Would Aluminium be an optimal choice for a low load and high load cycle applications? Yes, as long as the load is below the Aluminium fatigue limit Yes, as Aluminium is corrosion resistant No, because Aluminium has a lower stiffness and UTS than steel alloys No, because Aluminium has and endurance strength and could fail at low stress levels

Would Aluminium be an optimal choice for a low load and high load cycle applications? Yes, as long as the load is below the Aluminium fatigue limit Yes, as Aluminium is corrosion resistant No, because Aluminium has a lower stiffness and UTS than steel alloys No, because Aluminium has and endurance strength and could fail at low stress levels

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter28: Filler Metal Selection

Section: Chapter Questions

Problem 24R: What stainless steel(s) would a. have low creep at high temperatures? b. be used for food service...

See similar textbooks

Similar questions

Define the post-buckling behaviour of steel braces be modelled in ANSYS workbench?
What is Axial Load and explain with example?
a) A bicycle frame is being designed to carry a pedal force of 800N. Assuming axial loading only, which material will produce the lightest frame out of the two in the table below? Assume a design factor of 1.2 b) If the bicycle frame is being welded together and an internal flaw size of 30mm results, which material will produce the lighter section? (Apply a design factor of 1.2 If the bicycle frame needs to last a minimum 3 x 105 cycles, with an average stress of 150MPa and an alternating stress of 200MPa, use the Soderberg criterion to pick a suitable material from the two alloys listed above. Show all your working.
Give the definition of Poisson's ratio with an example?
what is the answer on this problem number 105?
Define the term distributing force?
Based on the table and the correct answers provided in Parts A-D, Are any of the claimed efficiencies impossible?
What are ratchet lines, and how are they arranged with respect to the fatigue crack front and any clamshell marks that may also be present?
Distinguish between the dead loads and the Live loads?Give their examples?
What is Limiting Friction? Describe it with some real case example.
Define the term Distributed loads?
A hook (Figure 7-27) for hoisting containersof ore in a mine is to be designed using a nonferrous (not based on iron) material. (A nonferrous material is used because iron and steelcould cause a spark that would ignite explosivegases in the mine.) The hook must support aload of 25,000 pounds, and a factor of safety of 2should be used. We have determined that thecross-section labeled ‘‘?’’ is the most criticalarea; the rest of the device is already well overdesigned. Determine the design requirements forthis device and, based on the mechanical property data given on the table design the hook and select an economical material for the hook.