What is the resistivity of tin if the cube of it 10 cm along each edge has a resistance of 1.15 ohms across opposite faces? ameter twice as great and a length six times as great.Find the resistance of the second wire. Ans. 37.5 N.17. What is the resistivity of tin if the cube of it 10 cm along each edge has aresistance of 1.15 µN across opposite faces? Ans. 11.5 x 10 N-m18) What ic th o Jangtt

Resistance R = Resistivity (ρ)×Length (L)Area (A) For cube , length is equal side . and area is…

Answered: .17. What is the resistivity of tin if…

.17. What is the resistivity of tin if the cube of it 10 cm along each edge has a resistance of 1.15 un across opposite faces? Ans. 11.5 x 10 N-m 18 What in th o lantl

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2P: The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where...

See similar textbooks

Related questions

Q: report about 4bit full adder Зрадes 9:55 PM

A: Full Adder circuit: A full adder circuit is the kind of digital circuits that used for addition. It…

Q: The resistance of a copper wire is (0.92 0) at a temperature of (4 oC). At what temperature will be…

A: Resistance of copper wire R= 0.92 ohm at 4°C Which temperature resistance become Resistance R= 1.06…

Q: ance of a certain wire is 0.5S. Another wire of the same material and at the sam has a diameter…

Q: Fill in the blank The resistance of a wire is 126.48 ohms at 1000C and 100 ohms at 300C. The…

Q: The value of resistance in insulators is a. can not be determined b. zero c. large d. small

A: Insulator opposes current .

Q: Find the Reluctance of a ring iron with relative permeability 1500(μr) the radius of the ring 0.1 m…

Q: Q6/ a- Find the conductivity and resistivity of intrinsic Ge at 300K. b- If n-type impurity is added…

Q: 4) Solue for the pauer delivered to the 1on oifr in the clf.chaa). ensq 12 easei (1. even +2V eldi

Q: Figure Q1(a) shows a circuit using germanium and silicon diode. Based on the figure calculate the…

A: Explanation: The forward voltage of silicon diode is 0.7 volt and the forward voltage of germanium…

Q: A 200 ft copper bronze alloy has a resistance of 1.46 ohms at 20∘C and a diameter of 0.0508 in.…

A: Given: Length of alloy, l=200 ft Resistance, R=1.46 Ω at 20o C. Diameter, d=0.0508 in

Q: Measuring the Hall coefficient allows to determine which of the following? a) temperature…

A: Based on polarity of produced hall voltage we can tell about type of semiconductor ( n type or p…

Q: In a string of suspension insulator with three units,the line unit has 15kV and k=0.25. The voltage…

Q: 8. are electrons at the outer shell. a) Inside shell electrons b) Conductor electrons c) Outside…

Q: Q18. For a lead acid battery, you can often use the Peukert prediction to assess the capacity it can…

A: The time taken to discharge the battery is calculated using the expression as shown below:…

Q: determine the resistance between the ends of this bar 270 m in length and 150 mm by 6 mm in…

A: In this question we need to find a resistance of a bar .

Q: 1.16 An arbitrarily shaped van der Pauw sample of thickness = 500 um was measured. The measured…

A: Given information: t=500 μm=500×10-6 m. R12,34=74 Ω. R23,41=6 Ω.

Q: Ques 1(a). A copper wire has a resistance of 0.850 at 20°C. What will be its resistance at 4 The…

A: In this question we will find copper wire resistance at given temperature.....

Q: Determine Rb1 and Vbb for a silicon PUT if it is determined that h = 0.65, Vp = 20.5 Volts and Rb2 =…

A: According to the question we have to calculate the value of Rb1 and Vbb.

Q: Each of three insulators forming a string has self-capacitance of "C" farad. each cap of insulator…

Q: The resistance of tunsgten filament at 1750c° is 4ohm. Find the resistance of the filament at…

A: It is given that: T1=1750°C=1750+273=2023 KR1750=4 ΩT2=20°C=20+273=293 Kα=6×10-3 /K

Q: IV analyzer-XIV1 Components: Diode D2 Current range (A) Log Lin IN4001GP F: 1.258 kA I: -114.398 A…

A: Analyzer- A device which is used to analyze the data and to show the values on screen.

