x(t)= C0 + C1*cos(w*t+phi1) + C2*cos(2*w*t+phi2) x(t)= A0 + A1*cos(w*t) + B1*sin(w*t) + A2*cos(2*w*t) + B2*sin(2*w*t) C0= 6, C1=6.325, phi1=-18.435 deg, C2=6.083, phi2=-9.462 deg, w=400 rad/sec. Determine A0, A1, B1, A2, B2

Q: The voltage across 20 Resistor where v= 10volts is 20 W O a. 4V O b. 10V О с. 3V O d. 2V in W m 20 V

A:

Q: State and explain Carson's Bandwidth Frmula. Need urgently help.

A: Carson's bandwidth method is used in telecommunication systems to calculate the bandwidth utilized…

Q: Q.65 (i) How many 128x8 RAM chips are required to provide a memory capacity of 2048 bytes. (ii) How…

A: Solution !!

Q: Vs VA R₁ 1₁ R3 Vc VB R₂ 2 = 100 (2, R3 = 50 (2, R4 = 90 02, and Vs = 10 V. 01 Substitute the values…

A: This question belongs to circuit theory . It is based on the concept of mesh analysis in the circuit…

Q: How long does it take a 100 W bulb to consume 13 KJ of energy? [c]

A: Given data, Power rating of bulb P = 100 W Energy of consumed E=13 KJ

Q: Calculate the maximum frequency deviation for the FM signal v(t) = 10 cos (6000t+ 5sin2200t) a. 2200…

A:

Q: The contribution of current source /2 is now calculated by making /₁ open circuit. R₁ = 3.8 Q, R2 =…

A:

Q: A numeric system (e.g. a numeric keypad) generates numbers 0 to 9 in binary. You are asked to design…

A: To approach for the given problem first assume some inputs to the above numeric system.Since result…

Q: easure the DC voltage across resistor R2 might lead to inaccurate sults. Include in your answer how…

A:

Q: What are the main limiting factors to battery improvements? Why is the infrastructure for battery…

A: Introduction: The main limiting factors to battery improvements. the infrastructure for battery…

Q: the standing wave ratio.

A: Given: lossless transmission line having  Za=50Ωlength=4.334mkr=0.4∠45°λ=2m if Vs='100V find 1)The…

Q: Draw diagrams to show how to connect a Digital Multimeter (DMM) for the following situations: (1) to…

A:

Q: 6) Carson's rule is used to calculate a. Bandwidth of FM signal b. Signal to noise ratio c.…

A: The solution is provided in the following section.

Q: controller and the plant in open- and closed-loop systems

A: Controller: A controller is a device used in control systems that works to reduce the discrepancy…

Q: A four-pole, 50Hz induction motor has a full- load slip of 5 percent. The rotor speed of this motor…

A: Given,For a induction motor,Pole, P=4Frequency, f=50 HzFull load slip, S=5%

Q: What is the maximum modulating frequency allowed in commercial FM broadcastings? a. 40 KHz b. 75 KHz…

A: Frequency modulation: Frequency modulation is a process of changing the frequency of the carrier…

Q: Having found a value for /2, calculate V using Ohm's law. VA VB Vs R₁ I R3 [² R₂ 1₂ RA

A: We need to find out the value of  V

Q: What is the equivalent resistance in kOhm if three resistors of 4.3 kOhm, 1.4 kOhm, and 2.2 kOhm are…

A: Given data, Resistances are given, R1=4.3 kΩ, R2=1.4 kΩ, R3=2.2 kΩ

Q: Can you explain to me the properties of Laplace transform by solving a diffrental equations as I…

A: The Laplace transform changes the frequency domain into the time domain. When working with…

Q: (TCO 6) Determine the resonance frequency of the tank circuit shown in the figure. The individual…

A: The resonance frequency of the LC tank circuit is given by the expression as shown below:…

Q: A 500: 10, current transformer is used and an ammeter is connected in secondary. If ammeter reading…

A: Current Transformer In high voltage Ac system, we can not use ordinary instruments ( low rating…

Q: 1. For the network of Fig., determine: (a) S(co) {b) S(Var) (c) S(B) Using T, as the temperature at…

A: Solution !!

