XA, Xg, Xc at p' is .......... ............. .......... XA, Xg, Xc at p" is ........... ............ ............

Q: PROBLEM 1. Compute the capillary effect of immersion in mercury of a glass tube of 6mm internal diam...

A: Given data: Internal diameter of tube = 6 mm Surface tension = 0.51 N/m Specific gravity = 13.55 Ang...

Q: Q1// The elementary gas phase reaction A + 2B → constant temperature (500 K) and constant pressure (...

A: Write the reaction as follows: A + 2B → C   Given, The initial concentrations of A and B are equal, ...

Q: Any device that performs signal conversion is Modulator explain?

A: Modulation is a phenomena in which a signal is sent through a bandpass range of frequencies. It is p...

Q: 4. Oil of specific gravity 0.853 is flowing through a pipe with a constriction. A manometer with tap...

A:

Q: Example 4.3:We wish to strip SO2 from water using air at 20°C. The inlet air is pure. The outlet wat...

A: Given: Operation is at 855 mmHg Ls/Gs=0.9(Ls/Gs)max HOL is 2.76 ft Henry's law constant is 22500 mm...

Q: 1. Steam with an enthalpy of 2168 kJ/kg enters a condenser at a rate of 10,000 kg/hr. If the condens...

A:

Q: Q4) A) What is the difference between R and Ru and how these two are related. B) What is the differe...

A: The gas constant is dependent on the pressure, volume, temperatures, and moles of the gas. This acts...

Q: Problem 1: Reynold's number a rotating brush uses a device similar to the device shown in HD Figure ...

A:

Q: Example 4.7: What is the maximum temperature that can be reached by the combustion of methane with 2...

A:

Q: .2. That division of metallurgy applying to the extracting, refining, and primary shaping of metals ...

A: Metallurgy is the science and technology related to production and purification of metals and alloys...

Q: Q1/A catalytic dehydrogenation process shown below produces 1,2-butadiene (C,H) from re normal butan...

A:

Q: Derive the Integrated Rate Law eq for the 2nd Order reaction of A→B The resulting equation shall be...

A:

Q: Which of the three radioactive emissions (a, ß, y ) best fit the following statements? Write the cor...

A: Solution: We are given the following radiation particles alfa, beta, and gamma. We need to fill the ...

Q: he following graph shows the pH curve for the titration of 25 mL of a 0.1 M monoprotic acid solution...

A:

Q: Methane diffuses at steady state through a tube containing helium. At point 1, the  partial pressure...

A: Equimolar counter diffusion is the flux of one component is equal to the negative of the flux of ano...

Q: A horizontal shell and tube heat exchanger (HE) with 2 passes is used to heat the air via hot oil.Ai...

A: Given t1=18 °C         m1=2 kgs T1=190 °C   m2=1.5 kgs N=30 tubes         D=1.5 cm      L=10m Cp1=1....

Q: The pressure in a chemical reactor is measured by an electronic sensor/transmitter with an output ra...

A: A set of devices that are mechanical or electronic used to regulate a process variable to its desire...

Q: Q5: A cylinder piston contains 100/ air at 110 kPa. The air is then compressed in a reversible polyt...

A:

Q: : Explain and draw Points Defects of crystalline engineering materials.

A: There are basically 4 different types of defect in a crystal. Point defect  Line defect Surface defe...

Q: The specific gravity of gasoline is approximately 0.70. (a) Estimate the mass (kg) of 50.0 liters of...

A:

Q: Explain the selection of engineering materials for applications depend on which properties. Why the ...

A: 1.Selection of Engineering materials depends on the following parameters: Mechanical loads Wear Ele...

Q: Aromatic, anti aromatic, or non aromatic

A: Compound name is toluene

Q: A material is crushed in a Blake Jaw Crusher and the average size of particles reduced from 50 mm to...

A:

Q: 3. Determine the molecular mass and identity of a +2 metal, X, that plates 46.3g of X in 6.75 hours ...

A: Given: Plating mass of X is 46.3 g in 6.75 hours at a current of 2 A 1 Ampere is equal to 1 Coulombs...

Q: (b) Fig. Q2(b) shows the isothermal transformation diagram for hypo-eutectoid steel. Sketch and labe...

