(1) 1=0 R₁ R₂

Q: For a seven-point moving average system analyse and approximately sketch the magnitude and phase…

A: Seven Point moving average system:

Q: 3) Consider the following signal: x[n] = 0.25"u[n]

A:

Q: QUESTION 4 With reference to the instruction below what is the value of the number stored at source…

A: Choose the correct answer:

Q: A JFET has a specified pinch-off voltage of 5V. When VGs=0, what is Vos at the point where drain…

A: In this question We need to choose the correct option We know Drain current ID = IDSS (1-VGS /Vp )2…

Q: 7. Under steady state DC conditions, find i and v in the circuit below: 10 52 25 V 1502 10 F 10 H 20…

A:

Q: A 240V, 50Hz supply feeds a highly inductive load resistance through a thyristor bridge that is: 1)…

A: Half and fully thyristor bridge: Given data: V=240V Load resistance, =50 ohm frequency, f=50Hz…

Q: (1-a) Explain the operation of the Zener diode in forward and in reverse bias.  (1-b) Analyze the…

A: Zener Diode:

Q: Solve problem 1.41. Find Ix in the circuit using Tellegen's Theorem. 4 V 8 V 18 V 12V 2A+ 24 V 2 A…

A: Introduction Tellegen's theorem: Tellegen's theorem is a fundamental theorem of linear electrical…

Q: Jf Q S[n] is even ? show that its odd part=0

A: Given, Signal S(n) is even signal. We need to show the odd part of the signal S(n) is '0'.

Q: True or false  1- Management it control and application everything in work place only.?  2-…

A: we have to tell the given statement are true OR FALSE with explanation

Q: QUESTION 1 Name the math functions performed by PLCs. OA. Sin Oh E. Cosin O C. addition ⒸD. division…

A: Option H is the correct answer. Explanation: Basically, plc,s will almost always include these math…

Q: 3 Question 1 Consider the circuit shown. Vz= 4V. R₂1₂ R₁ + V- 13 R3 Answer LARA E Assume the diode…

A: We need to find out the current through diode in the given circuit.

Q: Consider each of the following four types of oscillations: A. underdamped B. critically damped C.…

A: Four types of Oscillations:

Q: What is the problem in power electronics: Improving the efficiency and reliability of power…

A: We need to explain power efficiency impact over 100 years .

Q: In the circuit shown in (Figure 1) Z₁ = 2.4-0.6) 2. Z₂ = 8.9+5.71 2, and Z3 = 20.5+0j 2. Take that…

A:

Q: Q5) A random variable X has probability density function given by fx(x) = 0≤x≤1 2* kx³ 1 0.5)

A:

Q: What is VA? 12√ E 12 VA 1856 Tor лол 10-2

A: Introduction: Kirchhoff's current…

Q: SOLVE STEP BY STEP IN DIGITAL FORMAT In the following exercise use the model of the ideal diode plus…

A: Given diode circuit as follows.

Q: For each of the circuits shown below, draw its voltage transfer curve, using the constant-drop model…

A: Since you have posted the multiple questions so we are supposed to answer the 1st three sub part.

Q: What resistance value would you have to change R2 to such that the net currents through R4 and R5…

A:

Q: A system has an input of a voltage of a ramp voltage which increases at 5 V/s. What is the input as…

A: Given data The type of input voltage is a ramp. It increases at the rate of 5 V/s. We need to find…

Q: For VGs=0, the drain current becomes constant when Vos exceeds OVDD O Vp O OV cutoff

A:

Q: Given the following phasor form of Ē(p,0,z) in cylindrical coordinates, determine the ū(p,0,z) for a…

A:

Q: Write a report on a topic (norton theorem test)

A:

Q: inductance of 2 henrys and a resistance of 10 ohms are connected in series with an emf of E volts.…

A:

Q: (c) Let R₁ = R₂ = R3 = = 1. Find Us 1, Us2 that yield i1 = 1, 12 = -4,13 = 5. Is this possible? Why?…

A:

Q: (b) Table 2 below shows the energy consumption and population data for Bangladesh, for 5 years…

A: Electrical Power Consumption:

Q: IN QA QB TOF Time IN 15 PT Q ET QA IN 3s - PT TON Time Q ET- QB Time (s) Time Time (s)

A: For TON : When input IN is turned ON, elapsed time ET will start increasing by specified time -…

Q: Briefly explain check of transistor type (NPN or PNP) and terminals (E,B and C) in lab?

