-1 1 -1 5 2 -5 6 -5 то-о -5 6 6 5 5-6 6 0

Q: Design MOD-8 conutes

A: Counters : Counters are the digital circuit which is the application of flip flops with help of flip…

Q: i) Construct a CMOS NAND gate, NMOS NAND gate and NMOS NOR gate. ii) What are the differences…

A: We need to construct a CMOS Nand gate Nmos Nand gate and NMOS nor gate.

Q: 1)))))For the above circuit, determine:     a) The value of a resistance Rv, so that there is the…

A: In this question,  We need to determine the The value of a resistance Rv for maximum power transfer…

Q: Q17/ A 1100V, 50Hz, delta-connected induction motor has a star-connected slip ring rotor with a…

A:

Q: 8. Compute the Elmore delay for Vout in the 2nd order RC system: R2 n1 R, out FC2 VD

A: Given: Circuit diagram

Q: Vin R3 10. If Vin= 14V, Vz= 6.1V, Vae = 1.1V, he = 50 then, VOUT = V L = Ic= MA MA MA R2 250 R1 750…

A: We need to find out voltage and current for given circuit

Q: A 10-KVA, 500/250-V, single-phase transformer has its maximum efficiency of 94 % when delivering 90…

A:

Q: Q9/In a DM system, the voice signal is sampled at a rate of 64000 samples/sec. The maximum signal…

A: Given that; Sampling frequency (FS)=64000 samples/secMaximum Signal Amplitude Amax=1

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown www 50Ω O S3 个个 502 Vs…

A: In this question we need to draw Vm as a function of time

Q: A lighting load of 1500kW and a motor load of 2200kW at a pf of 0.707 are supplied by two…

A:

Q: Ck={0,0,0,1,0,1,0,0}

A:

Q: A signal x(t) is shown in Figure 1. 1 0 2 3 Figure 1: Signal x(t). (a) Sketch-x(t), x(t-1) and 2x…

A:

Q: /a- If the efficiency of the mhd generator for the gas system is 58% and the gas energy entering the…

A:

Q: three capacitors with

A:

Q: Find the time frequency expression for the voltage across the capacitor in the circuit shown in…

A: To solve this question we redraw the given circuit in phasor domain.

Q: Find the differential equation for the voltage across the capacitor in the circuit shown in below,…

A: It is given that: Vs=8e-2t

Q: Solve for Vo = Volts. =10 mA R₁ =2kQ w

A: In this question we need to find a voltage Vo

Q: Problem 3: Imagine you have a long straight wire running along the x- axis. Now imagine that…

A: According to the given information in the question, the diagram is shown below,

Q: An air-cored choking coil is subjected to an alternating voltage of 100 V. The current taken is 0.1…

A:

Q: Homework: For the circuit shown below find Av, Ai, Ro, Ri.

A: The required parameters can be calculated by using DC and AC analysis of Darlington amplifier.

Q: P8.7 A stepper motor has a specification of 200 steps/revolution. The motor shaft drives a linear…

A: A stepper motor has a specification of 200 steps/revolution. The motor shaft drives a linear…

Q: Determine the frequency responses of the following systems. Problem 2.4 (a) y(t) = r(t-1)

A: As per our guidelines we are supposed to be answer the first question only.  Kindly repost the other…

Q: Question(3): For the figure below: • Derive the pulse transfer function. • Find the input-output…

A: The Pulse Transfer Function We use z -transform to obtain a transfer function description of the…

Q: a. what is the charge voltage across the capacitor in figure a? b. what is the stable voltage range…

A: We need to find out charge and range for output voltage .

Q: FIND THE TOTAL FLUX DENSITY IN REGION: 1>=Y>=10 1>=Z>=2 X=0 If an infinite current sheet of k= 3ay…

A: In this question we will find flux density due to given infinite current sheet...

Q: Calculate work-function difference at T=27°C between Aluminum (4.1eV) and Boron doped Silicon.…

A:

Q: 12. Refer to the graphics addendum (C). The value most near the Line current between the Source and…

A:

Q: The task is to determine the number of elements in the vector x = [1, 4, 9, 16, 25, 67] and store it…

A: The vector is like array but unlike array, we don't define its size first. In vectors  size is…

Q: Find the Q point value of the diode current and the voltage gain Av in the following circuit: 700Ω…

A: Diode  It is an unidirectional electrical device, which allows current to flow only in one specific…

Q: what is the total impedance

A:

Q: Find the wind speed in K/h needed to generate 4641.7Kw for a wind turbine with a height of 32.13m…

A: Given data, Power generated P = 4641.7 KW Height h = 32.13 m  Density ρ=6.125 kg5 m3=1.225 kg/m3,

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown www 50Ω O S3 个个 502 Vs…

A: In this question we need to draw Vm as a function of time

Q: To put it another way: A BTS broadcasting information with 10 W of output power at 1800 MHz can only…

A: BTS broadcasting It is the type of base transceiver station, in which a fixed radio transceiver is…

Q: For the above circuit, determine: a) The value of a resistance Rv, so that there is maximum power…

A:

Q: The A matrix of a state space model has eigenvalues: [0.45 2.1j, -3.1] What conclusion can be drawn…

A: The solution is given below

Q: Show solution When the speed of an alternator is changed from 3600 rpm to 1800 rpm, the generated…

A: We need to find out generated emf for given Speed

Q: Draw the Single Line Diagram for electrical power system which consist of following items:…

A: In this question we need to draw single line diagram and per unit reactance diagram.

Q: Determine the discrete-time Fourier transform of the signal x [n] = (0.50)-¹u[n 1].|

A:

Q: given a descrete signal x[n]={...0,10,8,6,4,2,0,...} find even component and odd component

A: In this question we need to find even component and odd component of the given signal.

Q: 1- A 200-kVA transformer has an efficiency of 98 % at full-load. If the maximum efficiency occurs at…

A:

Q: A current filament of 10 7 A in the +X direction lies along x-axis, and a current sheet, K=2 ay A/m…

A: Given that; Current filament of 10π Ampere in +Ve x direction along axis→ produces H1 at P(2,4,3)…

Q: 11.24 In a balanced three-phase wye-wye system, the source is an abc-sequence set of voltages. Zine…

A: The solution is given below

Q: Make a figure/schematic symbol/drawing of this 2 problem given below (Parallel method: includes…

A: Bulb 1, 2 and 3 controlled by switch 1 in a parallel connection, Bulb 4 controlled by switch 2 in…

Q: Using Nodal Analysis, solve for VA.

A:

Q: 50) x y and z represent Boolean variables. If f = xy(z + 1) + xy, then one can simplify f So that f=…

A: We need to simplify the given Boolean expression

Q: P5.2 Determine the digital output of a 10-bit A/D convertor with 0 to 5 V analog voltage range if…

A:

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown www 50Ω S3 个 502 ↑ Vs…

A: In this question we need to draw Vm as a function of time

Q: Use the Principle of Superposition to determine the current i through R3 in the Figure. Let R1 =…

A: The solution is given below

Q: why is it 10 v instead if 20v?

A: In the given circuit, the input voltage magnitude is given as 20 V (peak-to-peak).

Q: Draw the output voltage waveform. V; 100 V –100 V 2.2 ΚΩ Ideal diodes 2.2 ΚΩ να 2.2 ΚΩ +

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.