the following questions: I. What is the IP address class? II. Netid and hosted? III. Number of bits borrows? IV. Number of total subnets created? V. Number of bits left? VI. Number of host per subnet? VII. Total of host for all subnets? VIII. The new subnet mask? (after subnetting) IX. Show the subnet address, host range and broadcast address of the first and the last block of the subnet created.
Refer to the following dynamic NAT configuration. The router R1 has 2 interfaces with the following configurations: G0/0 – inside network – 10.1.1.1/24 S0/0/1 – outside network – 209.165.200.225/27 End users are complaining that they can not access the Internet and, as a network engineer, you have been asked by your manager to analyze the NAT configuration and fix the problem. What part of the configuration is most likely incorrect? How it can be fixed? R1(config)# ip nat pool nat-pool1 209.165.200.226 209.165.200.240 netmask 255.255.255.0 R1(config)# ip nat inside source list 1 pool nat-pool1 overload R1(config)#interface G0/0 R1(config-if)# ip address 10.1.1.1 255.255.255.0 R1(config-if)#ip nat inside R1(config)#interface S0/0/1 R1(config-if)# ip address 209.165.200.225 255.255.255.224 R1(config-if)#ip nat inside R1(config)#access-list 2 permit 10.1.1.0 0.0.0.255
Which of the following statements could be valid with respect to the ICMP (Internet Control Message Protocol)? a. It reports all errors which occur during transmission. b. A redirect message is used when a router notices that a packet seems to have been routed wrongly. c. It informs routers when an incorrect path has been taken. d. The "destination unreachable" type message is used when a router cannot locate the destination.
Given the topology below, write the commands to advertise the OSPFv3 networks on the Sohar router. Use the following requirements: - Enable IPv6 routing- Process ID 10 - Router IDs (Sohar router = 2.2.2.2) - Advertise Network address for each interface - LAN interface (G0/0) set to passive interface - Assign Link-Local Addresses (fe80::1) to G0/0
The command below illustrates the configuration of the static route. Router(config)# ip route network-address subnet-mask {ip-address | exit-intf [ip-address]} [distance] What is the function of the parameter distance in the given command? a. To assign bandwidth b. To assign matric value c. To assign AD value d. To assign protocol value
Please answer all the three choosing the answer option. Thanks a lot in advance. 54) ___________ A passive IDS can terminate sessions by using the TCP-RST command. Answer True or False. 55) ____________ Switch function partially as routers at layer 3, load distributors at layed 4, and content filters at layer 6. Answer: True or False 57) A ___________ is a portion of a network with a common network address. answer: True or False