. A three-phase overhead transmission line is being supported by three-disc suspension insulators; the potentials across the first and second insulator from the top are 8 kV and 11 kV respectively. Calcualte (1) the line voltage (11) the ratio of capacitance between pin and earth to self capacitance of each unit (f)

. A three-phase overhead transmission line is being supported by three-disc suspension insulators; the potentials across the first and second insulator from the top are 8 kV and 11 kV respectively. Calcualte (1) the line voltage (11) the ratio of capacitance between pin and earth to self capacitance of each unit (f)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.52P

See similar textbooks

Similar questions

In a string of three identical suspension insulator units supporting transmission line conductor.if the self capacitance of each unit is debited as C farads, The capacitance of each connector pin to ground can be taken as 0.1C farad's. If the maximum permissible voltage per unit is given as 20 kva then calculate A.maximum safe working voltage B.string efficiency
A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV 50-Hz system. The cable common test results show that Ca= 0.15 µF/mi and C= 0.3 µF/mi. can you tell me what the 1. The capacitance of each phase to neutral in μF is 2. The total charging current in (A) 3. Conductor to sheath capacitance in (µF/mi) 4. Conductor to conductor capacitance in (µF) 5. If the first common test was performed on this cable, Ca is (uF/mi)
A single core concentric cable is to be manufactured for a 161kV, 50Hz transmission system. The maximum permissible safe stress is to be 16,000,000V/m (rms) and the relative permittivity, 4. Calculate the following:i) the radius of the conductor ii) the radius of the sheath iii) the capacitance of the cable
A three-conductor belted cable 15 mi long is used as a three-phase underground line for a 69 kV 50-Hz system. The cable common test results show that Ca= 0.15 µF/mi and C= 0.3 µF/mii need 1. The capacitance of each phase to neutral in μF is 2. The total charging current in (A) 3. Conductor to sheath capacitance in (µF/mi) 4. Conductor to conductor capacitance in (µF) 5. If the first common test was performed on this cable, Ca is (uF/mi)
A 3-phase 50 km long single circuit 66 kV transposed overhead line has horizontal spacing with3 m between adjacent-conductors and 6 m between outer conductors. The conductor diameter is2 cm. Find the Inductance per phase. [61.85 mh]
The capacitance per kilometre of a 3-phase belted cable is 0.18 µF between two cores with the third core connected to sheath. Calculate the kVA taken by 20 km long cable when connected to 3-phase. 50 Hz, 3300 V supply.
A 3-phase transmission line is being supported by three-disc insulators. The potentials across top unit (i.e. near to the tower) and middle unit are 8 KV and 11 KV respectively. Calculate: 1) The ratio of capacitance between pin and earth to the self-capacitance of each unit 2) The line voltage 3) String efficiency Subject Power Transmission And Distribution
Discuss why a. Complex power in an AC circuit is more than the DC resistance. b. Receiving end voltage of an unloaded long line may be more than sending end voltage. c. Inductance of the three phase of a transmission line are generally not equal. d. It is necessary to use the geometric means radius in the formula for the inductance calculation whereas the formula for the capacitance calculation uses the actual radius.
A 3-phase overhead transmission line is being supported by three disc insulators. The potentials across top unit and middle unit are 9 kV and 11 kV respectively. Calculate: a. The ratio of capacitance between pin and earth to the self-capacitance of each unit. b. The line voltage. c. String efficiency. JAns: a. 0.22 b. 35.444 kV c. 76%]
3-phase 132 kV, 100 km, 50 Hz, single circuit line has horizontal spacing with 3.5 m betweenadjacent conductors. The conductor diameter is 1.2 cm. Find the line capacitance per phase and__charging current per phase.[0.8415 uF, 20.15 A]
A lightning strikes a 30-m unshielded over-head transmission line tower Which has the following parameters Surge impedance of the tower= 100ohms Surge impedance of lightning channel at tower top =500ohms Tower-footing resistance=10ohms Tower height =30 m Cross-arm height=27m The lightning strike current is assumed to be a constant 30 kA for a duration of 20 µs. The raveling wave propagation speed in the tower is 1.2* 108 m/s. i) Determine the voltage reflection coefficients at tower top and tower foot. ii) Ignoring the phase voltage, determine the insulator voltage after 2µs.
A lightning strikes a 30-m unshielded over-head transmission line tower Which has the following parameters Surge impedance of the tower= 100ohms Surge impedance of lightning channel at tower top =500ohms Tower-footing resistance=10ohms Tower height =30 m Cross-arm height=27m The lightning strike current is assumed to be a constant 30 kA for a duration of 20 µs. The raveling wave propagation speed in the tower is 1.2* 108 m/s. i) Determine the voltage reflection coefficients at tower top and tower foot. ii) Determine the time of travel from tower top to tower foot. iii) Determine the time of travel from cross arm to tower foot. iv) Draw the voltage lattice diagram with proper labels of the time. v) Ignoring the phase voltage, determine the insulator voltage after 2µs. b) The insulator voltage approaches a constant value after 2 µs. If the basic impulse insulation level (BlL) of the insulator for phase conductor is 150 kV, evaluate the condition of the…