Q:ESTIMATE THE QUANTITIES OF THE FOLLOWING PARAGRAPHS,ACCORDING TO THE FIGURE BELOW1- EARTHEN EXCAVATIONS, STRIP FOUNDATION. 2- THE LIGHT CONCRETE LAYER UNDER THE FOUNDATION (BLINDING)(1:4:8) AND THE AMOUNT OF MATERIALS REQUIRED FOR IT.3- STRIP FOUNDATION CONCRETE (1:2:4) WITH AN ESTIMATE OF THE%3DQUANTITY OF CONCRETE MIX COMPONENTS REQUIRED FOR WORK.4- BUILDING WITH BRICKS AND CEMENT MORTAR (1:3) UNDER THEPADDLE WITH AN ESTIMATE OF THE AMOUNT OF CEMENT, SAND ANDBRICKS REQUIRED FOR WORK.5- PADLOCK CONCRETE.6- QUANTITY OF BRICKS REQUIRED TO BUILD WALLS UP TO A HEIGHTOF 3 M FROM THE LEVEL OF THE INNER SURFACE OF THE FLOOR9.12mعسنوى الكاشي0.48m3.0m2.0m0.24m1.2m0. 18m0.36m0. 16m0.40m0.30m1:3:60.00m10m0.7m1.24 m1,0cm

Answered: : 1- EARTHEN EXCAVATIONS, STRIP…

: 1- EARTHEN EXCAVATIONS, STRIP FOUNDATION 2-THE LIGHT CONCRETE LAYER UNDER THE FOUNDATION (BLINDING) (1:4:8) AND THE AMOUNT OF MATERIALS REQUIRED FOR IT.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Why the procedure to analyze the effects of secondary compression in a soil layer subject to usual types of construction loading is complicated?
What is the difference between soil compression and consolidation?
Foundation engineering makes use of different ways of extracting and quantifying the data necessary for the designer to take them into account at the time of design and execution and, thus, seek the best solutions to develop their work. A. Within the theme of design and calculation of foundations, describe what types of information should be obtained based on the aforementioned elements. B. Identify the three most commonly used types of field trials.
Write a simple analogy for the “Weathering, Erosion, and Deposition Processes” and explain further not more than 2 sentences each process.
When will you plan for stockpiling of excavation soil?
The load required to degrade the structural integrity of a foundation is normally distributed with amean of 22 tons and a standard deviation of 5 tons.(a) While at the site, a fellow engineer asks you the approximate probability that it takes between 17and 27 tons to degrade the foundation. Being knowledgeable in statistics, what you are able totell him off the top of your head?(b) Verify that your estimate in (a) is accurate using R.(c) A similar foundation is to be constructed so that the load required to degrade its integrity is againnormally distributed with a standard deviation of 5 tons, but the improved foundation is requiredto only have a 20% chance to degrade under a 22 ton load or less. What must the mean of thisdistribution be so that the foundation is constructed to the given specifications? Use R.
You are excavating a location for the vault shown below.The top of the walls shown are 1 foot below grade. Allslopes of the excavation are 1 to 3/4 per OSHA regulations(assuming type A soil) to a toe 1 foot outside the base of thewalls. The walls sit on a slab 1 foot in depth. Draw a sketchof the volume to be excavated, break it into components,and calculate the volume. The material from the excavationis to be used in a compacted fill. The front-end loader excavatingthe vault has an output of 200 bank cubic yards ofcommon earth per hour. It loads a fleet of four trucks(capacity 18 loose cubic yards each) that haul the earth to afill where it is compacted with a shrinkage factor of 10%.Each truck has a total cycle time of 15 minutes, assuming itdoes not have to wait in line to be loaded. The earth has aswell factor of 20%. How many hours will it take to excavateand haul the material to the fill?a. What is the production of this system in cubic yards perhour, assuming the trucks carry 35…
A septic tank is to be constructed to serve for a family of 8 persons. The size of a septic tankis 2300 mm x 1500 mm x 1500mm. Determine the following;a. volume excavated. b. for concreting, compute the cement, sand and gravel (using class A)i. top and bottom slab,ii. footing 6pcs- 0.60mx0.60m x 20cm andiii. column 6pcs- 20cmx20cm
Answer the following questions: 1) To compute the settlement for a particular soil sublayer, why does it matter how deep below the ground surface you are and where you are located beneath the footing footprint? 2) Why did we compute the time to complete 95% primary consolidation settlement instead of the time to complete 100% primary consolidation settlement? 3) Would we see more settlement beneath the center of a circular load or beneath the edge of the load? Why?
Discuss the importance of proper backfilling and compaction in excavation projects?
Determine the cubic feet of mortar and number of 12 × 8 × 16-in. concrete blocks required to construct a 35-ft-wide, 55-ft-long, 8-ft-high foundation. Assume a 5 percent waste factor for the block and a 50 percent waste factor for the mortar.
Using a waste factor of 7 percent, determine the number of cubic yards of concrete needed to pour the continuous footings shown in Figures 11.36 and 11.37. Assume that the wall is centered over the footing.