Q: 2-2m. If Vs = 100 volts, find: (use crack diagram) A lossless transmission line having Z-5002,…

A: Given: Z0=50 ΩVS=100 VKr=0.4<45λ=2 Find: 1. Standing wave ratio 2.Voltage standing pattern

Q: 6. For the follow logic circuit system, the output f is: [ (A) ab. (B) a + b. (C) a'+b'. (D) a'b' a…

A: Given, The logic circuit is,

Q: determine the transfer function Vo(S) Is (S)

A: Given- In series- Resistance, R Capacitance, C Inductance, L To find- Transfer function, V0sI0s=?

Q: image483

A: a) The capacitance of the capacitor with the dielectric is calculated as shown below:…

Q: The reactance of the Impedance Z=1 O 100 Ohms 48.48 Ohms 87.46 Ohms 1.64 Ohms

A:

Q: The total current in the following circuit is 15 volt 20 A 1.875 A 2.5 A 15 A R₂=3 Figure (2) R₂=52

A: Given circuit:

Q: a) Find the spectrum of x(t) = e²t u(1-t) b) Find the inverse Fourier transform of X (w) = j

A:

Q: 763. (NEW) This is about two points, (x1,y1) and (x2,y2), on a straight line whose slope is given in…

A:

Q: needed in order to successfully capture frequencies up to 80MHz in an analog

A:

Q: Simplify the following expression into sum of products using Karnaugh map…

A: It is given that: FA,B,C,D=∑1,3,4,5,6,7,9,12,13

Q: P4-2. A coil that is wound with 100 turns of wire draws 2.2 A when connected to a 12.5 VDC source.…

A: Given data, Number of turns N = 100 Current drawn i = 2.2 A Supply voltage V = 12.5 V Coli…

Q: Calculate the maximum frequency deviation for the FM signal v(t) = 10 cos (6000t+ 5sin2200t)

A: Given information: The expression of the FM signal is vt=10cos6000t+5sin2200t The maximum frequency…

Q: open- and closed-loop

A: Given:  Open- and closed-loop control system. To find: Compare and contrast open- and closed-loop…

Q: What is the maximum modulating frequency allowed in commercial FM broadcastings? a. 40 KHz b. 75 KHz…

A: The correct option along with the explanation has been provided in the following section.

Q: Q.) The circuit shown below is an idealized forward converter. Assuming an input voltage Va=40V,…

A: By utilizing a transformer, the forward converter is a DC to DC converter raises or decreases the…

Q: 3. A Pure Inductance of 3mh Carries A Current Of The Waveform Shown in Fig. Sketch The Waveform Of V…

A:

Q: The initial cost of an equipment is Rs.  5,00,000 and its salvage value is Rs.  20,000 is.  Its…

A:

Q: Find the boolean expression for the logic circuit shown below.

A: The given logic circuit is shown below:

Q: 02. A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60…

A: Given: 3 phase full wave uncontrolled bridge rectifier AC input voltage, Vin=90V Frequency, f=60Hz…

Q: why would you want to use a non-synchronous buck converter over a synchronous buck converter

A:

Q: 7.27. A linear time-invariant discrete-time system has transfer function 3z H(z) = (z+0.5) (z - 0.5)…

A: Given, Hz=3zz+0.5z-0.5x(n)=u(n) For initial conditions y(-1) and y(-2), the output response is…

Q: 2. (a) Determine the current in the circuit below. Hint view video on multip (b) Determine the…

A: Given circuit,

Q: If an 8-bit binary number is used to represent an analog value in the range from 200 ounces to 700…

A: Step 1-->We have, analog range 200 ounces to 700 ounces Binary number(n)=8

Q: SW1 SW2- L1 A 1₁ B 2 LEDS L2 D 1 3 4 5 2 C L3 What logic function is being performed? LED

A:

Q: 6) Carson's rule is used to calculate a. Bandwidth of FM signal b. Signal to noise ratio c.…

A: The correct option along with the explanation has been provided in the following section.

Q: 2. What is the voltage across the resistor R2 below (VR2)? 5A ↑40 3A ↑ R2=30 VR2

A: Given data, Given circuit diagram is,

Q: Next the multimeter will be used to measure the voltage VOUT_B for the second potential divider. The…

A: We need to find out output voltage for given circuit.

Q: A transformer connected to a120 V (rms) ac line is to supply 12.0 V (rms) to a portable electronic…

A: Given: Primary side voltage, V1=120V Secondary side voltage, V2=12V Load resistance, RL=5Ω

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.