velocity of the collar is 0.1 m/s. The spring attached to the collar has an undeflected length of 10 cm and a constant of 3 N/m. Calculate the distance x of position 2, where the collar will come to a stop. A 2-kg collar slides without friction along a horizontal rod as shown. At the position 1, the 20 cm- Vi= 0.1 m/s wwww x= ? www 20

velocity of the collar is 0.1 m/s. The spring attached to the collar has an undeflected length of 10 cm and a constant of 3 N/m. Calculate the distance x of position 2, where the collar will come to a stop. A 2-kg collar slides without friction along a horizontal rod as shown. At the position 1, the 20 cm- Vi= 0.1 m/s wwww x= ? www 20

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two weights of 96 pounds and 64 pounds move horizontally on a surface smooth, each spring has k = k1 = k2 = 600. At t = 0 the springs are unstretched and the weight of 96 has a velocity of 600 ft/sec away from the wall and the other is in repose. Solve the system of equations for the given conditions, and explain how the equations of motion are obtained for each mass ('x(t)' and 'y(t)').
Determine the time required that the elevator travels at any instant at a distance of 8 meters. The weight of the elevator is 10,000 N moving downward from rest until its velocity is 15 m / sec. (sec.) 2. In Problem 1, determine the force exerted in the cable to support the elevator. (kN)
Show the complete solution. Put notes on steps. The wooden block (mass m = 0.6165 kg) is released from rest at A by a compressed spring (compressed length 0.6 m, undeformed length 1 m, spring constant k = 150 N/m). The block is allowed to slide through the rough horizontal surface (A to B), then along the smooth circular ramp (B to C, central angle 0 = 45°, until the block is released after point C. Calculate the speed of the block at points B and C. Also, what is the magnitude of the normal force exerted to the block just before the block leaves the ramp? Neglect the geometry of the block.NOTE: Use Work-Energy Method to solve for the speeds; use Force-Mass-Acceleration (FMA) Method to compute for the normal force.
The lower block of mass m2 = 3.2 kg is pulled on by a rope with a tension force of 28 N. The upper block has mass m1 = 1.8 kg. The coefficient of kinetic friction between the lower block and the surface is 0.32. The coefficient of kinetic friction between the lower block and the upper block is also 0.32. What is the acceleration of the 3.2 kg block?
A 0.45 kg collar, of negligible size, is attached to a spring having an unstretched length of 190 mm. If the collar is released from rest at A and travels along the smooth guide, what is its speed just before it strikes the stop at B? 200 mm EM - B k = 150 N/m A 400 mm
The spring-mounted 0.8 kg collar A oscillates along the horizontal rod, which is rotating at the constant rate q = 6 rad/sec. The spring constant k equals 5 N /m and the coefficient of kinetic friction mk equals 0.4. At a certain instant, r = 0.2 m, which is increasing at the rate of 800 mm/s, while r = 0.3 m / s2. For this instant, calculate the friction force from the rod onto the collar and the elastic force on the collar. Indicate whether or not the elastic force points towards the origin O and then calculate the spring stretch. (Hint: the total normal force between the rod and the collar results from both the weight of the collar and the transverse normal force that is perpendicular to the rod on the plane of rotation of the rod.) PLEASE ANSWER ALL QUESTIONS!
A weather balloon is floating at a constant height above Earth when it r eleases a pack of instruments. a. If the pack hits the ground with a downward velocity of -73.5 m/s, how far did the pack fall? b. Calculate the distance the ball has rolled at the end of 2.2 s.
The 2.0 kg block slides along a smooth (frictionless) plane with a speed of 2 m/s and then strikes an unstretched spring with a spring constant of 220N/m. Find the speed of the block in meters per second after the spring has compressed 150 mm. What will be the maximum compression of the spring
the 75 n crate is released from rest in incline surface at time t=0. The coefficient of kinetic friction between the crate and the surface is 0.14. How fast the crate is moving at t=1.5s
A constant force of ''F'' acts on a mass as shown. The mass starts its motion from rest at position 1, the unstretched length of the spring is 250 mm, and the spring modulus is k=1,5 k?/m. Neglecting the friction, determine the required force ''F'' to cause the 2−kg mass to have a speed of v2=1,5 m/s at position 2.
A 10-kg body falls from rest, with negligible interaction with its surroundings (no friction). Determine its velocity after it falls 5 m. Derive with the formula below, show the cancellation, explain the step by step and draw a free body diagram/figure.
A wagon weighing 500 kN starts from rest, runs 30 meter down one percent grade and strikes the bumper post. If the rolling resistance of the track is 5 N/kN, find the velocity of the wagon when it strikes the post. If the bumper spring which compresses 1 mm for every 15 kN determine, by how much this spring will be compressed.