0.3m 25mm 6m 6m Phase A Phase B Phase C
Q: Given the Figure 3 as shown below, determine: R a) Draw the Phasor diagram in terms of: 250 2 1.…
A:
Q: write the ontpul wavefarm of the given IGBT based single - phase systen! Ib Lo 1eattery Co Vo K2
A:
Q: 24 - Which is marked with PE A) Phase B) Neutral C) Positive D) Ground E) Negative
A: In power systems, marking of the conductors is very important to avoid mismatch. Because during…
Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per…
A: Given data : distance D=25 feet
Q: f the AC load is inductive then the current is _________ the voltage Select one: A. In the same…
A: In practical scenario where, alternating voltage generated is of sinusoidal nature and is given by…
Q: Calculate the phasor currents I and Iz in the circuit -j42 12/0° V js a3 E J62 (1, 122
A:
Q: For the following waveforms: i = 2 sin(wt – 60°) v =-50sin(wt + 30°) The relationship between the…
A: Given : Current waveform i=2 sin(wt -60°) Voltage waveform v=-50sin(wt +30°) In the voltage…
Q: A voltage of 2500 is applied to an inductive circuit of impedance (5+j10)Q Determine circuit current…
A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…
Q: 7. Three sinusoidal voltage source of three phase generator have a. Inverse frequencies b. Random…
A:
Q: tion 1: what is the phase relationship between the sinusoidal waveforms of each of the following…
A: Brief description: For the above given current and voltage sinusoidal signals we need to justify…
Q: Delermine (a) peak value, (b) radian frequency, (c) cyclic frequency, and (d) period. 2-2 Acurrent…
A:
Q: Inductive reactance results in a current that lags the voltage by n/2 rad leads the voltage by n /2…
A:
Q: Q1: Draw the waveforms at the numbered points in the proper relationship to each other: %23 A B C D…
A: consider the given question;
Q: 013: Choose the correct answer: 1. In a symmetrical three phase system the total instantaneous three…
A: The solution is given below
Q: Let v1 = a + jb and v2 = c +jd, then v1 + v2 = (a+c) +j(b+d) only if a) v1 and v2 have the same…
A: Given v1=a+jb, v2=c+jd then v1+v2=(a+c)+j(b+d) this thing will happen when v1 and v2 have same…
Q: QUESTION I DIRECTIONS: Draw the following sinusoidal waveforms: 1. e = 220 sin ( wt - 50°) 2. į = 15…
A:
Q: If one of the voltage waveforms has a delayed phase of 31.2 degrees from the origin and the other…
A: In a group of voltage waveforms, if one voltage is said to be delayed with respect to origin if the…
Q: Problem 49: Find the rms value of the following sinusoidal waveforms: a. v = 120 sin (377t + 60°) b.…
A: The RMS value of a Sinusoidal waveform can be calculated by dividing its Peak value by √2.
Q: Referring to figure 3, determine the rms voltage at j5N reactance (inductor) using KVL(Answer must…
A:
Q: d the sum of the voltages and its phase angle and the angle difference of e1=-12 cos wt + 50oV and…
A: Given data: e1=-12 cos( wt + 500)Ve2=15( sin wt - 100)V
Q: 9) In wave winding the number of parallel path A=2. Select one: True False
A: We know that the number of parallel paths in the in a wave winding is equal to 2. So, armature…
Q: lof runs on a 50HZ per phase are 0.12 que at 4 % slip (ii) .m, 1333r.p.m]
A: It is given that: P=4f=50HzR2=0.1ΩX2=0.9Ωk=0.67s=4%s=0.04VL=200 V
Q: A sinlge phase load consist of a coil
A: Given- Resistance= 10 ohm Inductance= 100 mH Voltage supply= 150 V (50 Hz Ac supply)
Q: Ohmic components have a V-I curve O Non-linear VI curve. O Parabolic VI curve. O Sinusoidal VI…
A: Ohmic components obey Ohm's law. As per Ohm's law, the current flowing through a ohmic component is…
Q: In a resistive load, the current angle: Leads the voltage by 90. In phase with the voltage angle.…
A: In this answer let us try to explain how the current angle and the voltage angle are oriented with…
Q: The unit for three phase apparent power is Select one: O a. KW O b. V O C. KVA O d. KVAR
A: The apparent power is defined as the combination of the reactive power and the true power and is…
Q: "If Ibc is equal to 646.0552109 and la is 373angle;19, the phase sequence is:" O POSITIVE O NEGATIVE
A: We need to find sequence of given system
Q: A resistive and a capacitive load of equal magnitude is connected in series, determine the phase…
A: The phase difference of the circuit will be dependent on the reactance of the circuit.
Q: 1 TF(s) = s' + 3s? + 5s + 5 What is the phase share of the system in the figure?
A:
Q: "If lab is equal to 595.8252306 and lb is 344296, the phase sequence is:" O POSITIVE NEGATIVE
A: In this question we need to choose a correct option.
