Can you please answer this В1) The setup to the right is usedto support the 150lb pipe60°AEsection. Find for the tension ineach cable.H.

Answered: Image /qna-images/answer/c01856b2-f67a-4efc-97c9-f45d6c241c84.jpg

Answered: 1) The setup to the right is used to…

Engineering

Mechanical Engineering

1) The setup to the right is used to support the 150lb pipe section. Find for the tension in each cable.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.77P: The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B,...

See similar textbooks

Related questions

Q: 2. For the frame shown, calculate the reactions at A and B. 240 lb 90 Ib/ft 30 Ib/ft A 20 ft 20 ft…

Q: Find the tensions in the ropes that hold a 100N box. The ropes are considered weightless and are at…

Q: 3/63 A uniform steel plate 18 in. square weighing 68 lb is suspended in the horizontal plane by the…

A: The side of the square plate is a=18 in. The weight of the plate is W=68 lb.

Q: The homogeneous beam _4Bweighing 800 lb carries the distributed load shown.Find the support…

A: A pin support will exert both horizontal and vertical components of reaction. The support A is pin…

Q: A 363.8N horizontal steel shaft is suspended by a vertical cable from A and by a second cable BC…

A: Consider the free body diagram shown below for the given system.

Q: 7. The boom is used to support the 75 lb flowerpot in the figure. Determine the tension developed in…

Q: Еxample 1: دور لعحز For the force system shown below, determine all unknown reaction. لظام لقوة

Q: Q4. A Cylinder 1m diameter and 10kg mass is lodged between cross pieces that makes an angle of 60o…

A: x= tanθ=0.5x=Rxx=0.5tanθx=0.5tan30°=0.866m∑Fy=0N1+N2=mgdue to symmentry N1=N2=mg2=50N…

Q: Q/ Compute the pull force (F) on the rope exerted by the man to hold th crate in the position shown.…

A: Given:m=200 Kg

Q: The cable shown in Fig. If the sag ha in the cable is 200 m, determine weighs 30 N/m. The tension in…

A: Write the expression for tension in the cable.

Q: Find the tension force in each 35 cabler 木 oss kg.

Q: Find the force F on the bottom of the tank if : K=1.5 m , H= 6 m , D=5 m.

Q: ,determine the tenSion in each rope,

Q: An object is being held off the ground by a crane on the right and 4 constructions with a rope on…

Q: Q4: The jib crane is fixed at ( A ) and carry a box of ( 2500 kg ) mass, as shown in the figure.…

Q: 6 - The cable from A to B is 6 m long and supports the 100-kg crate from the small pulley Calculate…

Q: . each cable has vector, as seen in fig. Calculate the maximum mass of the sphere so that the…

Q: Find the tension in leg AC of the cable if the sag, h = 4'. 3' h

Q: Use the method of members to find the components of the forces acting on the frame with P=750N and…

Q: 5.18 The 355.8-N homogeneous plate is suspended from four wires. Determine the tension in each wire.

A: As the system is in equilibrium, so all the forces must balance each other. Write the expression for…

Q: A cable with supports at the same elevation has a span of 300m. The cable weighs 75 N/m and the sag…

A: Given data as per question span = 300 m cable weight = 75 N/m sag = 75 m Calculation

Q: Find the tension in the cable AB when the weight of the crate is 1000 N. B 3 m 2 m 2 m 1 m 1m y A 3…

Q: Find tension in the cable

A: Given data ; Acc. to question the free body diagram, W=981 Nμ=0.2 AForce=100 N

Q: Using the Method of Sections, find the forces in CE, CD, and BD. 4 m 5 KN B 2 m 10KN E 4m 3 m LL

Q: 3. The unstretched length of an elastic cord is made to run vertically from the ceiling down to the…

A: Given data: The slope of an inclined cord, s = 4/5. Let T be the tension in the cord and F is a…

Q: 6. Determine the tension in each segment of the cable and the cable's total le 4 ft 7 ft B

A: Find FAB , FBC, FCD, and total length

Q: 3.18 Neglecting the weight of the frame find the tension in cable CD.

