7:26"l ll@ *: 640909404 Engineering Economy Homework #3 Aretrofitted space- heating system is beingconsidered for a small office building. The systemcan be purchased and installed for $110,000, and itwill save an estimated 300,000 kilowatt-hours(kWh) of electric power each year over a six-yearperiod. A kilowatt-hour of electricity costs $0.10,and the company uses a MARR of 15% per year inits economicof evaluations refurbished systems. The marketvalue of the system will be $8,000 at the end of sixyears, and additional annual operating andmaintenance expenses are negligible. Use the AWmethod to determine whether this a system shouldbe installed.COMPANYLEGAL & POLICIESGet this answer with Chegg StudySEE THE ANSWER>>

Heat supplied is the heat supplied for the power generation or for the useful work of a machine.…

Answered: 0909404 Engineering Economy Homework #3…

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter6: Forced Convection Over Exterior Surfaces

Section: Chapter Questions

Problem 6.52P

See similar textbooks

Similar questions

Chapter 7, Problem 63, there is an 'h' value that is solved when expressing half the width of the Rankine Oval that I am not quite understanding the process by which the value is solved for. Could you break down the process by which h=0.02423 m? It's been a while since I was last in school, so the mathematical method by which 'h' was solved is a little unclear to me.
Use of Infinite Sequences and Series in Problem Solving of Special Theory of Relativity. A spacecraft travels fast the earth has a greater velocity (ⱱ) which approximates the speed of light. The time (to) measured in the spacecraft is different from the time (t) measured on earth. The time difference is given, to = t √1- ⱱ 2/c2 = t (1 – ⱱ 2/c2)1/2.
Write the simplified ENERGY BALANCE equation for each process based on the givenconditions. Start from the general energy balance form, and arrive at the correct balance byexplaining any addition, deduction, or change in the equation.Use the following as subscripts in your answer: 1 = initial system state; 2 = final system state; i = inletstate, e = exit state.a. A rigid tank transferring heat to its surroundings. b. The seal of an insulated system with a high energy substance is broken, causing the contents tobe evacuated until only 20% of the initial internal energy remained. No heat transfer was detectedin the system’s boundaries. c. Consider a hydroelectric power plant operating in steady conditions, wherein the system consistsof two water reservoirs with a height difference Δz, with a Francis water turbine placed betweenthe stream connecting both.
The temperature of an experimental heated enclosure is being ramped up from 80 to 450°F at the rate of 19°F/min. A thermocouple, embedded in a Thermowell for protection, is being used to monitor the oven temperature. The thermocouple has a time constant of 84 s. At t = 10 min, what is the difference between the actual temperature and the temperature indicated by the thermocouple? Final answer in whole number. Please show your complete solution and write readable.
The Laws of Physics are written for a Lagrangian system, a well-defined system which we follow around – we will refer to this as a control system (CSys). For our engineering problems we are more interested in an Eulerian system where we have a fixed control volume, CV, (like a pipe or a room) and matter can flow into or out of the CV. We previously derived the material or substantial derivative which is the differential transformation for properties which are functions of x,y,z, t. We now introduce the Reynold’s Transport Theorem (RTT) which gives the transformation for a macroscopic finite size CV. At any instant in time the material inside a control volume can be identified as a control System and we could then follow this System as it leaves the control volume and flows along streamlines by a Lagrangian analysis. RTT:DBsys/Dt = ∂/∂t ʃCV (ρb dVol) + ʃCS ρbV•n dA; uses the RTT to apply the laws for conservation of mass, momentum (Newton's Law), and energy (1st Law of…
Vibrations Question The following mass–spring system is sliding on a surface of kinetic friction.The system has the following parameters for initial design purposes subject to changes based on overall system performancem=100 kg, k=1300 N/m , x(0)=0.4 , v(0)-0.01, uk=0.08, F(t)=01. Obtain the equation of motion of the system2. Derive the equivalent first-order ODEs with initial conditions to represent part 1
Suppose we got the following data during a test of a 2- stroke engine in which gas is usedas a fuel:Diameter of the piston = 149 mmStroke length = 179 mmClearance volume = 0.88 literrpm of the engine = 302Indicated mean effective pressure = 6.0 barGas consumption = 6.0 m3/hCalorific value of the gas (fuel) = 16990 kJ/m3Make a clear sketch the geometry of this engine using the data and determine thefollowing:i. Indicated power developed by the engine in watt.ii. Air Standard Efficiencyiii. Indicated thermal efficiency of the engine.
AL-Gburi, [03.05.21 00:59]An ideal gas flows axially (x-direction) between parallel plates. Assume: Newtonian fluid, steady state, constant viscosity, constant conductivity, negligible gravity, and parallel stream- lines. Write the energy equation for this flow
****I hope that the solution is written on the computer and not written so that I can transfer it and understand it more quickly A composite wall of a refrigerator consists of three different materials; A, B, and C. Two of the used materials have known thermal conductivity, kA = 30 W/m. K and kC=45 W/m. K, and known thickness, LA=0.20 m and LC = 0.15 m. The third material, B, which is sandwiched between materials A and C, is of known thickness, LB = 0.15 m, but unknown thermal conductivity kB. Under steady-state operating conditions, measurements reveal an outer surface temperature of Ts,o = 20°C, an inner surface temperature of Ts,i = 600°C, and a refrigerator air temperature of T∞ = 800°C. The inside convection coefficient h is known to be 25 W/m2.K. (a) First, draw the thermal circuit for this wall. (b) What is the value of thermal conductivity for material B?
A diver 50 m deep in 8°C fresh water exhales a 1.2 cm diameter bubble which rises to the surface of the water and has a diameter of 2.2 cm when it reaches the surface of the water. Assume the air bubble rises slow enough that it is always in thermal equilibrium with the surrounding water. Include units in all your numerical responses 1. Determine the pressure of the air inside the bubbles
In a room unoccupied by people, a 2kW electric heater is turned on and kept on for 15 minutes. The enclosure is at atmospheric pressure of 100 kPa, has dimensions of 3 x 5 x 10 meters, and loses heat through its walls at a rate of 1000 kJ per hour. Calculate what temperature the air will reach after 15 minutes. solve it correctly please. I
What would be the weight of one 3-kg mass on planet where the acceleration due to gravity is 10 m/s2? Select the correct response 3 kN 29.43 N 30N 13 KN An open tank contains 5.7 m of water covered with 2.8 m of kerosene. Find the pressure at the interface of the two liquids. Specific weight of kerosene is 8.0 kN/m^3. Select the correct response 22.400 55.917 44.000 33.240

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Heat Transfer (Activate Learning wi…

Mechanical Engineering

ISBN:

9781305387102

Author:

Kreith, Frank; Manglik, Raj M.

Publisher:

Cengage Learning