Q: 1. Find the phase relationship between the following waveforms: a) v = 2 cos(wt - 30), i = 5 sin(wt…
A: As per Bartleby policy we can answer only one ques at a time. To calculate phase relationship…
Q: If the voltage and current are out of phase by 90 degrees, the average power is (c) minimum (a) V2VI…
A:
Q: 10. Draw the phasor diagram of the 2 succeeding currents if it is out of phase by 90o
A: In the above given question we need to draw the phasor diagram for the given current sources with…
Q: 25. Transform each of the following into phasor form: (a) 75.928 cos (110.1t); (b) 5 cos (55t –…
A:
Q: Determine the current Ih and Iz
A:
Q: 14.54 Express the following phasor currents and voltages as sine waves if the frequency is 60 Hz: a)…
A:
Q: R = 115 ohms XL = 26 ohms Xc = 51 ohms f = 268 Hz E sine Y m C m
A:
Q: "If Ibc is equal to 663.3752106 and la is 383angle;16,the phase sequence is:" O POSITIVE O NEGATIVE
A: Phase sequence is a order in which phase voltage are placed in a three phase network.
Q: Let v1 = a + jb and v2 = c +jd, then v1 + v2 = (a+c) +j(b+d) only if Oa) v1 and v2 phasors are…
A: Let V1 is the response of the signal with w1 frequency. And V2 is the response of the signal with w2…
Q: indicate whether the element is capacitive, inductive, or resistive v = 20 cos(250t+60°); i= -5…
A:
Q: During the day, the air above the land heats up more _______ than air over water. a. Moderatly b.…
A: In this question , we have to find out the air above the land and air over water...
Q: Find the phase relationship between the following waveforms: v(t) = 2cos(wt-30°) i(t) = 5sin(ot+60°)
A: Given: The voltage and current waveform is: vt=2cosωt-30°it=5sinωt+60°
Q: 3. Three circuits A, B and C are connected in series across 350 V supply. The voltage across circuit…
A:
Q: In a resistive load, the current angle: Between 90 and -90. In phase with the voltage angle. o Leads…
A:
Q: wt V and i i. = 10 cos at A || whe
A:
Q: What is the in phase component of 3*rect(t/10)*cos(300*pi*t + pi/2)?
A:
Q: 1. A phase difference of 900 degrees would more often be spoken of as choices: a. out of phase by…
A: 1) 900 degrees= 720 + 180 = 2x360 + 180 For 3600 one revolution gets…
Q: All of the following are correct definitions except The voltage lags the current in a capacitive…
A:
Q: In the oscillating column type wave power energy conversion method the following fluid is used as a…
A: Correct option is b) air In the oscillating column type of wave power energy conversion method air…
Step by step
Solved in 2 steps with 2 images
- Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz given the conductors to be Partridge and the spacing between centers to be 30 ft.If the per-phase line loss in a 70-km-long transmission line is not to exceed 65 kW while it is delivering 100 A per phase, compute the required conductor diameter if the resistivity of the conductor material is 1.72108-m.A 60-Hz, single-phase two-wire overhead line has solid cylindrical copper conductors with a 1.5 cm diameter. The conductors are arranged in a horizontal configuration with 0.5 m spacing. Calculate in mH/km (a) the inductance of each conductor due to internal flux linkages only, (b) the inductance of each conductor due to both internal and external flux linkages, and (c) the total inductance of the line.
- In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-halfCalculate the inductive reactance in /km of a bundled 500-kV, 60-Hz, three-phase completely transposed overhead line having three ACSR 1 113 kcmil conductors per bundle, with 0.5 m between conductors in the bundle. The horizontal phase spacings between bundle centers are 10, 10, and 20 m.Find the GMR of a stranded conductor consisting of six outer strands surrounding and touching one central strand, all strands having the same radius r.
- A 60-Hz, three-phase three-wire overhead line has solid cylindrical conductors arranged in the form of an equilateral triangle with 4-ft conductor spacing. The conductor diameter is 0.5 in. Calculate the positive-sequence inductance in Wm and the positive-sequence inductive reactance in /km.A 60-Hz, 765-kV, three-phase overhead transmission line has four ACSR 900 kcmil 54/3 conductors per phase. Determine the 60 Hz resistance of this line in ohms per kilometer per phase at 50C.Calculate the capacitance-to-neutral in F/m and the admittance-to-neutral in S/km for the three-phase line in Problem 4.18. Also calculate the line-charging current in kA/phase if the line is 110 km in length and is operated at 230 kV. Neglect the effect of the earth plane.
- A three-phase overhead transmission line is designed to deliver 190.5 M VA at 220 kV over a distance of 63 km, such that the total transmission line loss is not to exceed 2.5 of the rated line MVA. Given the resistivity of the conductor material to be 2.84108-m, determine the required conductor diameter and the conductor size in circular mils. Neglect power losses due to insulator leakage currents and corona.For a single-phase, two-wire line consisting of two solid cylindrical conductors of same radius, r, the total circuit inductance, also called loop inductance, is given by (in H/m) 2107ln(Dr) 4107ln(Dr) where r=e14r=0.778rFor a three-phase three-wire line consisting of three solid cylindrical conductors each with radius r and with equal phase spacing D between any two conductors, the inductance in H/m per phase is given by 2107ln(Dr)4107ln(Dr)6107ln(Dr) where r=e14r=0.778r