. A four component mixture (ABCD) has AB with K-values > 10 and CD with K-values <0.1. Under the perfect split assumption in a flash operation, AB would go as vapor and CD as liquid. Using the data given below, find the corrections to the perfect split for component B and component C, and their corrected flowrates. Compt. ABCD fi, mol/hr 600 950 400 150 Ki 60.0 12.0 0.05 0.01 [4]

Q: At 25°C, what is the pH of the solution produced when 0.0700 mL of 36.0 wt % HCI is diluted to 500…

A: Calculating the normality (or the [H+]) concentration first for calculating the pH, N1V1=N2V2N1 =…

Q: isothermal reversible expansion

A:

Q: A thermostat control with dial markings from 0 to 200 is used to regulate the temperature of an oil…

A: Introduction Thermostat controller A tool that routinely controls heating or cooling device in this…

Q: The fugacity coefficient of a certain gas at 290 K and 3.1 MPa is 0.74. Calculate the difference of…

A:

Q: Liquid A(sp gr = 0.95) at a temperature of 29°C is flowing at a rate of 120gal/min in a pipe with an…

A: For a detailed solution, please see the attached files.

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A:

Q: Sulphur dioxide is circulated as refrigerant in a small refrigerator. SO2 gas at a  pressure of 5…

A: Introduction  The general gas equation, commonly referred to as the ideal gas law, represents the…

Q: A fuel gas mixture of 10500 lbmol/hr 35 mol% ethane, 25 mol% propane, and the balance butane is fed…

A: Given, The molar feed rate of fuel, n = 10500 lbmol/hr The mole % of the components in the feed are…

Q: Ans. Bos 25: Hot oil at a rate of 1.2 kg/s (Cp = 2083 J/kg-K)) flows through double pipe heat…

A:

Q: (a) Estimate the transition length at the entrance to a 15-mm tube through which 100 percent…

A: Given data: Diameter of tube = 15 mm Velocity = 0.3 m/s Density of glycerol = 1240 kg/m3 Temperature…

Q: The following temperature/composition data were obtained for a mixture of octane (O) and…

A: Given, Pressure of the mixture= 1 atm x=mole fraction of liquid at equilibrium. and y= mole fraction…

Q: please write your solutions typing it makes it very confusing

A:

Q: 4. A soil contains 3,500 ppm of available Ca²+. Use this information to calculate the following: a.…

A:

Q: A one cubic foot tank, which is perfectly rigid, contains humid air at 20 psig and 70°F. Heat is…

A: Given, The initial pressure of air, P1 = 20 psig The final pressure of air, P2 = 50 psig The initial…

Q: A mixture of mole fraction 0.500 ethanol and 0.500 water at 25 ºC is fed continuously to a vessel at…

A: Mole fraction of ethanol in the given mixture is 0.5 and mole fraction of water in the given mixture…

Q: Assuming the validity of Raoult's law, do the calculations for the acetone(1)/tert-butanol (2)…

A: Dear Subscriber! We have answered the first three subparts as per our authoring guidelines. Please…

Q: 1000 kg/h of an aqueous feed solution containing 38 wt.% potassium nitrate (KNO3) and 0.2 wt.% CaCO3…

A: An aqueous solution of potassium nitrite is crystallized in an evaporator crystallizer.

Q: A hydrocarbon system is flashed in a drum at 325 psig and 300 K. Assume that the system obeys…

A: First, calculate the vapor pressure of each of the components using the Antoine equation given, For…

Q: d. The flash drum is operated such that the liquid mole fraction is 33 mol % dichloromethane, liquid…

A:

Q: Look at the Cu-Ni alloy in picture 1. After 700 hours of heat treatment at 1100 °C, the…

A:

Q: Name major three classes of column packings and give a currently-popular and an obsolescent example…

A: To  a. three major three classes of column packings  b. give a currently-popular and an obsolescent…

Q: A liquid film of constant thickness L flows down an inclined wall that makes an angle with the…

A: Given, The liquid film has thickness= L Make necessary assumptions and then do the shell momentum…

Q: In the concentration of fruit juices, a portion of the feed is redirected to bypass the evaporator…

