X(s) g(s) သုံးဘူးကြသေး G,(s) G-(s) G5(s) G(s) G(s) > Y(s)

Q: 4-21 Carbon dioxide contained in a piston-cylinder device is compressed from 0.3 to 0.1 m³. During…

A: Given  Pressure volume relation  P = a V-2 a = 8 kpa m6 Initial volume V1 = 0.3 m3 Final volume V2 =…

Q: What do you mean by volumetric flow rate?

A: Given Data  We need to define the volumetric flow rate

Q: Consider the reaction: 2CO(g) + O₂(g) - 200₂(9) Given an initial mass of 18.29 g CO, an excess of…

A: Given  Initial mass of CO = 10.29 g Molecular weight of CO = 28 g/mol Mole of CO = 10.29/28…

Q: on control, with no datum features, can be applied to two or more

A:

Q: s a chemical engineering student, you are asked to investigate the efficiency of a Rankine Power…

A:

Q: A continuous single-effect evaporator concentrates 9072 kg/h of a 1.0 wt% salt solution entering at…

A: Introduction:- The heat exchanger for boiling the solution and the specific features for separating…

Q: Nitrogen from a gaseous phase is to be diffused into pure iron at 700°C. If the surface…

A:

Q: Butadiene reacts to form its dimer according to the equation 2C,H.(g) C&H₁2(8) The following data…

A: (a) It is to be mentioned whether reaction is of order one or two.

Q: 5. Find the dryness fraction, specific volume and internal energy of steam at 7 bar and enthalpy…

A: Given, Steam pressure = 7 bar Enthalpy = 2600 kJ/kg

Q: Calculate vapor pressure of benzene at 26°C using Clausius-Clapeyron Equation. The normal boiling…

A: Given that- Temperature of benzene, T1=260C= 299 K Normal boiling point of benzene, Ta=80.10C= 353.1…

Q: 1. In a process for the manufacture of chlorine by direct oxidation of HCI with air over a catalyst…

A:

Q: In a process for the manufacture of chlorine by direct oxidation of HCl with air over a catalyst to…

A: Basis: 100 moles of product stream The number of moles of components in the product stream nHCl,P =…

Q: A first order reaction is carry out in certain reactor with initial concentratio 2 mol/ m3 If final…

A: Given  Initial concentration CAo = 2 mol/ m3 Final concentration CA =1 Rate constant K = 2 sec-1

Q: 2.A rigid tank of volume 0.5 m³ is connected to a piston-cylinder assembly by a valve as shown…

A: A piston-cylinder assembly is given.

Q: e 4.10 eV and 2.29 × 10-³

A:

Q: Consider the following reaction equation: CH4 (g) + 202 (g) 2H₂0 (g) + CO₂ (g)

A:

Q: At 25 °C, the EMF of the cell Pt, H₂(1 atm) / H* (Unknown) // KCl (satd) / Hg₂Cl₂ (s),Hg is 0.445…

A:

Q: 3. An evaporator is used to concentrate cane sugar solutions. A feed of 10000 kg/day of a solution…

A:

Q: Consider the following ternary diagram. The diagram is drawn to scale and the lengths are measured…

A: A triangular diagram is given.

Q: Heat is conducted through a tapered circular rod of 200 mm length. The ends A and B having diameters…

A: For a detailed solution, please see the attached files.

Q: Glutamic acid (CƑH₂OÂN) is used as one of the reagents for a standard to check the BOD test.…

A: Given that63  mgL  of glutamic acid there is reaction given C5H9O4N  +4.5O2   ⇔5 CO2   +3H2O +NH3NH3…

Q: Calculate AS (unit :JK-1) for the molar transformation H₂O(s, 0°C) decimal places, for example: 15.2…

A:

Q: 100mole mixture of benzene and toluene with 45 percent benzene feed to distillation column after…

A: Given  Feed F =100 mole  Benzene Composition in feed XF = 0.45 Composition of top product Xd = 90%…

Q: Heat dissipated from an engine in operation can cause hot spots on its surface. If the outer surface…

