You are strip cruising with 1 chain wide strips and the total length of your strips is 100 chains, what is the area you sampled? 50 acres 1000 acres 100 acres 10 acres
Q: For the following systems, we determine N=the minimum number of free nodal displacements that…
A: ASKED: To choose the incorrect statement based upon the number of free nodal displacements of the…
Q: 1.) Draw the Free-Body Diagram for each mechanism shown. Provide a direction a a name for each…
A: To draw FBD
Q: A truck with axle loads of 40 kN and 50 kN on a wheel base of 5 m rolls across a 13-m span. Compute…
A:
Q: During a test crash an airbag inflates to stop the dummies forward motion. The dummy has a mass of…
A:
Q: 24,00,000 litres of water passes through a sedimentation tank which has rate of flow 300 cubic meter…
A: Given data, Volume of sedimentation tank = 24,00,000 litre =2400 m³ Flow rate = 300…
Q: Determine the LRFD design strength and the ASD allowable strength of sections given. Neglect block…
A:
Q: A car weighing 4000 lb, with a wheel base of 9 ft, carries 1700 lb of its load on the front wheels.…
A: To find maximum moment
Q: A masonry dam is founded on pervious sand
A:
Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B = 25 kN, 2 m to the…
A:
Q: A non-prismatic member ij has the following stiffness matrix and the fixed-end moment vector 2.5 S40…
A: in question non prismatic member is given with stifness matrix and moment matrix and question is…
Q: The recorded distance is 4572.36m when the temperature is 20° and the pull was 55N supported only at…
A:
Q: A concrete-lined canal with a bed width of 2 meters and side slope of one(1) vertical, two(2)…
A: Bed width of canal, B =2m Side slope = 1V:2H Uniform gradient, So= 2/100 Manning's coeffiecient, n =…
Q: wheel loads rolls as a 12-m span. The N; B = 25 kN, 2 mt
A: Given:- A=15kN B=25kN C=50kN To find:- maximum shearing force
Q: Analyzing the continuous beam show below, draw the shear and moment diagram
A:
Q: What is a Waste Water Treatment Plant System of a Bread Manufacturing Plant? Describe the system,…
A:
Q: The section shown below, is subjected to a maximum shear and bending of 5 kips and 25 kips-ft,…
A:
Q: The elastic curve and moment diagram for a beam system are shown below. Elastic curve A Moment…
A:
Q: A planimeter measures the area of figure, traversed clockwise with anchor point inside and tracking…
A: Given data, M = 100 cm² C = 20 Initial reading = 3.436 Final reading = 8.945 To find out the…
Q: Design a bored pile carrying a compressive load of 1000 kN and a moment of 50 kNm. Use M25 mix and…
A:
Q: A triaxial test performed on a clay sample, under unconsolidated-undrained (UU) conditions, reaches…
A: In case of UU test the diameter of Mohr circle DOESN'T change if the confining stress is varied…
Q: A concrete beam of rectangular cross-section of size 120 mm (width) and 200 mm (depth) is…
A:
Q: car weighing 2000 lb, with a wheel base of 9 ft, carries 1400 lb of its load on the front wheels.…
A:
Q: time in minutes to remove half of the volume contained through the orifice b. time in seconds to…
A: Coefficient of discharge: - It is defined as the ratio of actual flow from nozzle to theoretical…
Q: A planimeter measures the area of figure, traversed clockwise with anchor point inside and tracking…
A:
Q: 3. Route the inflow hydrograph using Muskingum method; hr, = 0.2, = 0.65 hrs. %3D Time 01 2 3 4 5 6…
A: Given : Muskingham method Time and Inflow rate is given K = 0.65 hrs x = 0.2 t = 1 hrs
Q: Two distance 200 m and 298 m are measured from tacheometer instrument and corresponding staff…
A:
Q: Deflection of Beams 1. Determine the midspan deflection of the beam if E = 10 GPa and I= 20 x 10 mm…
A:
Q: In a consolidation test, when the load is changed from 50 kN/m² to 100 kN/m², then the void ratio…
A: Given a consolidation test data: Load is changed from, σ0=50 kNm2 to σ1=100 kNm2 Void ratio…
Q: Please find footing by C/C method , full detail please note/all dim in mm
A:
Q: An architect-engineering firm is planning a parking lot to accommodate 400 vehicles. Each parking…
A: Given:- The total number of vehicles to accommodate = 400 vehicles The dimension of each parking…
Q: Q1: - A simple horizontal curve has: R= 138m, C = 87m and station P.T. - 3D(52+50). Compute: 1- The…
A: Curves are regular curves in lines of communication, such as roads, trains, and canals, that allow…
Q: Three equal wheel loads of 30 kN each, separated by 2 m between each load, roll as a unit across a…
A: A moving load is acting of bridge span and it has been asked to determine maximum bending moment.…
