You are asked to design an active high pass filter with cutoff frequency 69 Hz. Given a capacitor of 18 nF, specify the value of the R1 resistor of the high pass filter below. Please enter your answer to the nearest whole number.

Q: or the circuit shown below calculate I, Iı and Iz. 33 Ω 10Ω W 109, 30V Σ47Ω 33 Ω 47 Ω

A:

Q: The frequency-division multiplexing system shown below combines two messages for transmission across…

A:

Q: Q2. A carrier signal ve(t) = E, cos(wet) is modulated by a single tone signal Vm (t) = Em cos(wmt)…

A: Given Data: An Amplitude Modulation system with, Carrier signal vct=Eccosωct Modulating signal…

Q: Consider the following bode plot representing a filter with a constant term greater than 1, tw…

A: Given Data: A Bode plot of a transfer function having, Two zeros One pole at  50 rad/s and A…

Q: the following bode plot. What is the corresponding transfer function? Magnitude (dB) Phase (deg) 0 0…

A:

Q: For the circuit attached, a. Use a series of source transformations to find i0 b. Verify your…

A: The value of unknown current io needs to be calculated by using the source transformation and the…

Q: A discrete-time signal x[n] has a period of N > 2. Which of the following is not always true? none…

A: The above question is based on the properties of discrete-time Fourier series (DTFS)

Q: For the control diagram in the figure below. Design the circuit for the control diagram using ideal…

A: Servomechanism, often known as a servo, is a feedback control system with physical position or…

Q: Use the node-voltage method to find all the branch currents ia through le in the circuit shown…

A:

Q: The Fourier transform of a continuous-time signal ä(t) is denoted by X(w). Apply CTFT properties to…

A: In this question we need to find the following  time domain expression of signal Fourier transform…

Q: If a particular parabolic reflector has a gain of 30dBi, what is its new gain with respect to the…

A: The old gain of a parabolic reflector is Gold=30 dBi. We need to determine the new gain of the…

Q: The complex number Z=0 - 3i will be located

A:

Q: numbers. Perform the following computations on the given unsigned binary a) 101010101101 b)…

A:

Q: A feedback amplifier employing series-series feedback is shown in the figure below, where the…

A:

Q: For the continuous-time periodic signal: æ(t) = 2 + cos(t) + 4sin(t), determine the fundamental…

A: For a continuous period signal is  Given x(t)=2+cos(2π/3*t) +4sin(5π/3*t ) We need to find the…

Q: iii Find the Norton equivalent circuit for the portions of the networks in Figure below external to…

A:

Q: Design a three-input digital circuit using both SOP and POS. a) f = [m(1,3,4,6)

A: here we have to design the three input digital circuits.

Q: Q3. Find the voltages and currents that are asked for in Figure 9-9 if the gates are all standard…

A: To find the voltages and currents in Figure 9-9, we need to analyze the circuit and determine the…

Q: 1 kn D64.4V D₁4.4 O a. el de 5.4 V O b. el de 8.4 V O C. D7 O d. D6 4.4 V I kn Para el circuito…

A: When p side of diode is at higher potential than n side it is forward bias. When p side of diode is…

Q: For the system shown in Figure 2, find the poles of the closed-loop transfer function, T'(s) =…

A: Given Data: A block diagram representation of a system with, Reference input =Rs Controlled output…

Q: Tg = Vth 2 ( 1135 (185) Rth + R²₂ ) ² + (x m + X²₂) ² Pf the result S = max B₂ th Find d Tg ds and…

A:

Q: VS1 = 35 VVS2 = 130 V ww Determine the current through R3 just after the switch is thrown at t = 0+.…

A: Here we have to find the current through the resistor R3 at t=0+.

Q: How does series compensation improve the performance of a transmission line and what are the key…

A: Series compensation is a technique used in power transmission systems to improve the performance and…

Q: The following Deferential equation is represented a system. d²c dt² dc +2+c=r(t) dt a. Find the…

A: A system is represented by a differential equation, d2cdt2+2dcdt+c=rt. To find the transfer…

Q: D3.3. Given the electric flux density, D = 0.3r-a-nC/m₂ in free space: (a) find E at point P(r= 2,…

A:

Q: (a) Use the Standard Resistor Colour-Code Chart in Figure 1.0f to: (i) determine the numerical…

A:

Q: The crust provided is a model for a battery charger. Assume D, and D; are ideal diodes -90 mA, and…

A: The circuit diagram is shown below, Where,Diode D1 and D2  are ideal diodes.Ich=90 mA.VB=4 V.

