. A device called air-track glider has a mass of 150gm is attached to the end of a horizontal air-track by a spring with a force constant 20N/m as shown below. Initially the spring is unstretched and the glider is moving at 3.50m/s to the right. Find the maximum distance d that the glider moves to the right, if the air is turned off, so that there is kinetic friction with coeficient He=0.40 glider

. A device called air-track glider has a mass of 150gm is attached to the end of a horizontal air-track by a spring with a force constant 20N/m as shown below. Initially the spring is unstretched and the glider is moving at 3.50m/s to the right. Find the maximum distance d that the glider moves to the right, if the air is turned off, so that there is kinetic friction with coeficient He=0.40 glider

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.48P: Find the smallest distance d for which the hook will remain at rest when acted on by the force P....

See similar textbooks

Similar questions

The coefficient of rolling resistance between the 30-kg lawn roller and the ground is r=0.1. (a) Determine the force P required to pull the roller at a constant speed. (b) What force P would be needed to push the roller at a constant speed?
By using a forked rod, a smooth cylinder C having a mass of 0.5 kg is forced to move along the vertical slotted path (r = 0.4 θ) m, where θ is in radians. If the angular position of the arm is θ = (0.3 t3 ) rad, where t is in seconds. The cylinder is in contact with only one edge of the rod and slot at any instant. Find "the force of the rod on the cylinder at the instant t=2s" Find "the normal force of the slot at the instant t=2s" Find the "radius of curvature at t=2s" Find the "ψ angle at t=2s"
A wagon weighing 500 kN starts from rest, runs 30 meter down one percent grade and strikes the bumper post. If the rolling resistance of the track is 5 N/kN, find the velocity of the wagon when it strikes the post. If the bumper spring which compresses 1 mm for every 15 kN determine, by how much this spring will be compressed.
A constant force of ''F'' acts on a mass as shown. The mass starts its motion from rest at position 1, the unstretched length of the spring is 250 mm, and the spring modulus is k=1,5 k?/m. Neglecting the friction, determine the required force ''F'' to cause the 2−kg mass to have a speed of v2=1,5 m/s at position 2.
The lower block of mass m2 = 3.2 kg is pulled on by a rope with a tension force of 28 N. The upper block has mass m1 = 1.8 kg. The coefficient of kinetic friction between the lower block and the surface is 0.32. The coefficient of kinetic friction between the lower block and the upper block is also 0.32. What is the acceleration of the 3.2 kg block?
Find the downward acceleration of m1 if it has a mass of 27.8 kg and the kinetic coefficient of friction of m2 and m3 to the surface has the same value of 0.2.
(The complete question is in the picture) Consider a 2.0 [kg] box that is attached to two identical springs that are in their relaxed state when the block is centered on the frictionless horizontal floor. The box is pressed to the left and then was released from rest as shown in the figure. If work done by the left spring is Wby spring = 25 [J], what is the speed of the boxas it passes the center x = 0? A. 8.2 [m/s]B. 7.1 [m/s]C. 3.5 [m/s]D. zero
Block A with a weight of 100N (mA=10kg) moves to the right (vA=1 m/s) at the moment shown in the figure. Since the kinetic friction coefficient between the surface and block A is μk=0.2, find the speed of block B when it moves 2 meters its weight is 200N (mB=20kg)
A mass-spring system is initially compressed towards a wall and hold in equilibrium withthe help of a forceF. At timet=0sec, the force Fis suddenly released. The mass-spring system then reaches a velocityvwhile sliding on the frictionless surface. (a) Is the linear momentum conserved? (b) Calculate the average force exerted by the wall on the mass-spring system after theforceFis released, assuming that the spring remains in contact with the wall for a shorttimeΔt. Express your answerin terms of k,m,Δt and F.
A block of mass m= 2.0 kg is released from rest on an inclined plane at a height of h = 1.5 m. It moves down the rough incline with slope theta= 30.0°and continues on the horizontal frictionless surface. As shown in the figure, there is a spring with negligible mass and force constant k = 300 N/m. The coefficient of kinetic friction between the block and the incline is 0.250 What is the speed of the block when it gets down on the horizontal surface before it touches the spring? The box continues to move on the horizontal surface and compresses the spring. What will be the maximum compression of the spring?
The 2.0 kg block slides along a smooth (frictionless) plane with a speed of 2 m/s and then strikes an unstretched spring with a spring constant of 220N/m. Find the speed of the block in meters per second after the spring has compressed 150 mm. What will be the maximum compression of the spring
A block with mass 0.400 kg is on a horizontal frictionless surface and is attached to a horizontal compressed spring that has force constant k=200N/m The other end of the spring is attached to a wall. The block is released, and it moves back and forth on the end of the spring. During this motion the block has speed 3.00 m/s when the spring is stretched 0.160 m. During the block's motion, what is the maximum distance the spring is compressed from its equilibrium position? When the spring has its maximum compression, what is the speed of the block and what is the magnitude of the acceleration of the block?