=. A 4-pole, lap-wound armature has 144 slots with two coil sides per slot, each coil having two turns. If the flux per pole is 20 mWb and the armature rotates at 700 rpm, what is the induced voltage?

Q: A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house…

A: The radio antenna receives all frequencies. In order to filter the desired frequencies, the radio…

Q: What does OS X has? a) monolithic kernel with modules b) microkernel c) monolithic kernel d) hybrid…

A: The correct option along with the explanation is provided in the following section.

Q: What is the z-transform of: 3nu(n)

A:

Q: For Common - collector of Emitte Follower JB 3RB 270k 3=120 -Vo 13 RE JE 2,4K 3 VEE -24V

A:

Q: Explore sources of static and dynamic power dissipation in CMOS logic.

A: CMOS refers to "Complementary Metal Oxide Semiconductor" . They are made of silicon and germanium,…

Q: find the value of RL for the given circuit if maximum power is transferred. 40 Q ww 360 V w a 1000…

A:

Q: A group of students were debating the effi ciency of the fi ve-stage pipeline when one student…

A: The Pipelining in a Microcontroller architecture can be defined as the set of the defined category…

Q: For the monostable multivibrator of Fig. 17.6, R₁ = 75 k2; calculate C for one shot high period of…

A: We got an monostable multivibrator as shown in figure   R1 = 75 KΩ   High period (Th) = 25 μs =…

Q: The value of Planck's constant is 6.63 x 10-34 Js. The speed of light is -1 3 x 10¹7 nms ¹. Which…

A: Given, Planks constant, h= 6.63×10-34 Js. Speed of light, c = 3×1017nms-1 Frequency of light, f=…

Q: Q4. A system has the following transfer function 00(s) 2 0₁(s) 3s² + 3s + 2 Calculate the undamped…

A: Given: A system has transfer function θ0sθis=23s2+3s+2

Q: What would be the inducesd voltage for a conductor moving at a speed of 25 km/h and having a length…

A:

Q: Vact) Question: + √x 1052 ja(t) 5mH ron 2mH roood v(t) 55 use 10 MF It Va (t) = 100 cos ( lowt - 30…

A:

Q: Let's consider a loop of wire with an unknown shape but in order to analyze it we need to assume a…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: Solve using Kirchoff's Law in solving the branch currents.

A: KVL, states that “in any closed loop network, the total voltage around the loop is equal to the sum…

Q: Four resistances are connected in shunt against 110 V supply. The resistance are such that R1>R2,…

A:

Q: 1 0 8 (t) t

A:

Q: A 20-hp, 110 V DC shunt motor has an efficiency of 88% and the exciting current of 4 amperes and an…

A:

Q: Consider a region where a 2.63-volt-per-meter electric field and a 2.78-tesla magnetic field exist…

A:

Q: 24. What value is to be considered for a "don't care condition"?

A: The correct option along with the explanation is provided in the following section.

Q: A long straight wire carries a current I = 1 A. At what distance is the magnetic field 1 Am-¹?

A: Given data, Current i = 1 A Magnetic field B = 1 A/m

Q: ⇓ Given x[n] = {4, 6, 8, 3} Analyse a. s[n] = x[n - 1.5] b. z[n]y[n/2] where y[n] = x[−n + 2]

A: Given:  x[n] = {4, 6¯, 8, 3}the signal x[n] is starting from n=-1where x[-1] =4, x[0]=6, x[1]=8,…

Q: Write an HDL dataflow description of the logic circuit described by the Boolean function in Problem…

A: Given data: boolean function with a 4×1 multfluxer and externals gates  a).…

Q: Write and verify a behavioral description of the counter described in Problem 6.24. 1. ∗ Using an if…

A: Flip flop:- Basic flip-flops can construct by four NAND or four NOR gates. It maintains its state…

Q: The first column of the Routh table of a system is made by the following 2K-3 values: -4, 3, and…

A:

Q: Which of the following is true regarding the relative permittivity of the dielectric used for the…

A:

Q: The three-phase half-wave converter in Figure P10.18 is operated from a three-phase Y-connected…

