Which type of compensator is used for feeding reactive power at the receiving end?  Draw its block diagram.

Q: 2. Estimate the distance over which a load of 12000 kW at a p.f. 0-65 lagging can be delivered by a ...

A:

Q: T The long straight conductor shown the plone the rechnguar loop at in fig. lies in a distane e d = ...

A: The given from the question is; I1=10 AI2=20 Aa=0.4 mb=1 md=0.2 m The net magnetic force on the loop...

Q: Create a truth table for the given circuit where X and Y are inputs and Z is the output. Y

A:

Q: A sinusoidal voltage v = (10 sin 377t) V r.m.s is applied to a resistor of 50 Q. The average power d...

A: Given data: Vt=10sin377t VR=50 Ω

Q: Take the input as vin(t) and the output as vout(t), and find transfer functions of the electrical ci...

A:

Q: The below amplifier has a voltage gain of 10. What will be the Voltage Gain Vo/Vi of the amplifier? ...

A: Given the open-loop gain of the amplifier, Av=10   Apply the voltage divider rule at the output side...

Q: Which of the following is an example of constant power type of load ? O Compressor O Rotary pump O M...

A: Constant power load is a type of load in which its torque is roughly proportional with speed. As pra...

Q: An amplifier has a voltage gain of 10, an input resistance of 1M ohm and an output resistance of 10 ...

A: Consider the given circuit,

Q: 3. A single-phase transmission line has two parallel conductors 3.2 meters apart, radius of each con...

A:

Q: The x-y plne seporotes two megnetie mognetic permeabilities M, nd N2. f there is no surfoce arrent a...

A:

Q: Electrical Engineering _ control system, Notes : pls try to solve in less than 30 min.

A: The system is of form G(jw)=wn2(jw)2+2δwn+wn2 By comparing the equations,  wn2=6⇒wn=6=2.45 The value...

Q: VS = 15V , IA = 6mA, R1 = 3KΩ, R2 = 6KΩ, and R3 = 18KΩ Using Thevenin or Norton circuit determine th...

A:

Q: Pleass answer the dotted question

A: Silicon widely used in semiconductor industries due to  1. Silicon is widely available in nature and...

Q: Calculate the drain current and drain-source voltage at the operating point of the circuits shown in...

A: This question is "advance analog electronics". Under which we are going find out the "drain current"...

Q: How long does it take to transmit an 8-Mbyte file using UART serial communication that operates at 9...

A:

Q: a] After the 20N–100 2-50 2 wye is replaced by its equivalent delta, the circuit reduces to 320 Q 80...

A: In this question we need to find a reduce circuit

Q: A coaxial cable of 105 N impedance is used to connect a satellite receiving antenna to the decoder. ...

A: Given, the impedance of the coaxial cable is 105Ω. capacitance (C)=75pF/m = 75*10-12 F/m diameter of...

Q: SOLVE THE FOLLOWING BJT CONFIGURATION DETERMINE VB, VC, VE, IE, IB, IC, VCE

A:

Q: Actuators and transducers are both examples of sensors: Select one: Oa. False O b. True

A: What is example of the sensor?  Is it true Or false  "actuator and transducer is example of sensor "

Q: I need help

A: The statement which describes both parallel and series lights 

Q: tlineGet 24/7 homework help and experts with bartleby learn. Subscribe now!arrow_forward   ...

A: Note: Since you have posted a question with multiple subparts, we will solve the first three subpart...

Q: Practice Problem 8.11 In the op amp circuit shown in Fig. 8.34, v, = 10u(t) V, find v.(t) for t > 0....

A: Given:vs=10u(t)R1=R2=10kΩC1=20μFC2=100μF

Q: Find V, using Thevenin's theorem 2KO 3KO Vx Vx 5KN Vo 4V 4000

A: The given circuit is

Q: me, Rins value aud Form factor of the v

A: The several types of wave-form are used as an input wave are given below. Sinusoidal wave Square wa...

