1) Given the sinusoidal voltage v(t)= 50 cos(30t + 10°) V, find: (a) the amplitude Vm, (b) t(c) the frequencyf, and (d) v(t) at t= 10 ms.

Answered: Image /qna-images/answer/8cee7ce4-0bf5-4dc3-9969-462701ba28e5.jpg

Answered: 1) Given the sinusoidal voltage v(t) =…

1) Given the sinusoidal voltage v(t) = 50 cos(30t + 10°) V, find: (a) the amplituc (c) the frequency f, and (d) v(t) at t= 10 ms. %3D

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Related questions

Q: A series RL circuit shown below, is excited with a sinusoidal voltage v(t) = 150 sin(500 t) V. %3D…

A: Given circuit is - Given values are - Vst=150sin500tVolt

Q: 9.1 Given the sinusoidal voltage v(1) = 50 cos(30t + 10°) V, find: (a) the amplitude Vm. (b) the…

A: Consider the given voltage equation is of the form. V=Vmcosωt+θ

Q: Q1. Using Thevenin's theorem, perform the conversion showed in the image below. Perform transient…

Q: AC Voltage Generator provides 100 V at angular frequency of 500 rad/s to a series RLC, R = 3 ohms, C…

A: It is given that: V=100 Vω=500 radsecR=3 ΩC=50μFL=10 to 80 mHVCmax=1200 V

Q: Question 2 What is the RMS value of x(t)? A signal x(t) has a period of 4 sec and is given as (1 n…

A: In this question we need to find a RMS value of the given signal.

Q: 2. For the sinusoidal waveform shown in Fig, determine (a) its frequency, (b) the peak-to-peak…

A: Fig: Given waveform (a) Time period of above waveform is T=horizontal…

Q: Q1: Fill all the blanks: 1- The total apparent power..... . 2- The capacitive network have a…

A: As per our guidelines we are supposed to answer only 3 sub part of a given question. Kindly repost…

Q: solve the following Amplitude (A), period (T), and frequency (f) using the measurement shown in the…

A: In this question, What is Amplitude (A), period (T), and frequency (f) ? We know 1. Amplitude =…

Q: The phase angle between the input waveform and the capacitor can then be measured using the…

Q: weite the equation of the Qc sine conditions Ye ミ220V, T = 20mg,=/2 ९१०० wave having the following…

A: given data: maximum value of voltage vp = 220 V Time period = 20 ms angle ϕ = π/2

Q: 2. If a voltage v(t) = 10 sin(2000nt + 45°) is applied to a) an inductor with L = 1.6 mH b) a…

A: Given that v(t)=10sin2000πt+45° V Case (1) when L= 1.6 mH (i) The impedance of the circuit is…

Q: 1. Given the sinusoidal voltage v (t) = 50 cos (30t + 10°) Volts, find: (a) The amplitude Vm, (b)…

Q: Problem 4 If v = 60 V at æ = 30° and t = 1.5 ms, determine the math- ematical expression for the…

A: In practical scenario, the alternating voltage is generated which is of sinusoidal nature and is…

Q: QUESTION 2 io + 10 cos 21 V C 6 sin 2t V For the circuit shown above, what is the amplitude of the…

Q: The voltage wave propagating on a transmission line is given in real space-time form as v(z, t) =…

Q: 1. The current source in the circuit shown below is generating a sinusoidal waveform such that iç…

A: By using current division rule we can find current in second branch then by using ohm's law we can…

Q: 3 2 1 0 −1 -2 -3 0.0 12.5 V 25.0 37.5 50.0 Time (s)

A: We need to find out root mean squre value of given voltage.

Q: Example: Convert the following phasors to the time domain if the frequency is 400 Hz. a) V = 10/20°…

Q: Unanswered Question 2 What is the RMS value of x(t)? A signal x(t) has a period of 2 sec and is…

A: We have to find rms of x(t)

Q: From the circuit, find the voltage drop across the capacitor. Let v.(1) = 4 u(t) V and at time t=0…

A: The solution is given below

Q: 2) An LC circuit is made by attaching a 0.2221 H inductor is connected across a variable capacitor…

Q: Given the sinusoidal voltage ??(??) = 50 cos(30?? + 10??) V, find: (a) the amplitude Vm, (b) the…

Q: An industrial coil is modeled as a series combination of an inductance L and resistance R, as shown…

Q: For an RLC series circuit, the voltage amplitude and frequency of the source are 130 V and 800 Hz,…

A: Given an RLC series circuit having, Peak Voltage, Vm=130 V Frequency, f = 800 Hz…

Q: . Assuming the passive sign convention and an operating frequency of 5 rad/s, calcualte the phasor…

Q: 4. For the signals provided below a. Which are periodic? Give their periods. b. Which are power…

A: The expression of signals is, a). (i). Considering the first signal, Determining the composite…

Q: The circuit shown operates in the sinusoidal steady state with an angular frequency of 100 rad/s.…

Q: The voltage across the terminals of the 5μF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the…

A: Given, Capacitor=C=5μF=5×10-6F Voltage across Capacitor Terminal=V(t)=30cos4000t+25°V

Q: Electrical Engineering A four-element array of isotropic sources is placed along the z-axis. The…

Q: A 350 Hz sinusoidal

Q: A pure inductor of 20.0 mH is connected to a source of 220 V. Find the RMS value of current in the…

