Write the Boolean expression for each of the logic circuits in Figure?

Q: A coil having an area 2m² is placed in a magnetic field which changes from 1Wb/m² to 4Wb/m² in an…

A: In this question We need to determine the total emf  We know Emf = change in flux / time

Q: :Consider the sinusoidal current i(t) = 25 cos (400 πt + 60°) A ?What is the phase angle in radians…

A: Given data, Current is given as, it=25cos400πt+600 A.

Q: 4. F(s) = (s²+12)/s(s+2)(s + 3) = K₁/s + K2/(s + 2) + K3/(s+3) Find K₂ A) 2 C) -8 B) 8 D) 7

A:

Q: ET + Calculate the voltages across R2 and R3 RI VRI E2 Hot DR₂ R3 El voits = 21 E2 vots = 10.6 = 5…

A: Introduction Loop Law or KVL: The voltage loop law, also known as Kirchhoff's Voltage Law (KVL), is…

Q: Q1-A car travels at 120 km/hr. If the earth's horizontal magnetic field is 4.1 x10-6 Wb/m2 and the…

A: Given: Speed of the car=120 km/hr. Horizontal magnetic field =4.1×10-6 Wb/m2. Vertical magnetic…

Q: 2. A combination of inverters is shown in Figure 3-77. If a LOW is applied to point A, determin the…

A:

Q: The linear electron-concentration profile shown in Fig. E3.5 has been established in a piece of…

A:

Q: Consider the system H which is described by t-3 H : x(t) → y(t) = √ x(27 + 1)dr − 1. - 88 Find and…

A: Given: yt=∫-∞t-3x2τ+1dτ-1

Q: When two voltage sources connected in parallel same as the image below, does all elements have same…

A: Redrawing the circuit by marking the node V as shown below:

Q: Use two ideal op amps to implement the function: Vo= V1+2V2-3V3.

A: The required function can be implemented by using the two ideal inverting amplifier stages. The…

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given data:Load -1 :P1=950Wcosϕ1=0.5 Load-2:P2=1.14Wcosϕ2=1 Load-3:P3=760Wcosϕ3=0.5 line voltage,…

Q: Derive the transfer function of a High pass and low pass RC filter.

A: Transfer function of high pass and low pass filter can be derived as follows.

Q: Use the Newton-Raphson power flow to calculate the voltage magnitude and angle at bus two (Perform 3…

A: To solve the problem, we will use the Newton-Raphson power flow method. The steps involved are:…

Q: Find all of the currents and voltage drops for this circuit. (VCE, Vrc, Vrb, IC, IE, IB) Assume that…

A: In this question We need to determine the all unknown parameters.  Assume  VCE sat = 0.2V We know…

Q: a coil of copper wire has a resistance of 5.45 at 75C what will be its resistance at 25C?

A: Given : RT=5.45ΩT1=750CT,=250C

Q: 4) Find the minterms of the following Boolean expressions by first plotting function on a K-map: T =…

A: Introduction In boolean algebra, the true and false truth values, which are often expressed by the…

Q: Find the values of R₁, R2, R3, and R4, if V2 = R₁ 0.625 A 40 Ω + 50V- R2₂. Element 50 V source…

A:

Q: Problem 4. Find the inverse Laplace transform of the following transfer function. s²+s+4…

A: In this question We need to determine the inverse Laplace transform of the given signal.  We are…

Q: Given points P(3, -23, 46) and Q(31, 40, -49),  what is the distance between P and Q? (Use 4 decimal…

A: Here we have calculated distance between P and Q

Q: Find vo in the given circuit.

A:

Q: 4. Given the following circuit, solve for V₁. Must use Mesh Analysis.

A: The mesh equation can be obtained by applying kirchhoff's voltage law to the meshes and then by…

Q: Problem 16: Consider the system 5 G(s) = s(s+3)(s² +2s+1) Then the system is: ANS: (a) controllable…

A: it is asked to find whether the given system is controllable , observable??

