With no load attached, the voltage at the terminalsof a particular power supply is 50.8 V. When a 10-Wload is attached, the voltage drops to 49 V.a. Determine vS and RS for this nonideal source.b. What voltage would be measured at the terminalsin the presence of a 15- load resistor?c. How much current could be drawn from this powersupply under short-circuit conditions?

With no load attached, the voltage at the terminalsof a particular power supply is 50.8 V. When a 10-Wload is attached, the voltage drops to 49 V.a. Determine vS and RS for this nonideal source.b. What voltage would be measured at the terminalsin the presence of a 15- load resistor?c. How much current could be drawn from this powersupply under short-circuit conditions?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

What is meant by FACTS in power systems? Discuss about UPFC type FACTS device.
AA chopper circuit in the figure, 400 ? (???)Control the power of an ohmic load from a 50 ?? source.. Since the load resistance is 20 Ω and ? = 30 °,a) The effective voltage, current and power of the load,b) Input power factor,c) Apparent, active and reactive powers drawn from the network,d) Minimum blocking voltage of thyristor,e) Average value of each thyristor current,f) The required firing angle for the power transferred to the load to be 80% of the maximum power,calculate.
Does Ohm’s Law appear to hold in this exercise? How?
Write the application of super tension that have rating upto 33KV and what used for?
Write about dc power supply Function Uses field How it used How it work Advantages and disadvantages Refer to parts names Pls no plagiarism
A. What is the importance of maximum power transfer? B. Where is maximum power transfer usually used at? C. How was maximum power derived?
A DC line has a resistance of 0.8 ohms. A load of 10 KW is taken at far end, while at the midpoint a current at 14 ampere at 204 volt is taken.Please find the supply voltage.
Describe the concept of power system stability and the methods used to analyze and improve it.
Discuss the concept of power system stability and the factors that influence it.
Discuss the challenges and strategies involved in microchip power management, especially in battery-powered devices. How does dynamic voltage scaling (DVS) work?
What is meant by FACTS in power systems? Discuss about STATCOM type FACTS device.
1. Thyristor switched reactor(TSR) for power factor improvement2. What is meant by economic dispatch? What are the advantagesof economic dispatch? (350 word)