Answered: 02. The homogeneous 40-kg basr ABC is…

02. The homogeneous 40-kg basr ABC is held by a horizontal rope attached to end C. Neglecting friction, determine the tension in the rope. 1.25 m 2 m B A. 30°

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.75P: The end of a water hose weighing 0.5 lb/ft is pulled with a 40-lb force that is inclined at 14 to...

See similar textbooks

Related questions

Q: 2500 N -200 N. 4000 N

Q: Q5/ Three cables are joined at the junction ring C. Determine the tensions in cables AC and BC…

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: 7. The homogeneous 5z.x-kg bar ABC is held in position by a horizontal rope attached to end C.…

A: Given- Considering the weight of the rope as 50kg ×9.81 = 490.5N Length AC = 3.25m Length AB= 2m…

Q: 3. Determine the force in each member of the truss shown. State whether each member is in tension or…

Q: Q22/A three-legged stool is subjected to the load L as shown. determine the vertical force reaction…

Q: The 6-m pole ABC is acted upon by a force P as shown. The pole is held by a ball-and-socket joint at…

A: The Answer is below

Q: I(a). b) Two cables are tied together at C and loaded as shown Fig. I1(b). Determine the range of…

Q: 7. The 50 lb square plate shown is supported by three vertical wires. Determine the tension in each…

Q: Three wires are connected at point D, which is located 18 in. below the T-shaped pipe support ABC.…

Q: 4. Three cables are joined at the junction ring C. Determine the tensions in cables AC and BC caused…

Q: carpenter holds a 1/-lb 2-in. by 4-in. board as shown. If he exerts ver

A: GIVEN:weight of bar 17lbdimension=2in by 4in

Q: The 40-kg homogeneous plate is suspended from four wires. Determine the tension in each wire.

A: Given data: Homogenous plate of mass 40kg To find Tension in cables TA=? TB=?…

Q: The crane BC shown below lifts a load of W. Neglecting the weight of the crane. Determine the…

Q: Q6/ Three cables are joined at the junction ring C. Determine the tensions in cables AC 45 and BC…

A: Given Data Weight of cylinder is : m=30 kg Now W=mgW=30×9.81W=294.3 N Now from the equilibrium…

Q: The crane BC shown below lifts a load of W. Neglecting the weight of the crane. Determine the…

Q: If the weight of cylinder A is 300N, determine the weight of cylinder C in orde. to hold the…

Q: A |C 70°/ A 50 kg load is lifted by the pulley system shown. Determine the tension in the cable ABC…

Q: Three cables are joined at the junction ring C. Determine the tension in cables AC and BC caused by…

A: Since you have asked multiple questions in a single request, we would be answering only the first…

Q: In the assembly shown, sags of s and 1.5 s resulted when the two cylinders were suspended from the…

A: Given: s=0.8879

Q: The 20 × 20-in. square plate shown weighs 56 lb and is supported by three vertical wires. Determine…

A: Given data To determine the weight and location of the lightest block that should be placed on the…

Q: The frame is supported by a pin at A and a cable (BC). Determine the tension developed in Cable (BC)…

Q: Y pies FD Fs D X 0,6 m FA W

Q: B 50° 40° |A m Determine the mass, m, of the box hanged by three cables if the magnitude of the…

A: Given: Tension in cable AB is 1kN or 1000N

Q: Three cables are joined at the junction ring C. Determine the tensions in cables AC and BC caused by…

Q: Determine the tensions in cables AB, AC, and AD. 1.65 m 2.35 m

Q: :Three cables are joined at the junction ring C. Determine the tensions in cable AC and BC caused by…

Q: Determine the magnitude of the force in member EF (Ib) of the Pratt bridge truss shown if h = 12.4…

Q: Determine the magnitude of the force in member EF (Ib) of the Pratt bridge truss shown if h 10.6 ft…

Q: Three cables are joined at the junction ring C. Determine the tensions in cables AC and BC caused by…

Q: Q3 Determine the force acting along the axis of each of the three struts needed to support the…

Q: Q.1) Draw Free-Body diagrams of each of the three cylinders shown below. Each of the cylinders has a…

A: For the given arrangement Weight of cylinder (W) = 400 lb The radius of the cylinder (R) = 15…

Q: Stiller Düzenlem Üst 2) A uniform brass plate with area of 18 x 18 m? has mass of 41 kg which is…

Q: , hinged at A and D and pinned at B and C as sho a. Determine the value of P that will prevent…

Q: Assuming the pulley system below is weightless and frictionless, determine the distance (d2) when a…

Q: The uniform 18kg Bar OA is held in the position shown by a smooth pin at O, and the cable AB which…

A: Given Data→ uniform mass of OA bar (m)=18 kgassume g=9.8ms2according to the question we have to…

Q: The bar shown is in equilibrium determine the forces P, T and R

A: Given Load in the system To find Magnitude of P, T and R

Q: distance x at which the load W can be supported. Neglect the weight of the bracket.