Q: Question 29 A hydraulic press has a ram of 300 mm diameter and a plunger of 45 diameter. When the…
A:
Q: Determine the horizontal and vertical 1.8 kN 1.8 kN 2.7 kN 2.7 kN reactions at the connections A and…
A:
Q: Network Diagram From the following data, determine the following:
A: For the following activity the network diagram will be:
Q: Find Hp of the turbine, (V=20 ft/s, * D=18 in , L=150 ft, f=O.03) Water 200 ft Turbine 20 tvs 200 ft…
A: ASKED: To determine the head of the turbine (Hp). Given, Head of water at the inlet of the pipe…
Q: 3–10. Determine the force in each member of the truss. State if the members are in tension or…
A:
Q: 1. Liquid Carbon Tetrachloride (CCL4) having a volume of 387 liters has a mass of 600kg. Determine…
A: As per the guidelines, we are supposed to solve 1st question only, kindly repost the other part of…
Q: 07. A cold drawn seamless steel tubing subjeet to internal pressure, has a dia of 6 cm and wall…
A: Ultimate strength, diameter and thickness have been given and it has been asked to determine…
Q: A 10 lb block is in equilibrium. What is the magnitude of the friction force between this block and…
A:
Q: Check the slenderness of the steel section against Local Buckling. 400 mm y 20 mm 340 mm X 30 mm 20…
A: A steel "I" Section is given in the question. Properties of the I-section are as follows : Width of…
Q: PI Elev 108.00m 1.50m +6% -3% 8.00m Sta 1+060 PT PC Sta 1+000 Elev 100.00m Answer the following:…
A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…
Q: A truck with axle loads of 20 kN and 60 kN on a wheel base of 5 m rolls across a 13-m span. Compute…
A:
Q: Two tangents of a simple curve have azimuth of 250 degrees 15' and 280 degrees 15' respectively and…
A:
Q: All the members in the frame have the same E and I. A is fixed, and C and D are pinned. The frame…
A:
Q: 1. Compute the vertical distance of link AB from pin E for the given set up if the tension in link…
A: Given:- The magnitude of the weight at GF = 800 lb The magnitude of the tension in link AB = 1500 lb…
Q: 554. What safe value of W can be applied to the beam loaded as shown in Fig. P-554 if o, < 60 MPa…
A:
Q: In a triaxial test for a soil sample, when the principal stresses are 270 kPa and 40 kPa, the soil…
A: Given: Triaxial test on a soil sample. Major principal stress, σ1 = 270 kPa Minor principal stress,…
Q: Determine the moment of inertia (Ix and ly) of the T-section of a cast-iron beam as shown with…
A:
Q: PROBLEM he centroid of the T-section shown is 1.6 ches above the base and x is 10. What hould be the…
A:
Step by step
Solved in 2 steps with 2 images
- Rancher’s dilemma A rancher has 400 ft of fence for constructing arectangular corral. One side of the corral will be formed by a barn and requires no fence. Three exterior fences and two interior fences partition the corral into three rectangular regions as shown. What are the dimensions of the corral that maximize the enclosed area? What is the area of that corral?Determine the average owner occupancy rate (percentage) for the three cities: From the following dataCityA B COwner occupancy (percentage)40.3 56.4 62.1Number of housing units (thousands)1,135 113 2101.What is the value CD? 2. What is the value CE?
- Choose the right answer Land transportation system included a-Railway b-Cannel ways c-Airwaysshow complete solution and formula What is the most probable value of a rectangular lot having the width and length of 239.01 ±0.03 m and 497.22 ± 0.03 m? Express your final answer in cm2Define each term in three sentences only. 1. Average Daily Traffic 2. Annual Average Daily Traffic (AADT) 3. Pavement Crowns
- Q1.) Consider a triangular shaped pasture for which a perimeter fence must be built. The length of the side A is 300m +- 2%, the length of side B is 400m +- 3%, and the length of side C is 500m +- 0.5%. What is the nominal value of the measure in meters? What length of fencing must be purchased in meters?When a civil engineer is a prime professional and is constructing a market building, what should be his/her minimum compensation if the project construction cost is: a. 15 million b. 30 million c. 45 million d. 28 million When a civil engineer is a prime professional and is constructing a tower, what should be his/her minimum compensation if the project construction cost is: a.12 million b. 14,500,000 c. 33,000,300 d. 9,600,017 Show your solutionFor 300 trips, assign them using constant assigntment ratio Route Hours 1 1.1 2 1.2 3 1.3 4 1.4 5 1.5