A:

Q: Naphthenes are * O None of the these Unsaturated cyclic compounds O Straight chain saturated…

A:

Q: the cell: pt / H₂ (latim) / NaOH cm) / HgO cs) / Hg = 0.924V 0.854 V and Егадк Calculate standard…

A:

Q: The time it takes to bake a bread at 120°C is 25 min. The same bread can be baked only in 360 s in…

A:

Q: A sample consisting of 4.00 mol of perfect gas molecules, for which CVm=5R/2, initially at p1=111kPa…

A:

Q: Time (minutes) 0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0 6.5 7.0 7.5 8.0 8.5 9.0 9.5 10.0…

A: A table of time and the volume of oxygen gas for three mixtures at different temperatures are…

Q: Under constant pressure P = 1 atm an ideal gas of 1.5 mol undergoes cooling from 120°C to 30.0°C,…

A: An ideal gas is cooled in an isobaric process.

Q: If moist hydrogen containing 8% water by volume is burnt completely with 34% excess air, calculate…

A: Given that moist hydrogen containing 8% water is burnt entirely with 34% excess air, the reaction is…

Q: Can you show that, for the Dieterici equation of state: P = [RT ∙ e^ (−a / RTVm)] ⁄ (Vm − b) where…

A:

Q: Acetylene (C₂H₂) is utilized as fuel and completely burnt. 1. Write down the fuel's total balanced…

A:

Q: A slurry of mashed dried neem fruits (6.06% oil, balance solids) at 255 kg/h is fed to an extractor…

A:

Q: What is the maximum number of independent balances that may be written around each subsystem?…

A:

Q: What are industries use ammonia?

A: Ammonia is a colorless, odourless and very flammable gas. The most common form of ammonia is…

Q: The feed stream to a distillation column contains 30 % propane, 50 % butane and 20 % pentane. The…

A: Given  Percent of propane in feed = 30% Butane in feed = 50% Pentane in feed  = 20% Overhead product…

Q: Losses by Natural Convection from a Cylinder. A vertical cylinder 76.2 mm in diameter and 121.9 mm…

A:

Q: Boiling Point ("C) 82.0 80.0 78.0 76.0 74.0 72.0 70.0 T T T 0.0 0.20 0.40 0.60 Xisopropanol 0.80 (a)…

A: Student ask for only part E so I answered only part E........

Q: The mixture of solute in cesium chloride solution is crystalized by a simple vacuum crystallizer.…

A:

Q: A mixture of dichloromethane (1) and ethyl acetate (2) and is separated in a flash drum at 1 bar. a)…

A:

Q: As shown in the figure, an exterior wall of a building has an average thermal conductivity of 0.32…

A:

Q: A N2-acetone gas mixture consist of 20% acetone and 80% N2. The mixture is made by bubbling dry N2…

A:

Q: The salinity of Mono Lake in Mono County is about 80 g/l. Assume that all of this salinity is due to…

A:

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: Given that,  The mass flow rate of feed F = 100 kg/h The composition of feed = 0.2 kg of A/kg of…

Q: A 4.00 x 104 M solution of aniline in H₂0 has absorbance A = 0.504 at 280 nm, when measured in a…

A: Given that- Concentration of aniline solution 1= 4.0 x 10-4 M Absorbance of aniline in H2O, A=0.504…

Q: Wet coal is dried in a continuous rotary dryer that operates at atmospheric pressure. The chips with…

A: Introduction  Dryer is used in the drying process to take the water out of a solution, suspension,…

Q: What are homologous structures? Give an example. Is it necessary that homologous structures always…

A:

Q: A stream of humid air enters a condenser in which 95 % of the water vapor in the air is condensed.…

A: Given data are as follows: Flow rate of condensate = 225L/h Entering humid air contains 10mol%…

Q: blood serum sample is analyzed and round to contain ug of the serum is 1053 kg/m³; AW Ca= 40.08.…

A:

Q: A group of students are doing an analysis of copper in 1-peso coin. They were tasked to prepare…

A: Types of errors.... 1. Determinate error – also known as systemic error, causes the mean of a data…