Q: 4.If the resistance of a copper wire at freezing (0°C) is 30 2, what is its resistance at -40°C?

A: It is given that: R1=30 ΩT1=0°CT2=-40°C

Q: Find Vout 10 ohms SVMM 100 ohms + • Vout

Q: [11] Insulators have - valence electrons. two three O four

Q: many milllamperes of TIOw througn a circu With a 40 source and 6.8 kQ of resistance? *

Q: The effect of a jump up in temperature is. to increase the resistance of alloys. ( All the above. to…

A: Jump up in temperature menas suddenly raised. As the temperature increases the resistance of the…

Q: What will be the voltage across the string in a suspension type insulator if the no of discs is 6…

Q: The value of resistance in insulators is O a. small O b. large O c. can not be determined O d. zero

A: The electrons in the insulator's atoms are strongly bonded and cannot travel easily. Other…

Q: Resistance of 800 has a conductance of O 125 millisiemens O 1.25 millisiemens 12.5 millisiemens…

A: Given data, Resistance (R) = 800 ohms The units of conductance is siemens. Conductance(G) is the…

Q: A resistor has a resistance of 43.6 ohm at 20°C and 50.8 ohm at 60°C. Determine the temperature…

A: Resistance at any temperature R =R0(1+( temperature coefficient of resistance )*temperature R0 is…

Q: A barium titanate crystal has a thickness of 2 mm. Its voltage sensitivity is 12*10-3 Vm/N. It is…

A: Given, A barium titanate crystal having, Thickness, t= 2 mm Voltage sensitivity, g= 12×10-3 Vm/N…

Q: B\ Assume D1 and D2 are Si diodes. Find ID1, ID2, VD1, VD2 and IO in the circuit below the practical…

A: ID1, ID2, VD1, and VD2 is determined as shown below

Q: Determine the current 1, 12. 13 in mA and the voltage across R1 for the network shown in the figure…

A: The diode is a silicon diode. And forward voltage drop of silicon diode is 0.7 V. Applying KVL in…

Q: Use the concept of equivalent resistance to determine the unknown resistance of the identified…

A: In this we will find equivalent resistance. ..

Q: Resistance of 800 Q has a conductance of O 125 millisiemens O 1.25 millisiemens O 12.5 millisiemens…

A: The explanation is as follows.

Q: A cube of an alloy of resistivity is 2.12un-m is 3x10^-2 m on a side. Determine the resistance…

A: In this question we need to find a resistance between two faces of the cube.

Q: Calculate the eguivalent resistance between A and B ww Sohm 10ohm

A: For series connection, the equivalent resistance will be: Req=R1+R2 For parallel connection, the…

Q: What is the resistance of gold (α = 0.003715/°C) at 65°C, if its resistance at 20°C is 25 kΩ?

Q: For the network shown in Figure B22 , assume E = 12V, Diode Di as silicon and D2 Germanium, R1=1.5KN…

Q: In a string of suspension insulator with three units,the line unit has 12KV and k=0.15. The voltage…

Q: 2) What doping of Phosphorus (n-type) do you need to make an 1206 resistor have a resistance of 1200…

Q: Find the upper limit (in ohms)for the :give color code Grey Blue Red Gold اخترأحد الخيارات a. 9.030K…

A: Given: Color code is Grey Blue Red Gold. Note- First color - first digit Second color - Second…

Q: What is its temperature coefficient of resistance at 30 oC?