A: We need to explain the process of identifying the NPN and PNP transistors and need to identify the…

Q: How would math instructions be classified as? A. Input OB. Output O C. Either A or B OD. Neither A…

A: Math instructions be classified as output.

Q: resistive load of value R = A single-phase, full-wave diode bridge is used to supply power to a 75 .…

A:

Q: 1) Find the voltage gain of the following amplifier. (Opam is am 15 M is ideal, Gain = 142 w +

A: The amplifier circuit is given as      We need to calculate the gain of the amplifier.

Q: 3. Consider the circuit shown in Fig 3 Assume that (t) U₂(t) = 10 cos(2000t + 16.26°) V. 1 mH Vo 100…

A: In this question We need to determine the all unknown parameters.  We know XL = wL Xc = 1/wC Current…

Q: Q7) A modem transmits a two dimensional signal (X,Y) given by: X = cos(2π0/8) and Y = sin(20/8)…

A: Disclaimer Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: Determine the resistor value Black Brown Red Orange Yellow Breed Blue Violet units Grey White Gold…

A: It is a four coloured resistor Green orange yellow silver

Q: We randomly take 10 units from the production of a machine whose production rate is 10% damaged.…

A: Probability problem:

Q: Show all complete solutions. A filter has a frequency response given by -14-12-10-8-6-9 |H(w)| ZH(w)…

A:

Q: In the circuit shown in Figure 3, a load having an impedance of 2z+j160 is fed from a voltage source…

A: As per Bartleby's guideline, only 3 subparts can be solved. Please send other questions separately.…

Q: What is the source voltage of the circuit below where I=20, R1=1,920, and R2=2,616? I R1 R2

A:

Q: Question 11 One of the most important characteristics of the FET is its high medium low none of…

A: JFET :  A JFET, is a junction based field effect transistor  in other words  JFETT, is a FET in…

Q: Using the figure above and the below information answer the following Problem 1 Known Ep = 120 V Es…

A: Given: Primary Voltage, Ep = 120 V Secondary Voltage, Es = 24V Primary Turns, Np = 300 turns Load, Z…

Q: products using K-Map for the function F (W,X,Y,Z) = Σ (0, 1, 2, 5, 8, 9, 10) 2. Obtain the minimal…

A: Since you have posted multiple questions, we will provide the  solution   only to the first question…

Q: FINITE STATE MACHINE A washing machine starts when a coin is deposited. It sequences through: a)…

A: FINITE STATE MACHINE

Q: (a). For the diode shown, calculate 2 points that belong to the diode equation P₁ = (VD₁ = 0.2V, ID₁…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: a. V₁ b. C. d. 12/0° v j₁ Find the Thevenin voltage, use mesh analysis to find VTH, clearly indicate…

A: Given, We need to determine a) Thevenin's voltage Vth by using mesh analysis and then solve mesh…

Q: 1. For the Intel 8086 microprocessor interface diagram below chose the suitable ICs to be connected…

A: 8086 microcontroller:

Q: 1. Determine the maximum power delivered to the v 4 V + 5Q -www- 15 Q2 3 Vx 5Q 692 www R

A: In this question we need to determine the maximum power transfer to the resistance R.  For maximum…

Q: Two generating units rated for 250 MW and 400 MW have governor speed regulation of 6.0 and 6.4…

A: Given: Speed regulation is 6 and 6.4 percent Power is 250 MW Frequency is 50 Hz

Q: Consider the function f(x) = 1, defined on the interval [0,1]. a) Find the Fourier cosine series…

A: given that function   f(x) = 1 , defined for interval [0,1] To find the Fourier series coefficients…

Q: Fill in the blank: Q: The mathematical formula for obtaining IDTFT is ?[?] =…

A: The inverse Discrete-time Fourier Transform (IDFT) is used for calculating the discrete time domain…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.