021) Find the value of R, if 1,-3A Rx www 502 562 www E-24 V 1g 3A

Q: READ THE QUESTION CAREFULLY. DO NOT DRAW THE KMAP OR THE CIRCUIT. Design a Moore-type circuit for…

A: A pattern recogniser with a 1-bit output Y accepts a 1-bit input X. Y becomes 1 only if the 1-0-1…

Q: Q2. A circular copper waveguide has a radius of 0.6 cm and is filled with a Teflon having & 2.25 and…

A: A circular copper waveguide has a radius of 0.6 cm and is filled with a Teflon having εr=2.25 and…

Q: Convert into rectangular, polar and exponential form: Given: Z1= 2-j3 Z2=3-j5 1. (Z1)^−5

A:

Q: A feedback control system characteristic equation is shown below: 5³ +5² +5+10=0 Fill in the Routh…

A: Given data, Feedback control system characteristic equation s3+s2+s+10=0

Q: Convert into rectangular, polar and exponential form: Given: Z1= 2-j3 1. csch(Z1)

A:

Q: Determine the closed-loop gain of the ideal OP-AMP circuit given with the following parameters: R1 =…

A: We need to find out closed loop gain for given circuit

Q: design 3 phase diode rectifier

A: The objective is to determine the design of three phase diode rectifier.

Q: Check the correct statements. * The localizer transmitted signals are frequency modulated Localizer…

A: Localizers are the antennas that are generally used for landing the flight. It is one of the…

Q: A battery is supplying electrical power to a single resistor R. If the total current in the circuit…

A:

Q: Find how many poles on the right half plane, RHP left half plane, LHP and on the j- axis for…

A:

Q: 8.13. A 1-T cell memory can be fabricated using PMOS transistors in the array shown in Fig. 8.46.…

A: Given, A 1-T cell memory can be fabricated using PMOS transistors in the array is shown below,

Q: Find the transfer function for mechanical system shown: + 7*X2 (t) f(t) [Hiokg| 2 Nm 5 N-s/m 2 Nts/m…

A: It is given that:

Q: D5.7. Using the values given in this section for the electron and hole mo- bilities in silicon at…

A: Semiconductors- Semiconductors are used in personal computers, smartphones, digital cameras,…

Q: The use of the magnetization curve to solve a problem like separately-excited and self-excited shunt…

A: In this question we will write about magnetisation curve of dc generator....

Q: 1. Find VCE, VBE, and VCB in below circuits. 2. Determine if the transistor is saturated or not Rc…

A: BJT transistor: It is a three terminal device and use for amplify the gain and as a switch. The…

Q: Refer to the given circuit below. Using Superposition Theorem, determine the percent contribution of…

A:

Q: rive the Vo response for non inverting summing amplifer circuit below using term Rf, Rg, R1 and :…

A:

Q: For a flux density of 6 Kilo Gauss at a pole with a cross-sectional area of 9 cm2, how much is the…

A: In this question we will find total flux of given pole....

Q: 4) The arms of a four an arm bridge a, b, c and d supplied with a sinusoidal voltage have the…

A: In this question we need to find value of R2 and the frequency at which bridge is balanced

Q: The magnetic circuit shown in Figure has an mmf of 500 A. Part 1 is cast-steel with 1₁ = 330 mm and…

A:

Q: A JFET shown in the circuit has the following V(GS(off))= -8V and IDSS= 16 mA. (a) Plot the Q point…

A: Junction-Gate Field-Effect Transistor:  JFETs is the three-terminal semiconductor devices.  This is…

Q: Refer to the given circuit below. Determine the Norton Equivalent Current Source if R3 is to be…

A:

Q: Given an Ideal OP-AMP with the following parameters: R1 = 680 2, R2 = 100 92, R3 = 1802, Rf = 2.7…

A:

Q: Given circuit represent the logic for which gate? A B Select one: a. None b. NOR c. OR d. NAND e.…

A: Given logic circuit:

Q: 2) From the given digram of inductance comparison bridge circuit, determine the value of Rx and Lx…

A:

Q: If 30% of a number is 12.6, find the number ★ 38 42 40 46

A: Given data, 30% of a number is 12.6

Q: Given an Ideal OP-AMP, what is the output voltage if the input voltage is Vi=0.9, R1=220 Ω and…

A:

Q: Q1: For the circuit shown in figure. Derive the stability factors S(Ico), S(VBE) and S(ß). RB +Vcc…

A:

Q: 10. A linear system has the transfer function given by W H(w) = w² + 15w+5 Find the power spectral…

A: We need to find out psd of output

Q: 1. a) Compute the capacitance of a parallel-plate capacitor with plates 10 cm by 20 cm and…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: Solve for Ic of Figure 41. VCC 15V Ve R1 $390kQ 4.77mA 0.33mA 3.3mA 0.477mA R2 $2.7kQ2 Q1 Beta = 90…

A:

Q: t w = 10000, the system H(s) = 10000*((s+100)(s+100))/((s+1000)(s+100000)) has a gain of: O A. None…

A:

Q: Solve the base voltage, VB, of Figure 611. R1 680ΚΩ VCC T18V R2 $3.9kQ Vc = 8V

A: Consider the diagram for the NPN transistor shown.

Q: given the circuit below, compute for the following is load impedance is 5+j10 and line impedance is…

A:

Q: 16. The resistance of a parallel circuit consisting of two branches is 12 ohms. If t resistance of…

A: Given, Two branch parallel circuit with, Req=12 ΩR1=18 ΩR2=?

Q: plz solve it within 30-40 mins I'll give you multiple upvote hand written

A: Here the concept related to the system stability is discussed.

Q: Solve the approximate value of lc of Figure 45. VCC 16V $3.9kQ Q1 1.32 mA 1.44 MA 12mM 1.5 mA V R1…

A: Collector current. Current is the rate of change of the flow of the charges. The current that flows…

Q: Check the correct statements. * To fly ILS an aircraft must be equipped with an ILS receiver ILS is…

A: Correct statements are:- 1st statement &2nd statement and 4th statement.

Q: What is the difference between a balanced voltage relay and a Translay relay ?

A: There are different types of relays used in the power system for the protection purposes like over…

Q: e. Draw the re model f. Zin g. Zout h. Ai i. Vo Z Av Z₁ 12 V 220 ΚΩ 2.2 ΚΩ HH B=60

A: Brief description: Note : According to the guidelines of the company we supposed to answer only 3…

Q: For the network of figure below, determine the value of IRs Rs www 9192 V₂=16 VA PZmax = 400 mW RL…

A: The solution is given below.

Q: Show your solutions clearly and systematically. The D latch of Figure 1 is constructed with four…

A: Given  The D latch of Figure 1 is constructed with four NAND gates and an inverter. Consider the…

Q: Solve the approximate value of Rg of Figure 44. VCC 12V Ⓒ468 AD 356 AM Ⓒ333 AN 340 AM RB RC Q1 Beta…

A:

Q: The generator shown in Fig. 1 is rewired as a self-excited shunt DC generator and Radj adjusted to…

A: Here we discuss the concept of DC shunt motor.

Q: If the frequency is 50Hz. The wavelength of light is O 6x10^6 m O 7x10^6 m O 3x10^6 m O 2x10^6 m *

A: If the frequency is 50Hz. The wavelength of light is

Q: If Vz=8 V and Pzmax=150mW. Determine the minimum value of RL to ensure the Zener diode is in the ON…

A: We need to find out the value of load resistance

Q: Find Leq 77 pH نعقد 17 pH m m 4 nH -Lea] b 12 nH ele 72 pH m 1 nH ell 7 pH m 14 pH

A:

Q: Capacitors are connected, one at a time, to the terminals of a 60-Hz, 12-V power source. Calculate…

A: From the Question Capacitors are connected, one at a time, to the terminals of a 60-Hz, 12-V power…

Q: he network given for the ac response with the re model inserted between the appropriate terminals.…

A:

Q: 1. Find Ceq Ceq Ï HE 0.4 μF 7μF 5 μF 0.8 μF HE HE 1 μF 12 μF 2 με не 5 μF

A:

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.