A: Resisitivity of silver ρ20 is 1.59x10-8 at 20o and temperature coefficient of silver…

Q: Question 10 Find the resistance in micro-ohms at 20 °C of an annealed copper bus bar 4.8 m in.…

A: Given, Wire length, l = 4.8 m Area, A=0.4 cm×3.6 cm=1.44 cm2 Resistivity, ρ=1.72×10-8 Ωm

Q: 2- Determine whether or not the following equalities are correct: (a) A B.C+A B.C = A (b) A +B-A C =…

A: This question belongs to digital electronics. It is based on the concept of laws of Boolean's…

Q: The resistivity of a ferric-chromium-aluminum alloy is 51x10 ohm-meter. A sheet of the material is…

Q: (vehlmin) 100 1 milelmi 50 Ko = 100 200 Kj= ? %3D

A: Kj can be find by using slope Since the slope between k = 100 to Kj is same as slope between 100 to…

Q: What is 10nm SuperFin All About

A: 10nm SuperFin is 10mm semiconductor wafer technology developed by the intel. As the size is very…

Question

What is the resistivity of tin if the cube of it 10 cm along each edge has a resistance of 1.15 ohms across opposite faces?

ameter twice as great and a length six times as great.
Find the resistance of the second wire. Ans. 37.5 N
.17. What is the resistivity of tin if the cube of it 10 cm along each edge has a
resistance of 1.15 µN across opposite faces? Ans. 11.5 x 10 N-m
18) What ic th o Jangtt

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where R1 and R2 are the resistances at temperatures T1 and T2, respectively, and is known as the temperature coefficient of resistance. If a copper wire has a resistance of 55 at 20C, find the maximum permissible operating temperature of the wire if its resistance is to increase by at most 20. Take the temperature coefficient at 20C to be =0.00382.
You are working as an electrician in a large steel manufacturing plant, and you are in the process of doing preventive maintenance on a large DC generator. You have megged both the series and shunt field windings and found that each has over 10 M to ground. Your ohmmeter, however, indicates a resistance of 1.5 across terminals S1andS2. The ohmmeter indicates a resistance of 225 between terminals F1andF2. Are these readings normal for this type machine, or is there a likely problem? Explain your answer.
What is the advantage of a metal film resistor over a carbon resistor?
Determine the thermal coefficient of resistance of copper at 500C, then use this value todetermine the resistance of copper wire at 1700F if the resistance of this copper wire at 500C is50 Ω. The thermal coefficient of resistance of copper at 00C is 0.004264/C0 .
A. What is the area in circular mils of a copper wire that has a resistance of 2.5 ohms and is 300ft long (T = 20°C)?b. Show your solution, determine whether the area of an aluminum wire will be smaller or largerthan that of the copper wire using the same resistance and length state in letter A. Explain
The resistivity of a commercial quality of copper conductor is 0.686 µΩ-in at 20°C. Determine the cross section in square inch and resistan ce at 20°C of 121 Ibs. of this copper when the length is 600 ft. The weightper cubic inch of copper is 0.321 Ibs.
A piece of silver wire has a resistance of 1 ohm. Determine the resistance of alead wire one-third the length and one-third the diameter if the resistivity of lead wire is 30 times that of silver. NOTE: Please explain where did you get the variables so I can understand them. Thank you
Of what material is a wire made, if it is 25.0 m long with a 0.100 mm diameter and has a resistance of 77.7Ω77.7Ω at 20.0∘C20.0∘C ? (b) What is its resistance at 150∘C150∘C?
Nichrome ribbon resistor elements each has a resistance of 1 ohm. The element is made from sheet of nichrome alloy, 0.025 cm think. If the width of the ribbon is 0.3cm, what length is required per element in cm? Assume specific resistance of nichrome alloy to be 109microOhm-cm.
A wire with a length of 200 meters has a diameter of 0.052 cm is drawn so that its new diameter is 0.041 cm. What is its resistance before and after it was drawn if the conductivity of the wire is 1.724 µ Ω-cm at 20 °C.
A. What is the area in circular mills of an aluminum conductor that is 80 ft long with a resistance of 2.5? B.What is its diameter in inches?
The diameter of a given bare conductor is 0.50 inches. Thermoplastic insulation with a thickness of 0.1 inches is wrapped around to insulate the conductor. Determine the insulation resistance of this conductor per meter. Assume specific resistance of thermoplastic insulation to be 2 x 10^14 ohm-cm.