1) A cable is attached to a 0.5 kg block that slides over the smooth rigid horizontal rod AB. The diagram shown depicts the vertical plane. The cable tension is constant value T. At point C the speed of the block is 6 m/s to the left and at point D the speed is 1 m/s to the left. Determine the value of T. Note: take gravitational acceleration g=9,806 3 m D C A B -4 m-

1) A cable is attached to a 0.5 kg block that slides over the smooth rigid horizontal rod AB. The diagram shown depicts the vertical plane. The cable tension is constant value T. At point C the speed of the block is 6 m/s to the left and at point D the speed is 1 m/s to the left. Determine the value of T. Note: take gravitational acceleration g=9,806 3 m D C A B -4 m-

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.19P: Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of...

See similar textbooks

Similar questions

Plot the earths gravitational acceleration g(m/s2) against the height h (km) above the surface of the earth.
A 4-kg block rests on a smooth surface and is acted upon by force F, as shown in the figure. What is the value of the force F if the block accelerates at 15 m/s2
A circular tank of diameter 3 m contains water up to a height of 4 m. The tank is provided with an orifice of diameter of 0.4 m at the bottom. Find the time taken by water to fall from 4 m to 2m. Take Cd= 0.60include your free body diagrama.84.7 seconds b.47.8 seconds c.24.8 seconds d.43.8 seconds
1) A student decides to move a box of books into her dormitory room by pulling on a rope attached to the box. She pulls with a force of 134 N at an angle of 28.0° above the horizontal. The box has a mass of 20.0 kg, and the coefficient of kinetic friction between the box and floor is 0.300. (a) Find the acceleration of the box. ______ m/s2(b) The student now starts moving the box up a 10.0° incline, keeping her 134 N force directed at 28.0° above the line of the incline. If the coefficient of friction is unchanged, what is the new acceleration of the box? ________ m/s2, up the incline 2) Neglecting frictional forces on the trailer, determine the following. (Indicate the direction with the sign of your answer. Take the forward direction to be positive.) (a) the net force on the car _______ N(b) the net force on the trailer _______ N(c) the force exerted by the trailer on the car _______ N(d) the resultant force exerted by the car on the road magnitude _______ N direction…
The figure shows a junction of mass m = 10kg sliding on a rod in a vertical plane. Positioned 1 simpai is stationary and horizontal spring and tensioned Fp = 300N. If the spring constant is k = 1kN/m and the average frictional force between the rod and the junction is F = 30N. Calculate the speed at position 2. (Ans: 3.47m/s)
n engineer is designing a spring to be placed at the bottom of an elevator shaft. If the elevator cable breaks when the elevator is at a height H above the top of the spring, calculate the value that the spring constant k should have so that passengers undergo an acceleration of no more than 9.0g when brought to rest. Let N be the total mass of the elevator and passengers. Spring constant k that the spring should have so that passengers undergo an acceleration of no more that 9.0g
The lower block of mass m2 = 3.2 kg is pulled on by a rope with a tension force of 28 N. The upper block has mass m1 = 1.8 kg. The coefficient of kinetic friction between the lower block and the surface is 0.32. The coefficient of kinetic friction between the lower block and the upper block is also 0.32. What is the acceleration of the 3.2 kg block?
In a 300-rough incline, a 1.25 kg block is initially at rest beside a spring that is compressed by 24 cm as shown in the figure below. The spring has a spring constant of 180 N/m and the coefficient of sliding friction between the incline and the block is 0.23. When the spring is released, (a) how far up the incline (with respect to its initial position) will the block slide before sliding back? (b) What is the speed of the block at the instant it is 0.34 m from its initial position?
Equation of Motion(NORMAL AND TANGENTIAL) Fn= Man Ft= Mat Given a 1400 kg car that travels along a road with increasing vertical profile y = 0.0003x². If the constant velocity of the car is 30 m/s. of the distance is at 210m, a. Determine the x-component of the velocity (m/s) of the car. b. Compute the total force (KN). a. Determine the x-component of the velocity (m/s) of the car. b. Compute the total force (KN). Hint: The slope of a line is equivalent to tanø where Ø is an angle measured from the x-axis.
A motorboat and its load weigh 2150 N. Assume that the propeller force is constant and equal to 110N, and the water resistance is numerically equal to 6.7V, where V is the speed at any instant time in m/sec. If the boat starts from rest, determine its distance at the end of 10 seconds.
In the feasibility test, the flight movement of a drone is known to have a position function height h (t) = t2 - t - 2, where t is in minutes and height h is in meters. Determine the average speed of the drone increments at intervals of 3 minutes to 6 minutes and then determine the instantaneous velocity exactly equal to the average velocity.
16- A helicopter with a mass of 72kg is towed by a rope 15m perpendicularly from the ocean surface. The pilot's acceleration is g/10. What is the work (J) done on the pilot by the force exerted by the helicopter? (g=9.80m/s2)