A: Load = 200 lb/ft Answer is T = 7200 lb

Q: 3: Find reaction at support B for the frame shown in Fig. (3). Also, draw B. M. D. Take

Q: Neglecting the weight of the frame, find the tension in cable CD

A: Solution:- Tension in the CD⇒Draw the free body diagram of member AB ⇒Now, the load is…

Q: The tension in cable AD is N.

Q: Two cables support a 200- lb weight as shown. Determine the tension in each cable. 200 - Ib

A: Given data as per question Load =200 lb considering FBD of the system Appling lami…

Q: A rope extends between two poles. A 90 N boy hangs from it as shown in Fig. 1. Find the tensions in…

Q: 1. In the figure below, if a=5 feet, L=14 feet, and the respective weights of the diver and the…

Q: Q.4) Determine the tensions in the three cables supporting a weight of 180 N as shown in figure…

A: Let us take origin as O. FBD: From figure, O = (0,0,0) A = (4,-8,5) B = (-6,-8,5) C = (0,8,5)…

Q: calculate the tension on cable CD and the reaction on joint B if the weight of the cylinder is 85N

Q: Draw the FBD. Find the support reactions in A and tension force in the cable. P = 8 KN.

A: Given data Given force system

Q: The 1200-lb weight is suspended from a cable that runs over a small pulley attached to the boom ABC.…

A: Given data, Coordinates of A = (12, 0, 0) ft Coordinates of B = (6, 0, 0) ft Coordinates of C = (0,…

Q: A cable with supports at the same elevation has a span of 550 ft. The cable weighs 4 lb / ft and the…

A: Given data: Weight of the cable, W = 4 lb/ft. Sag at the midspan of the cable, h = 100 ft. Distance…

Q: Q. 4: The 420 lb homogeneous log weight 420 lb, is supported by a rope at A and losse-fitting…

Q: The cable shown supports a girder which weighs 850 lb/ft. Determine the tension in the cable at…

A: Free Body Diagram: Free body diagram is a diagram that is drawn to determine the unknown forces in…

Q: 76A) The distance BF is 1.7 m. Using the method of sections, find the forces in BC, FC and FG. Also,…

Q: Calculate the tension in each cable, and the reaction at D

Q: A system of cords knotted together at O and P support the weights shown. Compute the tensions A, B,…

Q: Use this diagram to find the forces BC and CD. Use a positive number if in tension, a negative…

A: Given:

Q: The resultant force of the three cable tensions that support the crate is R = 500j lb. Find T1 and…

Q: Find the support reactions at D and the tension forces in AC and AB. The beam has a mass of 100 kg…

Question

Can you please answer this

В
1) The setup to the right is used
to support the 150lb pipe
60°
A
E
section. Find for the tension in
each cable.
H.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B, the sag in the cable is 5 m. Find the span L of the cable.
solve for the reaction
A flexible cable with supports at the same elevation has a span of 900ft. The cable weighs 0.75 lb / ft and is 1000 ft long. Determine The maximum tension in the cable
Find the force F on the bottom of the tank if : K=1.5 m , H= 6 m , D=5 m.
Each cord can sustain a maximum tension of 700 N . Determine the largest mass of pipe that can be supported.
Find tension in the cable
The 15-m-long cable supports the loads W1 and W2 as shown. Find the ratio W1/W2 for which the segment BC will be horizontal; that is, 2=0.
The end of a water hose weighing 0.5 lb/ft is pulled with a 40-lb force that is inclined at 14 to the horizontal. Determine the length s of the hose that is lifted off the ground and the corresponding horizontal distance L.
The 110-lb traffic light is suspended from two identical cables AB and BC, each weighing 0.80 lb/ft. If the maximum allowable horizontal force exerted by a cable on a vertical post is 170 lb, determine the shortest possible length of each cable and the corresponding vertical distance h.
The chain OA is 25 ft long and weighs 5 lb/ft. Find the maximum force in the chain and the distance H.
The woman is trying to move the crate of weight W by pulling on the rope at the angle to the horizontal. Find the smallest possible tension that would cause the crate to slide and the corresponding angle .
Determine the force F required to pull up the 3.54m stopper from the drain of a sink if the depth of water is 10 in. Use =0.036lb/in.3 for water and neglect the weight of the chain.