WT 8 x 50

Q: Estimate the moisture content of a solid waste sample with the following composition: Component Food…

A:

Q: For a given sand, the maximum and minimum void ratios are 0.70 and 0.35, respectively. Given G₁ =…

A: emax = 0.7  emin = 0.35 Gs = 2.75  ID = 59%  Assume unit weight of water (yw) = 9.81 KN/m3

Q: In the Figure 6, the reaction force in the x- direction at point B is (in kN): Figure 6: 5 m, 5 m A…

A:

Q: The 50kg pendulum has a center of mass at G and a radius of gyration about G of kG=250mm. A)…

A: It is given that :

Q: when excavating，(Support preload) Different retaining walls, support axial force, subsidence What…

A: Concept- Excavation- It is a process in the construction work. In this process earth materials,…

Q: The percentage loss of prestress due to anchorage slip of 3 mm in a concrete beam of length 30 m…

A:

Q: 7. Why do we need specialized remediation or clean-up technologies? What is the difference between…

A: Questions: (1) Why do we need remediation or clean up technologies? (2) What is the difference…

Q: What was the first law written to clean-up abandoned hazardous waste sites? When was it enacted? How…

A: The Resource Conservation and Recovery Act (RCRA) empowers the Environmental Protection Agency (EPA)…

Q: What are the characteristics should soil have to pavement

A: chracterstics should soil  have to pavement applications-1.The dirt subgrade ought to stay stable in…

Q: A 6 m simply supported beam has a roller support at the left side and a hinged support at the right…

A:

Q: Given for a soil stratum: Coefficient of permeability in horizontal direction = 3 m/day Coefficient…

A: given Coefficient of permeabiity in horizontal direction-kh=3 m/dayandCoefficient of permeabiity in…

Q: A ball with mass m kg is thrown upward with initial velocity 15 m/s from the roof of a building 19 m…

A:

Q: Member B is subjected to a compressive force of 600 lb. If A and B are both made of wood and are 1.5…

A:

Q: draw concrete reinforced column with specifications and dimension

A:

Q: 1 ton of fuel was completely burned. Calculate the amount of combustion gases produced. Note that…

A:

Q: Determine the external reactions at A and F for the roof truss loaded as shown. The vertical loads…

A: Determine external reaction for support at A and F

Q: If the overhanging beam has the flexural modulus, EI = 17(10³) N-m², determine the displacement at…

A: Given :

Q: What is the shear stress in a steel W14X257 beam that spans 40ft with a uniform load of 3k/f?

A:

Q: Find reaction forces and all the force members with the corresponding types of force for the give…

A:

Q: If M₂= = 210 kip-ft, find the magnitude of the bending stress at a point H. For the beam cross…

A:

Q: 1.17 A plate load test was conducted in sand on a 300 mm diameter plate. If the plate settlement was…

A:

Q: pported by this beam if the allowable WO IIIT x B 를 -를- LC kN/m

A:

Q: The control lever is subjected to a clockwise couple of 115 N-m exerted by its shaft at A and is…

A:

Q: of 0.88 is fitted at the bottom of the upper tank, determine- (1) the time required to drain all…

A: solution-  (1)  S0 =150=i          c =50        V¯=CML°  A= 50×15 A = 750 mm2     A = 50+2×15    P…

Q: Find reaction forces and all the force members with the corresponding types of force for the give…

A:

Q: A 2 m wide strip footing 20 kN/m³ and having , = is located at a depth of 2 m in a stiff clay of…

A:

Q: 259 664. The middle half of the beam shown in Fig. P-664 has a moment of inertia twice that of the…

A:

Q: Draw a free-body diagram of the rigid members of the system shown in the Figure. 20 kN/m 4m 6m 80…

A:

Q: In the Figure 5, the normal stress on the cross- sectional area is (in Mpa): Figure 5: P = 400 KN…

A: Normal stress can be defined as the axial load per unit area of cross section and shear stress is…

Q: After applying the dead load P on the rectangular beam with b=300mm, d=500mm, and h=700mm, the…

A: Answer We are given width b = 300 mm effective depth d = 500 mm Total height h= 700 mm short term…

Q: Q1/ Member B is subjected to a compressive force of 10 kips. If A and B are both 0.5 in. thick and…

A:

Q: A cana be 2-hour unit hydrograph as trapezoidal as approximated shown in figure. The unit hydrograph…

A:

Q: 17. A stone is dropped from a cliff and 2 sec later another stone is thrown down with a speed of 22…

A:

Q: Q.1\ A column of a cross-section (350x450)mm is reinforced with 4 bars of (25mm) in diam., knowing…

A:

Q: 1- Consider the unit cube shown in the Figure, which undergoes the deformation: 1 x₁ = α (X₁- X₂),…

A: Given : x1 = αX1 - 12X2x2 = βX2x3 = γX3…

Q: Problem 6: For the beam and loading shown below, derive an expression for the reaction force at B.…

A: Given :

Q: A column footing of 1.8 mx 1.8 m is to be placed 1.5 m below ground level in a dry cohesionless…

A:

Q: Four forces are exerted on the eyebolt as shown. If the net effect on the bolt is a direct pull of…

A: Determine the value of T and angle theta?

Q: 3. A man slowly pushes on a 50-kg rectangular crate with a pushing force P of angle 30° downward.…

A:

Q: What is the shear stress in a steel W14X257 beam that spans 40ft with a uniform load of 3k/f? W14…

A: Given data:- W14 Section properties:- Size=257 lbf/ft Area A=75.6 mm2 Depth d=16.4 in The breadth of…

Q: The force F is directed from A toward D and D is allowed to move from B to C as measured by the…

A: Given that :

Q: Explain Groundwater Wells in hydraulics (diagrams and formulas may be used)

A: Ground water wells- At the point when a well is siphoned, water streams into the well from the…

Q: Learning Goal: To understand the concept of moment of a force and how. to calculate it using a…

A:

Q: Velocity distribution function for flow over a channel is represented by u = 0.6z - z² where u is…

A: given velocity distribution functionu=0.6z-z2dynamic viscosity μ=0.8 Ns/m2shear stress at distance…

Q: 4= The state of strains at a point are defined as follows. Find the magnitude of largest normal…

A:

Q: A sphere of radius 0.25 m and a weight of 108 N is released with no initial velocity on the incline…

A:

Q: A cantilever beam carries the force and couple shown in Fig. P-552. Determine the ff. -Total Area of…

A:

Q: Problem A truss is subjected to the following forces as shown. Determine: (a.) The magnitude of the…

A: AH is the horizontal reaction at joint A AV is the vertical Reaction at joint A BV is the vertical…

Q: 18. An elevator with a mass of 1500 kg descends with an acceleration of 2.85 m/s². What is the…

A:

Q: Find reaction forces and all the force members with the corresponding types of force for the give…

A: