Answered: '. An electric current of 15 A is…

'. An electric current of 15 A is flowing through an electric fan. If the potential difference between two terminals of electric fan is 240 V, what will be resistance?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 9.4CYU: Check Your Understanding The current density is proportional to the current and inversely...

See similar textbooks

Related questions

Q: A parachutist whose mass is 65 kg drops from a helicopter hovering 2500 m above the ground and falls...

A: Mass=65kg Length=2500m B1=30N-sec/m

Q: A 40-gram point mass is traveling at a velocity of v = 2.6 m/sec parallel to the x-axis along th...

Q: A medical technician is trying to determine what percentage of a patient's artery is blocked by plaq...

Q: QUESTION 1 "Speedy" the super-tortoise accelerates from a dead stop to 1 m/s in 60 s. What is his av...

A: Given value--- initial speed = 0 m/s. final speed = 1 m/s. time = 60 sec. We have to find--- acce...

Q: Two long straight current-carrying wires run parallel to each other. The current in one of the wires...

Q: A medical saw is rotating at a constant rate of 15 revolutions per second. Convert its rotation to r...

A: Given: Angular velocity (ω) = 15 rev/s Required: Angular velocity in rad/s

Q: 8. Collision between neutrons and nucleus of the moderator results in slowing down the newly born fa...

A: Given that, Initial momentum of neutron is pn Initial energy of neutron is En Final energy of neutro...

Q: 1. A capacitor is composed of 2 plates separated by a sheet of insulating material 2mm thick and of ...

Q: In figure below, determine the output waveform for the sinusoidal input signal with Vm-30V, and Vi=8...

Q: b) When light is incident on an interface between two materials, the angle of the refracted ray depe...

A: According to Fermat's principle, the light travel between two points in the specific path where trav...

Q: medical saW is rotating at a constant rate of 15 revolutions per second. If it has a radius of 12 cm...

A: given: ω=15 rev/sr=12 cm

Q: the illustration below, the beam is 12 meters long and weighs 20N (positioned at its center of mass ...

A: For equilibrium net force as well as net torque acting on the system must be zero and horizontal as ...

Q: (a) What is the average current involved when a truck battery sets in motion 720 C of charge in 4.0...

A: Given that:- 720C charge flow from battery in 4sec.

Q: 1. Convert the following angles to radians. Express answers as fractions of T and as numerical value...

Q: The breaking stress of aluminium is 7.5 x 107 Nm-2. Find the greatest length of aluminium wire that ...

Q: A generator is made from a set of 50 wire loops of radius 40.0 cm that turn in a uniform 0.0900 T ma...

Q: A bakery works out a demand function for its chocolate chip cookies and finds it to be q = D(x) = 95...

Q: 21. A 10.0 uC charge is placed at x =0 m, y =0 m. A second -5.0 uC charge is placed at x =2.0 m, y =...

Q: A series LRC circuit has a 69.2Ω resistor, a 6.7μF capacitor, and a 8.1 mH inductor. The AC source h...

A: Given Resistance of the resistor is R=69.2 Ω Capacitance of the capacitor is C=6.7 μF=6.7×10-6 F Ind...

Q: 4. In a tennis game, a 0.2 kg ball moving at 15 m/s is hit by a racket. After the impact the ball mo...

A: In this question we have to find the time of contact between ball and racket. Please give positive f...

Q: If an electron's position can be measured to an accuracy of 1.93E-8 m, how accurately can its veloci...

Q: 4. A 150-V battery is connected across two parallel metal plates of area 28.5 cm2 and separation 8.2...

Q: A quantity of carbon monoxide gas is slowly compressed adiabatically in an insulated container to on...

A: Given : P 1= 2 ×10⁵ Pa, γ=1.3

Q: In the illustration below, the beam is 12 meters long and weighs 20 N (positioned at its center of m...

Q: Suppose you have q=11µC charge placed at the origin of your coordinate system. a) Using Gauss's law,...

Q: A resistance of 25 Q is connected to a 12 V battery. Calculate the heat energy in joules generated p...

A: Given data : Resistance = R Voltage = V ...

Q: a hydraulic piston with a face area of 2E-4m^2 is paired with another, larger, hydraulic piston. if ...

Q: 2 ЗР 3 P 1 4 V 4v V 33. An ideal gas is taken through a closed path 12-3→4-1. What is the net work d...

A: Answer:- (A) 6 PV Given Change in pressure (∆P) = (3P - P) = 2P Change in volume (∆V) = (4V - V) =...

Q: A woman swims the length of a 120-m pool and back again (one lap) in 90 s with a constant speed. 1....

A: Given data: Woman swims the length of pool and back again (one lap) Length of pool = 120 m Required...

Q: Good day, Maam/Sir. I hope you can help me to my study. Thank you!! Topic: Sound and Hearing Probl...

Q: Suppose that a typical power plant produces about 10 billion kilowatt-hours (kWh) per year. To produ...

A: A typical power plant produces about 10 billion kWh per year. 1 billion = 109

Q: A 0.5 kg mass is projected up a long 25° inclined plane with an initial speed of 4.5 m/sec. The bloc...

Q: A medical saw is rotating at a constant rate of 15 revolutions per second. Calculate its angular spe...

A: Given value--- angular speed = 15 revolution per sec. We have to find--- angular speed in rad per...

Q: Under what conditions of volume does a van der Waals gas behave like an ideal gas? Use the van der W...

A: Question Under what conditions of volume does a van der Waals gas behave like an ideal gas?

Q: 7. The electrons in the hydrogen atom are at the activation energy level 1. 7.1 Find the total energ...

Q: Part A A metal rod is 40.123 cm long at 20.5° C and 40.146 cm long at 45.2° C. Calculate the average...

Q: A lamina (flat plate) bounded by y = x , y = 0, and x = 27 with uniform density p = 8. b) Find the e...

Q: A parallel plate capacitor has plates of area 5.4 cm2, separated by a distance 5.1 mm and a dielectr...

Q: 1. Why independent KVL and KCL equations used? What happens if dependent equations are used? 2. Anal...

A: KCL and KVL equations are used to solve the circuit.With the help of these equations voltage and cur...

Q: 2) In a thermonuclear device, the pressure of 0.050 liters of gas within the bomb casing reaches 4.0...

Q: Suppose that a typical power plant produces about 10 billion kilowatt-hours (kWh) per year. To produ...

A: the power pwoduced by a power plant is 10 billion kWh per year. 1 billion = 109

Q: A 200 g B 6.0 N 400 g W600 g Lower magnet Open FIGURE P7.26 FIGURE P7.27 27. || FIGURE P7.27 shows a...

Q: Two resistors dissipate the same amount of power. The potential drop across resistor A is four times...

Q: the following equation refers to V-pendulum experiment T4 = (4x* Lki g?(8 n*L/g? d, where : %3D L: l...

A: Given Data

Q: 6. A long straight wire lies along the x axis carries a current of 15 amps in the positive x directi...

A: Given, A straight wire lies along the x-axis carries a current, I1 = 15 amp second wire carrying cur...

Q: Free Response problems 1. 2 moles of a monatomic ideal gas is placed under a piston in a cylindrical...

Q: in Compton scattering A 1.20 nm wavelength X-ray is fired at the target and scattered at an angle of...

Q: A ball is dropped on a floor from a height of 2.0 m. After the collision, it rises up to a height of...

Q: A solenoid is made of 500 turns of wire, length = 12 cm, radius = 3 cm, and carries a current of 15 ...

A: Given No of turns, N = 500 Length ,L = 12 cm Radius , R = 3 cm Current ,I = 15 Amp

Q: Object A, sliding on a frictionless surface at 3.2 m/s, hits a 2 kg object B which is at rest. The c...

A: In all collision momentum remains conserved Momentum before collision = momentum after collision In ...

Question

'. An electric current of 15 A is flowing
through an electric fan. If the potential difference
between two terminals of electric fan is 240 V, what will
be resistance?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A short circuit in a 120-V appliance cord has a0.500- resistance. Calculate the temperature rise of the2.00 g of surrounding materials, assuming their specific heat capacity is 0.200cal/gC and that it takes 0.0500 sfor a circuit breaker to interrupt the current. Is this likely to be damaging?
Check Your Understanding The current density is proportional to the current and inversely proportional to the area. If the current density in a conducting wire increases, what would happen to the drift velocity of the charges in the wire?
Can a wire carry a current and still be neutral-that is, have a total charge of zero? Explain.
A 0.50-W, 220- resistor carries the maximumcurrent possible without damaging the resistor. If the current were reduced to half the value, what would be the power consumed?
The emf of a battery is E = 12 V . When thebattery delivers a current of 1 A to a load, thepotential difference between the terminals ofthe battery is 10 V volts.Find the internal resistance of the battery.Answer in units of Ω.
Unreasonable ResultsTwo resistors, one having a resistance of 145 Ω , are connected in parallel to produce a total resistance of 150 Ω. What is the value of the second resistance?
What could happen to the drift velocity of the electrons in awire and to the current in the wire if the electrons could movethrough it freely without resistance?
Can a copper wire and an aluminum wire of the samelength have the same resistance? Explain
The quantity of charge through a conductor is modeled as: q(t)=at4+bt+c --> I(t) = 4 a t^3 + b If a = 5.02C/s4, and b = -4.36C/s, and c = 1.75μC, then what is the current, in amperes, at t=1.45s?
A certain electronic device needs to be protected againstsudden surges in current. In particular, after the power isturned on, the current should rise no more than 7.5 mA inthe first The device has resistance and isdesigned to operate at 55 mA. How would you protect thisdevice?
Is it possible to connect a group of resistors of value R in such a waythat the equivalent resistance is less than R? If so, give a specificexample
Assuming 95.0% efficiency for the conversion of electrical power by the motor, what current must the 12.0-V batteries of a 750-kg electric car be able to supply: To accelerate from rest to 25.0 m/s in 1.00 min?