write the symbol for the atom that has an atomic number 9 and mass number 19 How many neutrons does this atom have?

Q: Heat Transfer    Composite plane wall: The walls of a refrigerator are typically constructed by sand...

A: Given that, A layer of insulation is sandwiched between sheet metal panels Thermal conductivity of f...

Q: 6.21 of K.V. Narayanan book for Thermodynamics

A:

Q: A boiler you make use of has coal, which is low in sulfur and nitrogen, as fuel. The coal contains 4...

A:

Q: (a) Calculate the concentratíon of CO (ppm) in the stack gas. (b) The CO in the stack gas is a pollu...

A:

Q: A conventional multiloop control scheme consisting of two PI controllers is to be used to control th...

A:

Q: Nitrogen oxide reacts with hydrogen at elevated tempera- tures according to the following chemical e...

A: (a) The expression of the rate of reaction for the given reaction is to be determined along with the...

Q: Question 7 Consider a water tube boiler that produces an average of 10,000 lb/hr of steam with 20% m...

A: Given Data Output hardness with ion-exchange method = 1 ppm Output hardness with RO process = 3 ppm ...

Q: The reactor feed (not the fresh feed from the process) contains 3 moles of ethylene per mole of oxyg...

A: The reactor exit contains ethylene oxide, carbon dioxide, water, ethylene, and oxygen. Thus, the rea...

Q: The first-order, irreversible, exothermic liquid-phase reaction A→Bis to be carried out in a jackete...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: A brine solution of salt flows at a constant rate of 8 L/min into a large tank that initially held 1...

A:

Q: A boiler you make use of has coal, which is low in sulfur and nitrogen, as fuel. The coal contains 4...

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...

Q: 4.87. A fuel gas produced by gasifying coal is to be burned with 20% excess air. The gas contains 50...

A:

Q: Calculate the percent ionization of propionic acid 1C2H5COOH2 in solutions of each of the following ...

A: The percent ionization of the propionic acid is to be calculated for the given concentration.

Q: Ibuprofen, like many APIs, is produced in a chemical reaction in a liquid phase, and subsequently cr...

A: The interpretation of the question can be written as the following sequence of processes: Chemical r...

Q: A flue gas on a wet basis contains 10% CO2, 1 % CO, 5% O2, 5% H2O and 79% N2. It is at 190oC and 750...

A: Composition of the flue gas: 10% CO2, 1% CO, 5% O2, 5% H2O, and 79% N2. Temperature of the flue gas,...

Q: What is –rA?

A: The definition of the -rA is to be mentioned.

Q: 1.) How does the purity of coconut wine obtained from distillation is being tested? 2.) A mixture co...

A: Since you have asked multiple questions, we will solve the first question for you. If you want any s...

Q: 5. For your feasibility study your adviser assigned you to a power plant that makes use of coal as i...

A:

Q: The reactor feed (not the fresh feed from the process) contains 3 moles of ethylene per mole of oxyg...

A: Given data: Single pass conversion of ethylene = 20 % Number of moles of ethylene per mole of oxygen...

Q: Transport Phenomena Question

A: given that, the diameter of pipe D1 = 3-in  the diameter of jet D2 = 1.5-in the pressure in the pipe...

Q: You place a paper clip in a cup of soda and it sinks. Which is denser? O Paperclip O Soda

A: The ratio of the mass of a substance and its volume is defined as its density. The higher the densit...

Q: A single-pass cross-flow heat exchanger with both fluids unmixed has water entering at 16C and exiti...

A: Given that, Flow rate of oil Vh = 0.19 m3/min = 0.00317 m3/s Density of oil ρ = 870 kg/ m3 Inlet tem...

Q: Coal fired in a furnace analyzes 30% VCM, 51% FC, 14% ash, 5% moisture, 1.6% N and1.2% S with a heat...

A:

Q: A mixture of neon, argon, and xenon had a total pressure of 1560 mm Hg at 298 K. The mixture was fou...

A: The partial pressure possesses by the Xenon in the given mixture is to be calculated.

Q: 22 The volume coefficient of expansion of water at 373 K is 7.8 × 10 K-. Calculate the change in ent...

A: Hello !! Thank you for asking a question It appears that there are two questions (6.22 and 6.24) The...

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A:

Q: 238Pu, which decays by the emission of an alpha-particle, has been used as athermal power source.(a)...

A:

Q: Water is to be heated by solar heated hot air (Cp= 1010 J/kg.°C) in a double pipe counter flow heat ...

A: Given:   Double pipe counter flows heat exchanger. Overall heat transfer coefficient for the inner s...

Q: 6.34 Calculate the fugacity of nitrogen at 800 bar from the following data at 273 K. P, bar 50 100 2...

A: Given P, bar 50 100 200 400 800 100 Z=PV/RT 0.9846 0.9846 1.0365 1.2557 ...

Q: In a batch reactor, sulfur dioxide is oxidized to sulfur trioxide by oxygen at 207 oC. The feed gase...

A:

Q: Ans 97.34 % vapour

A:

Q: “A liquid is heated at constant pressure in a smooth container to a temperature above its boiling po...

A:

Q: Solid gypsum, CaSO42H2O, is formed in a crystallizer and leaves the unit as particles suspended in a...

A: Basis: 2-liter Slurry Solid gypsum = 0.35 kg CaSO42H2OL slurry The density of gypsum = 2.32 gmL The ...

Q: Decomposition of sulfuryl chloride The reaction shown below is first order with regards to SO2Cl2 ...

A: The given reaction is:   SO2Cl2 → SO2 + Cl2   The reaction id first order with respect to SO2Cl2. At...

Q: 5D. Compute the pressure required to reduce the volume of 1.00 cm of Cu at 1.00 atm by 0.2%. For Cu:...

A: Given data: Volume of copper at 1 atm = 1 cm3 Density of copper = 8.96 g/cm3 Value of isothermal com...

Q: 100 kg of a waste stream containing 10 wt% suspended solids is separated in a vacuum filter to produ...

A:

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A: Given that, Weight % of carbon in sludge = 40% = 0.4 Weight % of sulphur in sludge = 32% = 0.32 Weig...

Q: A liquid mixture containing 10 mol% heptane and 90 mol% ethylbenzene is fed at its boiling point to ...

A: mol% of heptane in liquid mixture xL = 10% = 0.1 mol% of ethylbenzene in liquid mixture = 90% = 0.9 ...

Q: Temperature is sometimes measured with a gas thermometer by observing the change in the volume of th...

A:

Q: For the hydrogenation of benzene to cyclohexane at 500K and 30 atm in the liquid-vapor phase. Assumi...

A:

Q: How can engineers contribute to mitigating the problem of water pollution?

A: Water is essential ingredient in daily life. The water is only solvent which is used widely in the c...

Q: A converter gas contains 10 kmol SO3. If this converter gas is allowed to pass through an absorber u...

A: Given The above step is a part of Contact Process for manufacturing H2SO4 SO3 consumed= 10 Kmol Abso...

Q: 1 kg CO2 is heated through a constant pressure reversible process. It starts at 300K and 1bar and st...

A: Given information:   1 kg CO2 is heated at constant pressure in a reversible process. Pressure, P = ...

Q: Heat Transfer    Radiation: Under conditions a room’s temperature is maintained by a heating or cool...

A: Given data: Temperature of air inside a room = 20 0C Temperature of room (summer) = 27 0C Temperatur...

Units and Dimensions

Dimensions are the basic concepts of the measurement of quantities. Units are the means of expressing the dimensions. For instance, an area has a dimension of L2 and a unit of m2.