Q: if the base supply voltage is 2v in fig 7-30 c what is the current through the led

A: By considering the given LED is a ideal. Hence from the given transistor diagram the collector curre...

Q: 1. Write the asynchronous motor 1-phase equivalent circuit and its equations? 2. Explain by drawing ...

A:

Q: The X-Y plane of a pole - zero map is called as Polar Plane O F(s) Plane S- Plane O Cartesian System

A: In this question we need to find a pole zeros drawn in which plane

Q: directions in image

A: In this question , we will find capacitor voltage..

Q: While drawing N circles, if the value of radius is 4.65, then the value of N is Bode plot analysis i...

A:

Q: Electrical Engineering _ control system, Notes : pls try to solve in less than 30 min.

A:

Q: Which one of the following rectifier mostly used in a DC regulated power supply? Ohalf-wave rectifie...

A: In case of half wave rectifier, the output is not continuous. So, it cannot be used for DC regulated...

Q: A single phase line has two parallel conductors 1.5 meters apart. The diameter of each conductor is ...

A: According to question we have to calculate the value of inductive reactance and capacitive reactance...

Q: Quiq plz

A: In this question , we will define to make system unstable to stable...

Q: A displacement sensor produces an output of 10mV per centimeter of movement. What could be the outpu...

A: Given:-  Output Voltage for 1 cm movement =10mV

Q: Which of the following compensator is used to improve the margin of stability?

A: A compensator is a component in the control system and it is used to regulate another system

Q: Explain transistor amplifier and switching action with proper example.

A: Transistor act as an amplifiers by raising  strength of the weak signals. A DC bias voltages is  app...

Q: A sphere of + 11Q charge density of radius a is located in the center of a conductive sphere shell w...

A: Gauss's law can be used to determine Electric Field intensity-- Electric Field for all points inside...

Q: 4,7K Rc For the ampliffier netwark offig fle) cansider, =300ka,ße20- The de emittercurrent isobe03mA...

A: It = 0.3mA β=120∝ = ICIEIC = ∝IE IC = ββ+1IE IC= 120121x0.3 mA IC = 0.2975 mAgm = ICVt = 0.2971 mA 0...

Q: Electrical Engineering _ control system, Notes : pls try to solve in less than 30 min.

A: Correct option is cascade compensator.

Q: Two particles of Qı= -3µC and Q2= -5µC positioned coordinate (-3,3) m and (4,4) m respectively. Calc...

A:

Q: The advantage of the differential amplifier is in its: Select one: O a. Low input resistance O b. Hi...

A: The advantage of differential amplifier is in it's

Q: Which of the statements are the advantages of closed loop systems over the open loop systemImmersive...

A: the closed-loop systems have several advantages over the open-loop system. 

Q: Solve it fast fast plz

A:

Q: At no load total losses are equal to half load losses Select one: True False

A: In the transformer or in machine at no load total loss is equal to the core loss of the transformer ...

Q: Electrical Engineering _ control system, Notes : pls try to solve in less than 30 min.

A: The given roots are, -5+j2, -3, -5-j2 There are 3 roots given for a system.

Q: Quiq plz

A: In this question we need to find a which compensator is use to increase the relative stability.

Q: Q. NO.1. In the following circuit, the speed of the fan can be set high, medium or low by moving the...

A: Given V =10 VIh =7 AIm= 5 AIl =3 A Rf =0.01 ΏRload =30 mΏ  

Q: 2. Given: v(t) = 325.269 sin( 376.991t + 36.87 ) V Find : a. Vp b. Vp-p c. Vave d. VRMS %3D Answer: ...

A: Write the expression for the given sinusoidal wave. vt=325.269sin376.991t+36.87° V      ......1 Also...

Q: In the following circuit, if the resistance of the sensor varies linearly with the measured quantity...

A: In the circuit, if resistance of the sensor are linear, then Voltage across the R will be linear or ...

Q: Draw the dual circuit of the one in Fig. 8.46.

A: to covert the below circuit in its dual 

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.