A: x=12in

Q: 01: Determine the forces and state if its tension or compression in members AB, AH, BH, BG, BC and…

Q: are joined at the junction ring C. Determine the tensions in cables AC and BC caused by the weight…

Q: The 1200-lb weight is suspended from a cable that runs over a small pulley attached to the boom ABC.…

A: Given data, Coordinates of A = (12, 0, 0) ft Coordinates of B = (6, 0, 0) ft Coordinates of C = (0,…

Q: Q3 Determine the force acting along the axis of each of the three struts needed to support the…

Q: Two cables are tied together at Cand loaded as shown. Draw the free-body diagram needed to determine…

A: Given data as per question Mass of the block = 1600 kg considering Free body Diagram of the system…

Q: The rectangular plate shown weighs 80 lb and is supported by three vertical wires. Determine the…

A: Free Body Diagram

Q: If point A is in equilibrium under the action of the applied forces, the values of tensions TAB and…

A: For equilibrium about point A, sum of forces in horizontal direction should be zero. ∴ TAC cos 30 -…

Q: A pole is braced by a guy wire that exerts a force of 250-lb pull on the top of the pole, as shown.…

Q: Please draw the FBD and solve. Three cables are joined at the junction ring C. Determine the…

A: Solution: Given Data: m = 30 kg

Q: determine the magnitude of force P(N). Round off only on the final answer expressed in 3 decimal…

A: Coordinate of the points are: A = (0,0,0) B = (0,3,0) C = (0,6,0) D = (1.5,0,-3) E = (1.5,0,3) F =…

Concept explainers

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.

Question

Solve the following with a free body diagram.

02.
The homogeneous 40-kg basr ABC is held by a horizontal rope attached to end C. Neglecting friction, determine
the tension in the rope.
1.25 m
2 m
B
A
30°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The end of a water hose weighing 0.5 lb/ft is pulled with a 40-lb force that is inclined at 14 to the horizontal. Determine the length s of the hose that is lifted off the ground and the corresponding horizontal distance L.
A person weighs 30 lb on the moon, where g=5.32ft/s2. Determine (a) the mass of the person; and (b) the weight of the person on earth.
1. Samer (ms = 75 kg) is sitting on the seat of a swing at the playground. The seat is supported by two cables, one on each side of the seat. (You may assume the seat has negligible mass.) A. Determine the tension in each cable due to Samer sitting on the swing seat. B. Given each cable has a diameter of 1 mm and each cable is exactly 5 m long before Samer sits on the seat, determine the length of each cable when Samer is sitting on the seat. (The cables are made of Aluminum for which Y = 70 GN/m°.) show all work in logical, detailed form and box in numerical answers. Include a diagram wherever possible. On any problem where an FBD is appropriate, it must be included for maximum credit. All numerical results should be stated to 3.00 or 4.000 significant figures and in mks units unless otherwise noted.
1. If the mass of cylinder CC is 50 kg, determine the mass of cylinder AA in order to hold the assembly in the position shown 2. If an astronaut has a mass of 180 LBM on earth, what is the weight of this astronaut on the moon, where g=5.32 ft/s2?
Find the tension of AB, BC, and BD in pounds.
Determine the weight W, in U.S. Customary units,of an 85-kg steel bar under standard conditions (sea levelat a latitude of 45 degrees).
Show complete solutions and figures The diameters of the two cylinders A and B in the figure shown are 80 mm and 750 mm, respectively. The face of the piston is 1.2 m above the face of the weight platform. The space in between the piston and the weight is filled with oil (s.g.=0.80). If F=75 N, Determine the following: the value of Wrequired to maintain equilibrium. a) 38.6 N b) 86.3 N c) 63.8N d) 83.6 N e) None
A 15 kg block of wood displaces 6 kg of water when submerged in water. Bobuoyant force acting on the block of wood is?( use g =9.8m/s^2) A. 147N B. 58.8 pounds C. 58.8N D. 147 pounds
28. The balloon shown in the figure is being held in place by the hooks placed in B, C, and D. If F = 717 N, determine the tension in cable AB (in N). ROUND OFF TO TWO DECIMAL PLACES.
The uniform plate has a weight of W = 450 lb. Suppose that F= 250 lb. The plate is supported by cables A, B, and C as shown below. Determine: A) The tension in the supporting cable A. B) The tension in the supporting cable B. C) The tension in the supporting cable C.
A block weighing 500N rest on a ramp inclined at 25° with the horizontal. Determine the force tending to move the block down the ramp.
Two weights (one is 100lbs. the other is 50 lbs.) are suspended over a circular post as shown. Determine the minmum co-efficient of static friction such that the weights remain motionless if B=180.