1. A 25.0 m metal rod moves at a speed of 5 m/s perpendicular to a magnetic field of intensity 1.4 T. Find the resulting potential difference at the ends of the rods. 2. A square loop with 5 cm sides is perpendicular to a uniform field 150 mT in intensity. If a third of this flux remains every 0.010 s, what is the average emf induced?

1. A 25.0 m metal rod moves at a speed of 5 m/s perpendicular to a magnetic field of intensity 1.4 T. Find the resulting potential difference at the ends of the rods. 2. A square loop with 5 cm sides is perpendicular to a uniform field 150 mT in intensity. If a third of this flux remains every 0.010 s, what is the average emf induced?

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter28: The Atom

Section: Chapter Questions

Problem 59A

See similar textbooks

Similar questions

Can a constant magnetic field set into motion an electron initially at test? Explain your answer.
A square loop of wire connects the ends of a 10-ohm resistor, as shown . The loop sits perpendicular to a magnetic field of strength 0.6 T that is directed into the page in the picture at right. The field then drops to zero over a time of 3 seconds. If the loop is 10 cm high and 15 cm wide, what is the current induced in the loop?
E2 The two plates in figure 6 are infinite both in the directionof ?̂ as in ?̂. Determine the magnetic induction producedfor current distribution. ?⃗ =?0?̂ for− ? < ? < 0?⃗ = −?0?̂ for 0 < ? < a
A 20-cm-diameter circular loop of wire is placed in a 0.72-T magnetic field. 1) When the plane of the loop is perpendicular to the field lines, what is the magnetic flux through the loop? 2) The plane of the loop is rotated until it makes a 41 ∘ angle with the field lines. What is the angle in the equation ΦB = BAcosθ for this situation? 3) What is the magnetic flux through the loop at this angle?
In the figure below, a uniform magnetic field of 0.5 T points directly into the plane of the paper as shown below. The bottom section acts as a velocity selector, so that the crossed electric field (uniform in the entire region) of strength 2.08X105 V/m and magnetic field allows only positive ions q with a certain velocity to reach the slit S1. After passing through the S1, the singly ionized positive ions experience a magnetic force only (same uniform magnetic field as bottom section), which can separate isotopes with different masses, and only selected mass will reach one of the slits S2 or S3. a. What is the mass of the particles that will reach the second slit, if the distance between the slits are 40 cm (1 and 2 or 1 and 3). b. If the magnetic field is doubled in both regions, while keeping electric field same what is the new mass that will reach the second slit S2/S3.
1. What is Lenz's Law? To which basic principle of physics it is most closely related and why? 2. Explain how Lenz's Law allows one to determine the direction of an induced current. 3. A straight conducting wire is dropped horizontally from a certain height with its length along east-west direction. Will an emf be induced in it? Justify the answer.
A 9-turn generator coil with area 0.160 m2 rotates in a 1.30 T magnetic ﬁeld. At what frequency should the coil rotate to produce a peak emf of 135, as expressed using three significant figures? Can you help me conceptually how the answer is derived better.
1. Explain briefly how Lenz’s law is said to follow the Law of conservation of energy (that explains why there has to be an opposing magnetic field) 2. Why do you think, we need to study the processes, principles and laws in electricity production and distribution?
At a given instant, a 3.8A current flows in the wires connected to a parallel-plate capacitor. What is the rate at which the electric field is changing between the plates if the square plates are 1.60 cm on a side?
Figure 1 is a sectional view of two circular coils with radius ?, each wound with ? turns of wire carrying a current ?, circulating in the same direction in both coils. The coils are separated by a distance ? equal to their radii. In this configuration the coils are called Helmholtz coils; they produce a very uniform magnetic field in the region between them. (a) Derive the expression for the magnitude ? of the magnetic field at a point on the axis a distance ? to the right of point ?, which is midway between the coils.
Electromagnetic radiation from a 4.9-mW laser is concentrated on a 0.75-mm2 area. Part (a) What is the intensity of the radiation falling on this surface, in watts per square meter? I = Part (b) Suppose the surface carries a 2.00-nC electric charge. What is the maximum magnitude of the electric force, in newtons, it experiences? FE,0 = Part (c) If the charge moves at 400 m/s, what is the maximum magnetic force, in newtons, that it feels? FB,0 =
A sort of "projectile launcher" is shown in (Figure 1). A large current moves in a closed loop composed of fixed rails, a power supply, and a very light, almost frictionless bar (pale green) touching the rails. A magnetic field is perpendicular to the plane of the circuit. If the bar has a length ℓ = 30 cm , a mass of 1.5 g , and is placed in a field of 1.5 T , what constant current flow is needed to accelerate the bar from rest to 20 m/s in a distance of 1.5 m ? What is the direction?