A: Given, Source voltage, Vsrms=220 V Inductance, L = 20 mH Frequency of source, f = 50 Hz

Q: Q1): Sketch the root locus for the system shown below and find the points intersection with the…

Q: find the phase, frequency, amplitude, period of the sinusoid v(t) = 10sin(377t +45°). Graphically…

A: v(t) = 10sin(377t +45°)

Q: If a circuit is operating at a frequency of 135 rad/sec and the circuit has a capacitor with a value…

A: Given data, Angular frequency, ω=135 rad/s Capacitance, C=2 mF

Q: Determine the steady-state voltage v(t) when it is subjected to a waveform shown below. is (A) 5 mH…

A: The function given is defined as, Its period is, The fundamental frequency is,

Q: need the correct solve asap plz

Q: The current in an L-R-C series circuit has amplitude 0.120 Aand angular frequency 8.00 * 103 rad/s,…

A: It is given that:

Q: in AC mode. Determine the current response in the inductor in the time domain. 330 mF 20 2.5 cos…

Q: The sinusoidal signal x(t) = 3 cos(200t + m/6) is passed through a square-law device defined by the…

Q: The terminal points determined by pi/2, pi, -pi/2, 2pi are __________, ________, ___________, and…

A: Given: The values are shown below:

Q: 1) (G-). x1(t) = 2 cos and r2(t) = 2 – 4 sin %3D %3D do the following: (a) Find the fundamental…

Q: Question 2 What is the RMS value of x(t)? A signal x(t) has a period of 1 sec and is given as 1 x(t)…

A: A simple problem on RMS value finding.Look below for solution:-

Q: A circuit has an ac voltage source and a resistor and capacitorconnected in series. There is no…

A: Ohm's law: This law states that the current is directly proportional to the voltage and inversely…

Q: VR), magnitude of the voltage across inductance (VL) and capacitance (Vc the following RLC series…

A: In this question we will find voltage source value and active power consumption with given data....

Q: Consider two signals v1(t) = 2 sin(wt + 135°) Volts and i, (t) = 3 cos(wt + 15°) Amps, respectively.…

Q: The voltage wave propagating on a transmission line is given in real space-time form as v(z, t) =…

Q: The relaxation time of mica (G = 10-15 mho/m, ɛ, = 4) is %3D 7.36 hrs 2.456 hrs 4.912 hrs 9.82 hrs

Question

1) Given the sinusoidal voltage v(t)
= 50 cos(30t + 10°) V, find: (a) the amplitude Vm, (b) t
(c) the frequencyf, and (d) v(t) at t= 10 ms.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

b) Find the rms current flowing in an AC capacitive circuit when a 4μF capacitor is connected across a 880V, 60Hz supply.
Consider the sinusoids x1[n] = 2 sin(πn +2π/3) ,x2[n] = 3 cos(3πn + 3π/2) −∞ < n < ∞, From their frequencies determine if these signals are periodic, and if so, determine their corresponding periods.
Given the sinusoidal voltage ? (?) = 70 sin(4π? + 10) V find: (i) The amplitude of the maximum voltage(ii) The period T(iii) The frequency f
Given the sinusoidal voltage ?(?)=50cos⁡(30?+10?) V. Find the following: (a) the amplitude, ?? (b) the period, T (c) the frequency, f (d) the angular frequency, ? and (e) ?(?) at t=10 ms
find the phase, frequency, amplitude, period of the sinusoid v(t) = 10sin(377t +45°). Graphically sketch the position of the sinusoid
Using the phase shift theta= 72° from the Experiment, determine the value of the capacitance, C, of the capacitor shown. Vr(t) = 0.93612 cos( 4000 t - 72° ) V
solve the following Amplitude (A), period (T), and frequency (f) using the measurement shown in the picture: 1. Amplitude = (V/DIV) DIV = 2. period (T) = (T/DIV) DIV = 3. frequency= 1/T=
A chirp is a signal of the form x(t) = A sin(2πϕ(t)) where A is the amplitude and the function ϕ(t) is the phase of the chirp. If the phase has the form ϕ(t) = f0 ((t1 − t0) / ln ( f1/ f0 )) * ((f1/ f0)^( t−t0/ t1−t0 ) − 1 ) + ϕ0, Then the signal is called a logarithmic chirp, exponential chirp, or exponentially swept sine. Here, f0 is the frequency at time t0, f1 is the frequency at time t1, and ϕ0 is the phase at time t0, where t1 > t0, f1 ̸= f0, and f1f0 > 0 The frequency of a chirp at time t is f(t) = dϕ/ dt . What would the frequency of a logarithmic chirp as a function of time t and show that the frequency strictly increases for t0 < t < t1 when f1 > f0 and strictly decreases for t0 < t < t1 when f1 < f0.? Thank you for the help.
Solve for the steady state expression for vo(t) if vg(t) = 60 sin 8000t V
Consider the following sinusoidal plot of the instantaneous voltage of an inductor as a function of time.What is its root-mean-square voltage?
Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the inductor, EL, is 104 V, and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. ETITZ20VAPFER78VIRRPEL104VILXLVARsLL
A circuit has an ac voltage source and a resistor and capacitorconnected in series. There is no inductor. The ac voltage source hasvoltage amplitude 900 V and angular frequency v = 20.0 rad/s. Thevoltage amplitude across the capacitor is 500 V. The resistor has resistanceR = 300 Ω. What is the average rate at which the ac source supplies electrical energy to the circuit?