A: An electrical circuit known as a half-wave rectifier transforms only one-half of the AC cycle into…

Q: A sequential circuit with two D flip-flops A and B, two inputs, x and y; and one output z is…

A: Given parameters: Two inputs- x & y One output - Z Two Flip-flops- A & B State equations:…

Q: Which of the following is an effective tool to determine directly the conductor surface equation?…

A:

Q: The length of a magnetic circuit of a relay is 25 cm and the cross-sectional area is 6.25 cm2. The…

A: The length and cross-sectional area of magnetic circuit of a relay is, lm=25 cm=25×10-2 mAm=6.25…

Q: 1. A single phase circuit with a given load  5 ohm resistance and capacitive  reactance of 2 ohms as…

A:

Q: | ΜΑ For the op-amp circuit of Fig. 6.21, find Vo 10 ΚΩ wwwwww + V₁ V₂ ΜΜΜ 99 ΚΩ wwww 1 ΚΩ Hli RL Vo

A:

Q: A4 = A Zener regulator shown in Fig. A4. The source resistor Rs 10002 and the Zener voltage V₂ =…

A:

Q: What would be the inducesd voltage for a conductor moving at a speed of 25 km/h and having a length…

A: Given data, Speed of conductor, v=25 km/h Length, L=1 m Magnetic flux density, B=0.6 T

Q: A transformer may be used to provide maximum power transfer between two AC circuits that have…

A: Given: A transformer may be used to provide maximum power transfer between two AC circuits that have…

Q: In the circuit below, what is the value of the current I1? A O 0.52 A 0.19 A O 0.25 A O 1.25 A 25 Ω…

A:

Q: 1. Write an expression for the output in each circuit below. a) A- Ja Out b) A 3-0 B Out

A: a) Given data, Logic circuit,

Q: 03 For the op-amp eircuit in Figure 2: a) Determine if the circuit can regulate the output voltage.…

A: Given data, VZ=4.7 V R1=5k ohm R2=1k ohm

Q: Given the following unit step response of a second order system, calculate the following values: 1.…

A: The above plot is the standard plot of tep response of a 2nd order system. Peak time is defined as…

Q: ) A single-phase transformer, with primary turns of 500, is delivering full-load of 80 kW at a…

A: We are authorized to answer three sub part at  a time, since you have not mentioned which question…

Q: A wye-connected synchronous motor connected to a 440V, 3-phase line is operating with an electrical…

A:

Q: An annoying thing about CMOS is that it is naturally inverting so if you wanted to implement a…

A: Given that CMOS has the unpleasant tendency to invert automatically in this situation if we wished…

Q: The transfer function of (1-7)(1-12-²²) a resonance MCZ) = 1=2rcos (W₂T) Z_ +r+Z ² -2 3 Date: filter…

A:

Q: 1. In Superposition theorem, while considering a source, all other voltage sources are? A. open…

A: Superposition theorem : According to superposition theorem when a circuit consist of multiple number…

Q: f(t) A t

A: In this case, the Laplace transform of the given function is to be determined.

Q: A trigger pulse is applied to the sweep generator every 10 ms. Compute the amplitude of the voltage…

A: A trigger pulse is applied to the sweep generator, Given data Time (t) = 10 ms = 10 * 10-3 sec…

Q: . Determine the z-transform and ROC

A:

Q: What is the role of the @ operator and a sensitivity list in an always statement?

A: Sensitivity List: The sensitivity list will have the list of signals for which the always statement…

Q: Part 1. Determine the inverse z-transform using partial fraction expansion that results to a causal…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: IN RB 270k B=120 RE 2,4K VEE -24V TE

A:

Q: The boolean function F=A+A'B+C+C'B' can be minimized to be equal to OA+B+C OA+C 01 00

A: Given function, F=A+A'B+C+C'B'

Gear Motor

A gear motor is a combination of a gearbox and an electric motor. This combination of two systems is used for efficient usage of the motor. It makes a cost-effective solution for high torque, low-speed applications. These motors are used in our household as, garage door openers, alarm clocks. In commercial areas, hospital beds, cranes.