You are a structural Engineer who works in Dar Al Handasah company. Your direct manager has called for a meeting and provided you with the below schematic design of a concrete beam that might be implemented at one of the sites. You were requested to calculate the following: (make 15 KN bold) 40 KN 15 KN 20 45° KN 30 KN 40 KN m 16 20 Figure 1: Concrete Beam 1. Find the equivalent forces of the disturbed loads. 2. Sketch the beam showing all the applied forces (reaction and equivalent forces) and their suitable locations. 3. Apply the moment equations in the equilibrium state to find the value of the reaction forces at points A and B.

You are a structural Engineer who works in Dar Al Handasah company. Your direct manager has called for a meeting and provided you with the below schematic design of a concrete beam that might be implemented at one of the sites. You were requested to calculate the following: (make 15 KN bold) 40 KN 15 KN 20 45° KN 30 KN 40 KN m 16 20 Figure 1: Concrete Beam 1. Find the equivalent forces of the disturbed loads. 2. Sketch the beam showing all the applied forces (reaction and equivalent forces) and their suitable locations. 3. Apply the moment equations in the equilibrium state to find the value of the reaction forces at points A and B.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Show how you would retain a screw on Orcad cadence?
What is Direct Shear Test?
What is Vane Shear Test ? explain where it can be used ?
a= 3.4m b= 43 kN/m c= 24.2 kN Show complete solution. Draw the diagram. NEED ASAP. THANK YOU.
What is the amount of loadthat applied to the center ofthe rectangular concrete beamsample if the Modulus ofRupture is 3.50MPa?Length of the sample = 550mmDimension: 150mm x150mm
HYDRAULICS PROVIDE COMPLETE SOLUTION WITH FIGURE IF POSSIBLE THANKS!
Explain local shear failure and General shear failure ?
Answer the ff about staad pro. a). Can we still analyze and design a structure if we did not use reference loads? explain why b). Why is there no earthquake load in the y direction of staad? c). What does it mean if there is a question mark attached to an item in staad? d).What is the difference between error, warning and notes in staad? e). What type of structural member will you place to act as a shearwall f).How can we specify different floor load values on different portions of a slab.
What is field load test?
How Linearly Increasing Vertical Loading ?
Define Transient loads
Define the local shear failure ?