Q: Given for a FET, gm = 190 mA/v, total capacitance = 1000 PF and voltage gain of -60. The bandwidth…

A: It is given that: gm=190 mAvCT=1000 PFAv=-60

Q: Given the range . Find the per scale value for each range based on the encircled basis only. (Follow…

A: The given image of the analog multi-meter screen is shown below. We need to calculate the values…

Q: Workspace From your observation of the measurement results in Table 5.0, was the operation of a…

A: The potentiometer placement in the bread board is The values of measurement of potentiometer are…

Q: Analyze the timing diagram. What logic gate is being used?

A: Need to analyze the given output timing diagram from time t1 to t3 for various combinations of…

Q: A generator rated 100MVA, 20KV has X"=X2- 20% and X0-5%. Its neutral is grounded through a reactor…

A: The above question is based on unsymmetrical faults under unloaded conditions. The standard results…

Q: True or False: A diode can be used as a voltage source.

A: A diode is a two stage terminal passive device which consumes power.  An active device is the device…

Q: Sketch the Colpitts oscillator (using a BJT), clearly showing the modifications from a…

A: According to the question, we need to sketch the Colpitts oscillator (using a BJT), clearly showing…

Q: A single period of the magnitude and phase spectra of a discrete-time signal is shown below. What is…

A: Asked to  find the following  time domain expression of signal Fourier transform of the given…

Q: For a periodic signal π v(t) = 30 sin 100t + 10 cos 300t + 6 sin 500t + 4 the fundamental frequency…

A: Given- Signal equation, vt=30 sin 100t+10 cos 300t+6 sin 500t+π4.   To find- The fundamental…

Q: Consider a unity feedback control system with a forward T.F : K G(s) (S+3)(5+5) Sketch the root…

A: The above question is based on the root locus in control systems. The rules used are mentioned.

Q: 6. In FM stereo radio broadcast, the Left and Right channels are transmitted as the I and Q channels…

A: To find the given statements are true or false, 6) In FM stereo radio broadcast, the Left and Right…

Q: 2. Find an expression for the voltage gain transfer function, H(s), of the circuit shown below.…

A: In this question We need to determine the voltage gain of the given circuit.  We are solving this…

Q: 2. Find: VAB RAB Vas R Total P Total V1 SOV 1000 R2 w 100 R3 m 100 R7 www 5000 R4 m 200 www 2000 RS…

A:

Q: 2) Given a voltage source, resistor and capacitor arranged in a series circuit, below; a) Calculate…

A: The value of the resistor, R=510 Ω The value of the cpacitor, C=0.22 μF The source voltage, Vs=4 V…

Q: Compute the value in μF for C that yeild a first-order high-pass filter with a passband gain of 8…

A: In this question We need to determine the value of capacitance C if gain is 8 and cut off frequency…

Q: + 10 ΚΩ 3 ΚΩ Μ 50V Σ15kΩ 6kΩ Μ 5 ΚΩ Μ 1 mA {20kΩ i {15 ΚΩ ΚΩ

A:

Q: TJE ww RD Rs UDD = 1,8V Vout (a) Find the Voltage gain: 5 bias current: IMA Mnlox= 100MA/v² UTH =…

A:

Q: 6. Consider the circuit shown in Fig. calculate the total impedance and determine: a) The maximum…

A:

Q: Problem #4: FOR thE FOLLOWING SET OF EQVATIONS CONSTRUCT the Conrosponding Cincit. V₁-V₂ + V₁-V₁.…

A:

Q: Complete the simulation table for the 1-bit register until cycle 4 considering the following inputs:…

A: To complete the simulation table for the 1-bit register until cycle 4, we need to calculate the…

Q: Part 3 (a) Newton's law of cooling describes the temperature T of a body cooling down to the…

A: The above questions are based on laws related to electrical machine design, particularly the design…

Q: Given the following control system block diagram: R(s) 9 s+1 (b) K 1 S Y(s) Find the closed-loop…

A:

Q: 3 2 2 3 15 5 5 25 If these two networks are connected in series, the impedance matrix of the…

A: Given- The impedance matrices of two, two-port networks are, ZA=3223ZB=155525,   To find- The…

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.