A string of insulators in a 132 kV line consists of 5 units. If the value of the mutual capacitance is 10 times the shunt capacitance, find the voltage across each unit, and find the string efficiency.

Q: ■ Calculate the current Ic Ic Vs=10020° -j5 Ohm 8 Ohm j6 Ohm

A: Given circuit,

Q: Simplified output for given Boolean function. f(a, b, c, d) = Em(4, 5, 6, 7, 8, 9, 12)

A:

Q: What justifies the need for plenumrated cabling above the ceiling tile?

A: ANSWER                            There are several reasons why we use…

Q: In a test for a fault to earth on a 600 m length of cable having a resistance of 18 per 1000 m. the…

A: We have an data of the test for a fault to earth with, Length of the cable is 600 m Cable resistance…

Q: Example 15.86. An alternator is supplying a load of 300 kW at a p.f. of 0-6 lagging. If the power…

A: Given, Active power, P1=300 kW Power factor, cosϕ1=0.6 For, Power factor, cosϕ2=1 The extra…

Q: 5.29 A magnetic field propagating in free space is given by H(z, t) = 20.sin(π × 108t+Bz) ax A/m…

A: It is given that: Hz,t=20.sinπ×108t+βzax Am

Q: 1.2.Given a Programmable Logical Array device in Fig. 2. A Inputs R JO Programmable AND Programmank…

A:

Q: 2) Determine the current (Ix) in the following circuits. 20 Ω 80 V 80 V 20 Ω Μ Μ | ν 20 Ω 30 Ω 3 30…

A:

Q: $7. (III) Consider the circuit shown in Fig. 19–71, where all resistors have the same resistance R.…

A: Given- DC voltage source =ε Resistance are same= R Capacitor = C  To find- Current through each…

Q: A 4-pole, 50 Hz, 3-phase induction motor has a rotor resistance/phase of 0.03 ohm and reactance of…

A:

Q: B- For the closed-loop control system of the open-loop transfer function Find the minimum value of K…

A:

Q: A.C. to transmit the same power and for the same loss and the same lamp voltage. Compare the copper…

A: Assuming that the power delivered in the two-wire DC system is P, the resistance per conductor be R1…

Q: What Is the jobs done by registers inside a CPU

A: A register is each of a small set of knowledge-holding locations that are part of a pc processor. A…

Q: Plot the polar plot and mark the crossover frequencies frequencies & margins for the T.F. G(s) = 27…

A:

Q: Due to the advantages of synchronous motor, analyze the application of the synchronous motor for…

A: Due to the fact that both the rotor and stator of a synchronous machine are excited, it is known as…

Q: Assuming ideal op amps, find the voltage gain vo/vi. Show all steps and assumptions clearly. τι; α…

A: Given circuit: Feedback resistance, Rf=100 kΩ Input resistance, Rin=20 kΩ

Q: 2) Determine the current (Ix) in the following circuits. 20 Ω 80 V 80 V 20 Ω α Μ | 20 Ω Μ (30Ω 3 30…

A:

Q: We want to connect a 10 V source with an internal resistance of 1 MΩ to a load of 1 kΩ. Find the…

A: The output voltage closely tracks the input voltage and is hence identical to the input value, it is…

Q: Sketch the single-sided and double-sided spectra of x(t) = 2 sin (10nt - 1)

A:

Q: If resistances of 10ohm, 20ohm, 30ohm are connected in parallel and supplied with 240 volts,…

A:

Q: Implement the following four Boolean expressions with three half adders: D=A⊕B⊕C E=A′BC+AB′C…

A: It is given that: D=A⊕B⊕CE=A'BC+AB'CF=ABC'+A'+B'CG=ABC

Q: A 3-phase, 7 kW induction motor has a p.f. of 0.7 lagging. A bank of capacitors is connected in…

A: We have an 3-Phase induction motor, Motor Input , (p) = 7 KW Power Factor (Cos ϕ1) = 0.7 lag raised…

Q: The voltage signals VA and VB from two sensors need to be conditioned to obtain an output voltage…

A: Given data: Voltage signals from sensor, Va and Vb Expression for output voltage, Vout = A(Va - Vb )…

Q: in +1 Find sensitivity of voltage divider of R2 can be changed. Nominal value of R₁-2002 and R2-100…

A: Given circuit: Vin=10 VR1=200 ΩR2=100 Ω

Q: Ex19; For the circuit below, determine the voltage at the (42) resistor and the power at the (802)…

A:

Q: Ques 2. Two coils connected in parallel across a 100V DC supply, take 10 A current from the supply.…

A:

Q: Hello expert, I need to calculate the values of the resistors inside the schematic in pencil

A: Given:

Q: What are the useful engineering applications of an annual worth approach related to estimating the…

A: The cost estimation of an electrical engineering project or product needs various parameters to be…

Q: a 6-kWh battery has a DoD of 74%, find the maximum amount of energy that can be used befor…

A: Given data, Energy E =6 kWh DoD (Depth of Discharge) = 74%

Q: Consider the series R-L circuit shown in figure below. For obtaining transient free response, switch…

A: Given- R-L circuitR=ωLCircuit is given. To Find- the value of to

Q: The voltage signals VA and VB from two sensors need to be conditioned to obtain an output voltage…

A: Given : Output voltage VOUT=AVA-VB Gain A is between 0 to 100 Find : Circuit used to perform the…

Q: (d) Calculate the output active power, apparent power and the power factor. (e) Suggest how the…

A:

Q: 4- Find the most simple expression for this k_map. You must circle the adjacent cells accordingly. 1…

A: Given K-map,

Q: An office with 30 m * 15 m is illuminated by 40 W fluorescent lamps of lumen output of 2200 lumens.…

A: We have been given an Office area and the given data, Working Area (A) = 30 m * 15 m = 450 m2…

Q: The resistance of a copper wire is 0.742 ohm and length of this wire is 1.56 meter. The diameter of…

A: We have an copper wire with, Resistance of wire = 0.742 Ω Length of this wire = 1.56 m Diameter (d)…

Q: draw k-map for function F1(A,B,C,D) = Σm(3,7,8,9,11,15)  F2(A,B,C,D) = Σm(3,4,5,7,10,14,15) and…

A: The given functions are: F1(A,B,C,D) = Σm(3,7,8,9,11,15) F2(A,B,C,D) = Σm(3,4,5,7,10,14,15)

Q: The product of (3+4j)(1-2j) in polar form is

A: Given, Equation in rectangular form,  F=3+j41-j2

Q: find the complex Fourier expansion of the periodic function shown below - < x < ² 2 2 COS X Cn =…

A:

Q: (a) A flat, circular coil does not actually produce a uniform magnetic field in the area it…

A: Given data: The voltage V=1.50 volt The resistor R=270 Ω The parameter of the circle 90 cm

Q: 7. A first order system has a transfer function of b) e 21 a) 2e-¹/2 1. The unit impulse response…

A:

Q: The BCD equivalent of decimal 88 is O a. 10000010 O b. 10000001 O c. 10001001 O d. 10001000

A: Given, The decimal number is 88.

Q: The voltage across R₁ resistor in the circuit shown below is? 후 _V1 10 R1 50 R2 50

A: Given, The circuit is,

Q: K The range of K for stability of a unity feedback system whose open-loop transfer function is G(s)…

A: Given, Open loop transfer function, Gs=Kss+1s+2 Unity feedback, Hs=1

Q: The color code for a 2.2K Q resistor with 5% : tolerance is O Orange - Orange - Brown -Gold O Red -…

A: The given data is, The resistor is  2.2 kΩ with 5% tolerance.

Q: Q10/Chose the correct answer for the output Q3 of the following circuit ( Assume that A=…

A: Writing the expression from the circuit. S=A+BR=C⊕DT=AD Writing the characteristic equation of Flip…

Q: Consider the following common emitter amplifier: Discuss the LIMITATIONS of this circuit in terms…

A: We need to discuss the limitation of this circuit in terms of linearity and in terms of impedance…

Q: + 100 F un 16+ No is чий + 240kn 360kn Rea

A: Circuit is given as:

Q: The current in Ris I = 20 mA units R₁ 100Ω M R₂ 200 Ω

A: Given circuit,

Q: An ADC having a range of [0, 5] V. i. Determine the number of bits required if the minimum…

A: Given data, Range of ADC is 0 to 5 V, Resolution, Vr=0.61 mV = 0.61×10-3 V

Q: For the voltage-divider bias circuit of Fig. 3.33, determine IRQ ICQ VEQ Vo V₂ V 16 V R wwww of wwww…

A: Given data: A BJT circuit is shown below. Determine IRQ, ICQ, VCEQ, VC, VE, and VB.