A:

Q: A centrifugal pump was tested for cavitation initiation. Total head was 40 m and flow rate were 0.06...

A:

Q: Butane (C,H10) is bumed with air (21 mole% Oz, 79% N2) in a continuous steady-state process, and wat...

A:

Q: write uints and correct number of significant figures 2. Answer the following question using the tab...

A: -rA=0.0036=K (0.12)n1(0.030)n2.......................1 -rA=0.0072=K (0.24)n1(0.030)n2..................

Q: Using a centrifugal pump, process fluid is pumped from the bottom of one distillation column to anot...

A:

Q: Liquid A decomposes by first-order kinetics, and in a batch reactor 50% of A is converted in a 30-mi...

A: GIVEN: first order kinetics for a reaction  Time=30 min half life equation for first order reaction:...

Q: 630 g of water (Cp = 4.186 J/g-K) is heated to 49 ⁰C at constant pressure. The resulting change in e...

A:

Q: The density of a mahogany wood is said to be 497 - 849 kg/m3, compute the values to g/mL and g/cm3. ...

A: Density is the ratio of mass and volume. Mass can be expressed in grams or kilograms. Volume can be ...

Q: 1.) Air undergoes an Isentropic process where it expands. It is initially at 900K then the temperatu...

A:

Q: Two well-known gas phase reactions take place in the dehydration of ethane: CH, - C2H + H2 C2H6 + H2...

A:

Q: The feed to a reactors contains 100kmol C,H4 and 100kmol 02. a) which is limiting reactant? C2H4 b) ...

A: Given that, 2C2H4 + O2 → 2C2H4O The number of moles of C2H4 in the feed nC2H4,F = 100 kmol The numbe...

Q: For counter-current absorption in a packed column, it was found that the liquid and the gas flowrate...

A:

Q: 3. The way in which the elements of an alloy or the atoms of one element are arranged a. Metallurgy ...

A: lets choose the correct option according to their definitions, (a) Metallurgy is a subject that stud...

Q: 2. A chromium metal was deposited coming from a solution of Cr*3. The amount of the said metal depos...

A:

Q: Match the definition to that of the main word in specific context. Prompts Submitted Answers Process...

A:

Q: b) Given 3 dx, V1+ x? approximate the integral using trapezoidal rule with h = 0.25.

A:

Q: Methyl alcohol (CH3OH) burns with 200% theoretical air, yielding CO2, H2O, O2, and N2. Determine the...

A: Given Combustion of Methyl alcohol (CH3OH)  with 200% theoretical air, To determine Balanced chemica...

Q: How many grams of antifreeze would have to be added to 15 kg of water in the trucks cooling system t...

A: Given Details: Freezing point of pure water = 0°C Freezing point of solution = -20°C Mass of water =...

Q: C: Copper has an atomic radius of 0.128 nm, an FCC crystal structure, and an atomic weight of 63.5 g...

A: Given data  r= 0.128 nm FCC crystal structre M= 63.5 g/mol

Q: A process has a distillation column, where a crude dichlorobenzene is pumped from a storage tank. Ni...

A: Given P1=Pressure in storage tank(Dichlorobenzene)=0.1barg P2= Pressure in distillation column=500m...

Q: Please calculate the energy density of 1.0 kg of H2 (the energy from the combustion of per kilogram ...

A: Given Hydrogen at temperature of 300K and pressure of 10 atm. To calculate energy density of 1.0 kg ...

Q: 10 kg of oxygen contained in a closed container of volume 2m3 is heated without exceeding a pressure...

A:

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The evap...

A:

Q: Q2/ A counter-flow double-pipe heat exchanger is to heat water from 20 °C to 80 °C at a rate of 1.2 ...

A: Given: For cold fluid (water): Tc1 = 20oCTc2 = 80oCmc = 1.2 kg/sCpc = 4.18 kJ/kg.oC For hot fluid (g...

Q: 3/A) For the following control system below, is it under damping ? if yes, termine the (Mp, tr, tp, ...

A: Find out the transfer function (C(s)/R(s)) for the given control diagram as follows: C(s)R(s)=Produc...

Q: Consider the hypothetical reaction A +B+ 2C → 2D + 3E where the rate law is Rate = - At A[A] k[A][B]...

A: Problem deals with pseudo order rate law. We have to take a large excess of B in solution. When whol...