A: Given that :L1 = 1 cm = 0.01 mK1 = 14 wm k L2 = 5 mm =0.005 m K2 = 0.5  wm k T1  =350 Ch1  = 5 wm2 k…

Q: What would the AStotal be in counter-current? J mol* K if the two streams entered co-currently…

A:

Q: 2Zn(s) + O2(g) → 2ZnO(s) + 701kJ 1. Solve for the standard enthalpy of formation of ZnO(s) at 298K?…

A: Write the reaction as follows: 2Zns + O2g → 2ZnOs Two moles of Zn reacts with 1 mole of  O2 and…

Q: Calculate the apparent M.wt, then Convert From Volum fraction to wieght fraction. Component Methan…

A:

Q: Calculate the energy associated with a radiation having wavelength 3000 A. Give the answer in kcal…

A:

Q: Calculate the molar Entropy change AS in the of oxygen gas when its pressure is increased…

A:

Q: Find the heat flow rate through the composite wall as shown: The thermal conductivities are:

A:

Q: Using the isothermal transformation diagram for an iron-carbon alloy of eutectoid composition…

A: 100% bainite is formed when the specimen is cooled rapidly to 350°C from 760°C and held for 10's and…

Q: The following reaction occurs in a system initially consisting of 2 mol CH4, 1 mol H2O,  1 mol CO,…

A:

Q: 5.12. The tank in Fig. 5.20 is full of helium, of molecular weight 4 g/mol, at the same temperature…

A: It is given that tank is full of helium. Given data are as follows: Molecular weight of helium is 4…

Q: A binary mixture of mole fraction z1 is flashed to conditions T and P. For the following, determine…

A: A mixture of acetone and acetonitrile is flashed vaporized.

Q: One kilogram of water at 25°C and 1 bar is compressed isothermally to 1,500 bar. Bis 250 * 10-6K-1…

A:

Q: 2. Hydrogen produced by steam-methane reforming exits at a pressure of 1.6 MPa and a temperature of…

A:

Q: Using the stoichiometric coefficients from the equation, create three ratios that can be established…

A:

Q: 100mole mixture of benzene and toluene with 45 percent benzene feed to distillation column after…

A: A mixture of benzene and toluene is separated into distillate and bottom product.

Q: Complete the following tables for water. (v is specific volume and u is specific internal energy) P…

A: The given property tables of water to be completed.

Q: 1. If a parcel of air at 15 °C has a specific humidity of 4.6 g/kg, what is the relative humidity of…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: A chemical engineering student was given an information that the vapor pressure of n-butane at…

A: Given data: Temperature = 170.33 0F Vapor pressure of n-butane = 3796.76 in H2O

Q: Problem 1 An aqueous solution of methanol containing 20% by weight methanol is fed to a distillation…

A:

Q: When a liquid mixture is boiled, the vapor that leaves the vessel is enriched in the more volatile…

A: -Test the linear and polynomials models to verify the experimental data: Let us consider the given…

Q: A gas mixture consisting of 80% ethane and 20% oxygen is burned in an engine with 200% excess air.…

A:

Q: The transfer function of a process is esponse will be 1) underdamped 16s²+8s +4 (b) critically…

A: Given  Transfer function  1/(16s2 + 8s+4)

Q: when we are taking our deltas why are we doing intial-final instead of final-initial

A: We need to explain why the difference in enthalpy (hi - hf) is denoted as ∆h in the energy…

Q: Liquid mercury has a molar volume of 0.01465 dm3 mol-1 and solid mercury a molar volume of 0.01413…

A: Given data: Molar volume of liquid mercury = 0.01465 dm3/mol Molar volume of solids mercury =…

Q: On burning 0.83 g of a solid fuel in a bomb calorimeter, the temperature of 3500 g of water…

A:

Q: (a) The mass of a water molecule is 2.9915 x 10-23 g. How many water molecules are there in a 212.5…

A:

Q: Green chemistry is an area of chemistry and chemical engineering focused on the designs of products…

A: The fiveconcepts related to the practice of green chemistry are discuss below. Using alternative…