1- Calculate the theoretical output DC voltage of the half wave rectifier circuit and compare it with measured value. For the capacitive filter, obtain the theoretical values of the DC output voltage and the ripple voltage and compare these values with the measured quantities. 2- Explain the effect of increasing the filter capacitance on the output voltage. 3- What is the difference between Half-Wave Rectifier and Full -Wave Rectifier? 4- What is the advantages and disadvantages of Full-Wave Bridge Rectifier over Half Wave Rectifier?

1- Calculate the theoretical output DC voltage of the half wave rectifier circuit and compare it with measured value. For the capacitive filter, obtain the theoretical values of the DC output voltage and the ripple voltage and compare these values with the measured quantities. 2- Explain the effect of increasing the filter capacitance on the output voltage. 3- What is the difference between Half-Wave Rectifier and Full -Wave Rectifier? 4- What is the advantages and disadvantages of Full-Wave Bridge Rectifier over Half Wave Rectifier?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

How is a solid-state diode tested? Explain.
What is CEMF?
What is the Half Wave Rectifer? What is the effect of a reservoir capacitor upon rectified waveform? What is the term "mean value" that applied to a rectified waveform? Explanation and interpretation of relationships in the experiment of Half Wave Rectifer? What is the different between half wave rectifier with filter and without filter?
1. Draw and briefly explain the ideal characteristics of PN-junction diode ? 2. Explain briefly about avalanche and Zener breakdown ? 3. In which region can Zener diode be used as a regulator? Why? 4. What is the ripple factor? For a good filter, should the ripple factor be high or low? 5. What is a rectifier? What is the difference between a full-wave rectifier and a half-wave rectifier?
The voltage waveforms shown below are obtained from a three-phase power rectifier used in an ESKOM application.The rectifier output before the inductive filter is denoted by VL and the load voltage after the inductive filter by Vo. Ignore any diode losses and consider a load resistance of 12.7 Ω. Analyse the waveforms and specify / calculate,11) the supply frequency;12) the rectifier pulse number;13) the rectifier average output voltage;14) the average output current;15) the r.m.s. value of the output current;16) the r.m.s. value of the harmonics present in the output current;17) the dc current rating of the rectifier diodes;18) the r.m.s. current rating of the rectifier diodes;19) the peak repetitive reverse voltage rating of the rectifier diodes;20) the peak repetitive forward current rating of the rectifier diodes;21) the line-line r.m.s. voltage of the three-phase supply;22) the rectification efficiency of the converter;23) the converter transformer utilisation factor;
What is a full-wave bridge-type rectifier circuit? Describe fully the operation of full-wave bridge-type rectifier circuit.
A 3.3-V, 30-A dc power supply is to be designed with a ripple of less than1.5percent. Assume that a half-wave rectiﬁer circuit (60 Hz) with a capacitor ﬁlter is used. (a) What is the size of the ﬁlter capacitor C? (b)What is the PIV rating for the diode? (c)What is the rms value of the transformer voltage needed for the rectiﬁer?(d) What is the value of the peak repetitive diode current in the diode? (e) What is the surge current at t =0+?
Following the analysis applied to the half-wave rectifier with capacitor filter, show how to arrive at the output waveform for a center-tapped full-wave with filter capacitor.
Calculate the capacitor value Conditions: 1st That, for the calculation of the peak voltage of the rectifier output, it is 9V. 2nd That the ideal ripple voltage is equal to 10% of the peak voltage at the output of the rectifier. 3rd That the maximum load current is 0.009A
Discuss the advantages and disadvantages of all rectifier circuits :
Explain the operation of both signal- and three-phase rectifier circuit by making reference to the sketched waveform.
Describe fully the operation of full-wave bridge-type rectifier circuit.