Q: Find the Thevenin's equivalent circuit at terminals a - b, in the circuit shown in Fig. 4. 5/45° A…

A: Introduction Thevenin's equivalent circuit: Thevenin's theorem is a fundamental principle in…

Q: find V1, V2, V3, and V4 from these 4 equations: ((5sin(120pi t) - V1) / 470) + ((V2-V1)/…

A: It is given that: 5sin120πt-V1470+V2-V1-j3.195×103+V3-V4-j56.92×103=0                        .......…

Q: The voltage source, Vs, in the RC circuit has been at 0 V for a long time and then goes to 1 V at t…

A: In this question we need to find time constant, capacitor voltage expression as function of time and…

Q: Using the given transfer functions of the open-loop system, determine the stability region of the…

A:

Q: large flat roof is covered with PV-modules. The system is expected to annually deliver 50 000…

A:

Q: In the circuit shown, the voltage Vx is 0.5V 54(D) 10Ω 2002 ΒΩ ΜΑ • 0.25 V.

A: Given circuit:

Q: Design a series RLC bandpass filter (see (Figure 1)) with a quality of 6 and a center frequency of 7…

A:

Q: An oscillator may be viewed as a “badly designed" negative-feedback amplifier; so badly designed…

A: This question deals with an oscillator which is to be viewed as a "badly designed" negative-feedback…

Q: Q1) build a componet form of the vector h +s

A:

Q: A 5μF-capacitor is charged to a 12 V and then connected to a 4000-resistor. Find, (a) The time…

A: We need to find out the time constant for given RC .

Q: Three capacitors are connected in series to be used in a circuit at 1 GHz. The capacitor values are…

A: Introduction Capacitive reactance is a measure of the opposition offered by a capacitor to the flow…

Q: Nodal Analysis #1. Find i0 using nodal analysis. Το 4Ω 60 V + 10 Ω Μ 2Ω 31ο www 8 Ω Ans: i = 1.73 A

A:

Q: A star connected three phase, 10 MVA, 6.6 kV, alternator is protected by  Merz-price circulating…

A:

Q: For the following voltage and current phasors, 1) calculate the reactive power in VA. V = 140 20⁰…

A: Answer : given that (1). voltage (rms) V = 140 ∠20°       current  (rms)  I  = 15 ∠59° To find the…

Q: Use Thévenin's theorem to find V, in the network shown below. 2 ΚΩ ww 6 V (+. 4 ΚΩ www 12 V + 2 ΚΩ…

A: Answer: given that a linear circuit To find Vo in then  given circuit

Q: use convolution to find y(t) = h(t) ∗ x(t)   h(t) = u(t) − u(t − 3) x(t) = u(t) − u(t − 4)…

A: Given: Two signals as,  h(t)=u(t)-u(t-3), x(t)=u(t)-u(t-4), To find: We have to find convolution of…

Q: 51 In the circuit shown in Figure P4.61: VS1 = 15 V VS2 = 9 V R$1 = 130 Q Rs2 = 290 Q R₁ = 1.1 kQ R₂…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: QUESTION 6 Using the voltage divider rule, find Vab (with polarity) for the figure below and the…

A: In this question we need to find the voltage Vab shown in the given circuit by using voltage…

Q: 1. Demonstrate the effect of communication networks on environment and obtain the 8-bit data stream…

A: According to the question,

Q: F(s) = (s+2)/[(s+2)2 + 102] use the final value theorem to find f(0). A) f(0) = 1 B) f(0) = ∞ C)…

A: We need to find out the f(0) , for given F(s) .

Q: Ro U9 + I

A: We need to find out the value of unknown resistance and maximum power for given resistor in the the…

Q: Find the transfer function H(s) = V₁/V; of the circuit shown in Fig. 14.71. www R Figure 14.71 For…

A: In this question we need to find the transfer function of the given circuit.

Q: Problem 1 Plot the bode plot of the system described with the transfer function below G(s) = 10(s²…

A: Analysis of the magnitude and phase variations brought about by a linear time invariant system may…

Q: 3.24 In the circuit shown in Figure P3.7, assume R = 2 2 and C= 0.1 F. Also, let: 0 ---- v(t) = -00…

A:

Q: why cold? Answer it Briefly the outflow water is very (Related power generation)

A:

Q: Using Boolean algebra, simplify the following expressions

A: The given expression is,F=C+CDC+C¯DC+E.

Q: What is the maximum voltage that can be applied across the series combination of a 150-0, 2-W…

A: We have Power P=V2/R From the above equation we get V=(P×R ) where P-Power rating R-resistance…

Q: 6. Given the following circuit, findVo using Delta to Wye. 16 MA 4 ΚΩ 4 ΚΩ ww ww 2 ΚΩ Μ 6 ΚΩ 2 ΚΩ +…

A: