Ży = 69 + 36j ohmsZw = 9 + 6j ohmsLine to line Voltage = 420VAssume positive sequence and Van with zero angle.VZwZyanAVonZwZy01BVenZwZyDetermine the phase current of Vbn.Select your answer.2.7372 angle -28.3 Amp.2.7372 angle -148.3 Amp.2.7372 angle -91.7 Amp.2.7372 angle 0 Amp.

Answered: Image /qna-images/answer/95b5aa9a-43d7-4e19-a59e-0b18af658391.jpg

Answered: Zy = 69 + 36j ohms Zw = 9 + 6j ohms %3D…

Zy = 69 + 36j ohms Zw = 9 + 6j ohms %3D Line to line Voltage = 420V Assume positive sequence and Van with zero angle. Zw Zy a A IA Von Zw Zy B V Zw Zy on Ic Determine the phase current of Vbn.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26MCQ: A balanced -load can be converted to an equivalent balanced-Y load by dividing the -load impedance...

See similar textbooks

Related questions

Q: A solenoid with an inductance of 0.25 H and a resistance of 100 is connected to a 120-V 60-Hz source...

Q: in a series circuit the voltage in every element is equal and follow the law of conservation of ener...

Q: +15 Vcc RC 1.5 k2 22 k2 ß = 150, R2 4.7 k. SRE 680 kN

Q: A three-phase induction motor has a rotor resistance and standstill reactance of 0.1 ohm and 3.5 ohm...

Q: What is the output voltage(R1) on the 1st half cycle? * C1 Y D1 R1 12V V3V

A: The solution is given below

Q: 30.determine the values of VCB and IB for this circuit.

Q: 1) The required sampling frequency to get ten samples/cycle for a signal that has a baseband of 15 k...

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: Design a circuit diagram for the following comparator system that takes three 3-bit binary numbers [...

A: Given that 3 bit input A,B,Coutput=1; if A-3<Boutput=0;otherwise

Q: e resistivity of a conductor ranges in giga lect the correct response:

Q: A certain appliance uses 350 W. If it is allowed to run continuously for 24 hrs, how many kilowatt-h...

Q: what is the total resistance

Q: The current entering the positive terminal of a device is i(t) = 3e-2" A and the voltage across the ...

Q: 1. Calculate the current for a 3v battery and a 1.5 kilo ohm resistor. Then, calculate the silicon v...

Q: What is the dimensioning system shown in the figure below? 1.31- 67 - .31 51

A: Unidirectional dimensioning system The dimensioning system used in given figure is unidirectional d...

Q: The variable resistor Ro in the circuit shown in is adjusted until maximum average power is delivere...

A: Solution- From the diagram, keeping the a-b terminal open circuited and measure the open circuit ...

Q: A 2,500 kVA, three-phase, 60 Hz, 6.6 kV wye-connected alternator has a field resistance of 0.45 ohm ...

Q: The current gain α of a transistor is 0.995. If the change in emitter current is 10 mA, the change i...

Q: If you make a circuit with R1 6 KOhm and R2 = 9 KOhm, and your %3D %3D UIN UOUT GND

A: Solution

Q: Explain the basic principle of IP (induced polarization)! (b) the mechanism for the occurrence of th...

A: We have given the following problem a) Explain the basic principle of IP (induced polarization)! (b)...

Q: Describe fabrication steps of CMOS inverter

A: CMOS Technology is used as it dissipates less power. Fabrication steps of CMOS inverter are- Choos...

Q: The maximum value of 50 Hz an AC voltage is 100 V. Its value after 1/300 second will be O a. 66.8 V ...

A: Given: The maximum value of ac voltage, Vm=100 V Frequency, f = 50 Hz Time, t = 1300 sec

Q: Find i(t) and v(t) for t ≥ 0.

Q: An electric stove with four burners and an oven is used in preparing a meal as follows. Burner 1: 40...

A: The solution is given below

Q: ollutant. (Use 4 significant figures.) * Each sample of water has a 10% chance of containing a parti...

A: Here,The probability of containing the particular organic pollutant is,P=10%Samples, n=18Pollutant, ...

Q: A 15 V source is connected across a 12-0 resistor. How much energy is used in three sec? Select the ...

A: Energy = power × time in sec ws Power = voltage 2/ resistance.

Q: How many 10-kilo-ohm resistors should you connect in parallel to get an equivalent resistance of 1.2...

A: We know that whenever equal value resistors are connected in parallel then the equivalent resistance...

Q: 1. Calculate the current for a 3v battery and a 1.5 kilo ohm resistor. Then, calculate the silicon v...

Q: 169sin 377t a) What is the RMS value? b) What is the Average value?

A: Given: Let V=169sin 377t

Q: 4. Given the electric circuit of figure 4 where v(t) is a small signal source. i(n) 1 H Nonlinear re...

Q: 3 phase system V = 240kv supply to 2 sets of balanced loads connected in Y type Load 1: P=30kw,PF=0....

Q: Problem: Consider the following canonical form of a Boolean function F(W,X,Y,Z) F(W,X,Y,Z)=E(1,3,4,5...

Q: What is the advantage of the JK flip flop over the SR flip flop?

A: Advantage of JK flip flop

Q: The PDN of a CMOS Logic Gate is shown below QI A Y Q4 Q2 B- Q3 В Qs If L=0.25µm design W for Q1, Q2,...

Q: Suppose you are an electronic circuit designer. How you can use the center-taped step down transform...

A: Center Tapped Step down Transformer- In this type of transformer, a wire is connected exactly at the...

Q: 3) The current passing through a resistor of 50± 0.2 Qis 4 +0.02 A. Determine the limiting errors. 4...

Q: 5) Two capacitors ofvalues C1 = 99 ±1 µF and C2 = 49 ±1 µF are connected in series once and in paral...

A: Note: As per our company guidelines we are supposed to answer only one question. Kindly repost other...

Q: Calculate the resistance of 1 km long cable composed of 38 stands of similar copper conductors, each...

A: Given that, length L=1 km=1000 m Number of strands = 38 diameter D=1.32 mm =0.00132 m change in len...

Q: In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of B is. .......... а. 100 О. 50 O c. about...

Q: Figure P4.22 25 V 20 N + 14 13 2 A 50 Ω 150 :55 Ω a

Q: The following information is given in connection with three loads connected to a 240-V source: load ...

Q: A lead wire and an iron wire are connected in parallel. Their respective specific resistances are in...

A: In this question we will find wire ratio of area with given length , current and specific resistance...

Q: Determine the voltage gain of the amplifier

Q: ulate the total charge

Q: can bias a diode forward or reverse. Soon: a) Directly polarizing means connecting the positive of ...

Q: Find the mnemonic and the operand of the following machine code (shown as hexadecimal numbers) BE EF

A: Machine code is an important language to understand the computer. It is processed by a Central proce...

Q: Q3. Consider the following 1-bit ALU Operation -Result a. Add additional hardware to this ALU to sup...

A: The given 1-bit ALU is shown below,

Q: An electric lamp whose resistance, when in use, is 2 0 is connected to the terminals of a dry cell w...

A: In this question, Calculate the internal resistance r and voltage difference between terminal of th...

Q: About sources, check the correct statement(s). a) A power supply is composed of at least six parts,...

Q: Determine the proper size of copper wire conductor necessary to apply a 750 W electric motor that is...

A: It is given that: P=750 WL=100 feetVpanel=120 voltsVdrop=1.2 volts

Q: he x(t) signal is given. Even{x(t)} and Odd{x(t)} signal parts of this signal. get it and draw it.

A: Given signal

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Ży = 69 + 36j ohms
Zw = 9 + 6j ohms
Line to line Voltage = 420V
Assume positive sequence and Van with zero angle.
V
Zw
Zy
an
A
Von
Zw
Zy
01
B
Ven
Zw
Zy
Determine the phase current of Vbn.
Select your answer.
2.7372 angle -28.3 Amp.
2.7372 angle -148.3 Amp.
2.7372 angle -91.7 Amp.
2.7372 angle 0 Amp.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two impedances z1=4+j6 and z2=3-j6 are connected in parallel to a supply voltage of 120V. Determine the magnitude of the current and its phase relative to the 120V supply voltage. Remember: 1/z = 1/z1 + 1/z2 I = I/V
What is the complex power delivered to the three phase load of a four-wire Y-Y circuit. The phase voltages of the Y-connected source are Va= 110 angle (0) Vrms, Vb= 110 angle (-120) Vrms, Vc= 110 angle (120) Vrms. The load impedances are Za=Zb=Zc= 50 +j80 ohms?
*2 2-If in an ach phase sequence, V,, = 1002 — 20 V then V, is: a)1002-1400vV O b) 10021000V O ©) 10024500V O d)100£100v O wsthas Sl i @
BalancedIn 3-phase star-star connection, 2 equivalent loads are connected in parallel.Va(t) =100cos(2t) is given. so what is A if Vz=Acos(2t+B)
Hello I need a full explanation about the power of y and delta connection what Is the advantages and disadvantages all information about them in the 3 phase system
Find the line voltage Vab of Vbn=265.6 angle 37° and the sequence is BCA.
A three-phase load has a line voltage of 480V and a line current of 10A. What is the three phase apparent power of the load? Possible answers 8.3kVA 4.8kVA 14.4kVA 9600VA
The unbalanced Y load of the circuit has balanced voltages of 100 V and a-c-b sequence.Calculate the line currents and the current in the neutral, taking into account that ZA = 15 Ω, ZB = 10 + j5 Ω and ZC = 6 - j8 Ω
A delta connected load (Figure 2) has an impedance Z is(12 + j35) ohms. If the applied VAB voltage is 380 V with -50º phase . Get the current IC and load IAB current.
You have a 3 phase wye connected resistor network. The Line voltage is 208V and the line current is14A.Draw out this circuit and solve for the following: Phase voltage =Phase current =Phase resistance =Total power =
A 400V three-phase, four wire dystem has the following loads connected: Phase 1: Load impedance Z1= 4- + j15 Ohms Phase 2: Load impedance Z2 = 60 Ohms Phase 3: Load impedance Z3 = 15 - j20 Ohms Draw the circuit diagram and determine: The line and phase voltages for all phases (Including phase angles)
14. An unbalanced, star-connected load is fed from a symmetrical 3-phase system. The phase voltages across two of the arms of the load are Vb=295 ∠ 97° 30' and Vr= 206 ∠-25°. Calculate the voltage between the star-point of the load and the supply neutral. (152.2 ∠ -49.54) Answer