1. A Carnot engine operates between reservoirs at 610 and 315 K. If the engine absorbs 75J per cycle at the hot reservoir. Calculate (a) The efficiency, e, of the engine e= (b) The work output per cycle W. = per cycle

1. A Carnot engine operates between reservoirs at 610 and 315 K. If the engine absorbs 75J per cycle at the hot reservoir. Calculate (a) The efficiency, e, of the engine e= (b) The work output per cycle W. = per cycle

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter4: The Second Law Of Thermodynamics

Section: Chapter Questions

Problem 73AP: A Carnot engine operates between 550 and 20 baths and produces 300 kJ of energy in each cycle....

See similar textbooks

Related questions

Q: A 2002 load receives power from parallel-connected battery cells, as shown in the figure below.…

Q: In the given circuit, R₁= 6 ohms, R2 = 3 ohms and R3 = 5 ohms. The battery has negligible internal…

Q: Question 7 A wave travels or propagates with a definite antinodes wave speed amplitude O wavelength…

A: To fill the blank : A wave travels or propagates with a definite _____ through the medium

Q: Determine the equivalent resistance between terminals a and b.

Q: Compute for the normal force. n m₂ Ⓒ = 40.3° A. m2gcos40.3 B. m2gsin49.7 C. m2gtan49.7 D. m2g m₂g T…

Q: A cord that has a mass of 0.79 kg is stretched between two supports specifically 45 m apart. If the…

Q: Suppose that there are standing waves in a closed pipe. Which of the following is true regarding the…

A: Standing waves are present in closed pipe .

Q: Wave that moves along the string Standing Wave Antinode Node Traveling Wave

A: The wave that moves along string is bound within string.

Q: O Antinodes O Amplitude

A: These are particular points in the wave that never move

Q: Initially, a parallel combination of two resistors, R₁ and R₂, is connected across a DC source.…

A: In parallel combination current across two resistances become different but the value of potential…

Q: Suppose a wave whose expression is given as y(t) = Asin (2nFt), where y is the vertical displacement…

A: The expression of the wave is given. All we have to do is to substitute the given values properly to…

Q: a R1 ww 7 Ohms R2 www 2 Ohms

A: Since R3 and R6 are in series so the equivalent resistance R'1 = 6 + 10 = 16Ω R5 and…

Q: The circuit below has a voltmeter that reads 6-V connected, in parallel, to resistor with unknown…

A: Given DataI=3mARE=3kΩVs=6V

Q: A baseball slugger hits a pitch and watches the ball soar into the bleachers for a home run, landing…

A: Given The velocity at which the ball is caught by the fan is 35.4 m/s The angle made by the ball as…

Q: Initially, two resistors R1 and R2 are connected in series. The connection of the terminals of R1…

A: Series and parallel connection of resistors

Q: Which statement is TRUE when the resultant of all the forces acting on the body is zero? O The body…

A: According to the Newton's second law of motion the net non zero force acting on a body cause…

Q: In the normal mode of a vibrating string, multiple frequencies are present and one of these is the…

A: Answer:- overtones In the normal mode of a vibrating string, multiple frequencies are present and…

Q: Question 26 Which of the following is true regarding parallel-connected resistors? The answer cannot…

A: Third option is correct.

Q: What is the formula for linear mass density? speed/Force length/mass mass/length Force/speed

A: Required: The formula of linear mass density

Q: An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel…

Q: In order to perform an experiment on electric circuits, a student has to use a 6-ohm resistor, but…

Q: Initially, two resistors R1 and R2 are connected in series. The connection of the terminals of R1…

Q: Determine the ratio RA of the force exerted by the sun on the moon to that exerted by the earth on…

Q: 35. The curr . the capa A. V3H В. 0.3Н С. 0.4Н D. (5/VE E. 5H

Q: Two resistors, 18 ohms and 24 ohms, are to be connected in parallel across the certain voltage…

A: Given:- Resistance of the two resistors are R1=18Ω, R2=24 Ω Power dissipated in 18 Ωresistor is…

Q: For the circuit shown below, determine the power consumed by battery 1's internal resistance. O…

Q: The point form of Ampere's law tells us that: a.) Currents produce steady magnetic fields b.) The…

A: Ampere's circuital law is always one applicable for steady current. So option (a) is true. The…

Q: Connected in series, three resistors consume the following power values: 50 watts, 30 watts, and 20…

A: P1 = 50 W P2 = 30 W P3 = 20 W V3 = 10 V

Q: The current through a 10-ohm lamp energized by two series-opposing ideal batteries amperes when the…

Q: Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and…

Q: Davie flexed his lowest bass guitar with strings of length 1.00m between fixed points. One string,…

Q: Determine the equivalent resistance between terminals a and b. R1 a- ww 5 Ohms Ο 7.9640 Ω Ο 7.4483 Ω…

Q: Compute for the current is in the circuit shown below.

Q: Determine the equivalent resistance between terminals a and b. R1 a 5 Ohms O 7.9640 Q Ο 7.4483 Ω…

Q: The current through a 10-ohm lamp energized by two series-opposing ideal batteries is measured to…

A: Given, The current through a 10-ohm lamp energized by two series-opposing ideal batteries is…

Q: 5. The figure shows a cross section across a diameter of a long cylindrical conductor of radius a =…

Q: Determine the equivalent resistance between terminals a and b. M 10 ohms 10 ohms 10 ohms M 10 ohms…

Q: 25. How many complete rotations will a phasor, representing a 50Hz AC, make in two seconds? A. 0.01…

A: The frequency is given. We have to find the number of full rotations in 2s.

Q: Given two batteries: one with voltage V and internal resistance r1₁; another with also voltage V and…

Q: Determine the equivalent resistance between terminals a and b. R4 4 Ohms ww R1 1 Ohm X N 20 R2 2…

Q: Connected in series, three resistors consume the following power values: 50 watts, 30 watts, and 20…

Q: Suppose a wave whose expression is given as y(t) = Asin(2xFt), where y is the vertical displacement…

A: Given that Wave expression Y(t)=A sin(2πFt) T=20 mili second=20×10^-3sec Time (t)=8 ms=8×10^-3sec…

Q: Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and…

A: Equivalent emf of two cells when are in series E = E1 + E2 And, equivalent internal resistance in…

Q: The displacement of the particles in a medium is perpendicular to the direction of the wave…

A: Last option is correct. Explanation- In Transverse wave, motion all points on a wave oscillate along…

Q: 5 S R5 5 Ohms www www R1 1 Ohm - R2 ww 2 Ohms R6 ww 6 Ohms R3 ww 3 Ohms ww R4 4 Ohms a

Q: Which of the following is true about resistors that are connected in series? O The reciprocal of the…

A: Two resistances are said to be connected in series when they are connected end to end.

Q: Which of the following term describes the number of cycles that pass by each second? frequency…

A: Required: The number of cycles passed each second is known as

Q: A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done…

A: Data provided: Current (I) = 12 A Voltage (V) = 25 V Time (t) = 3 ms = 3×10-3 s Asked: Energy (E)

Q: etemine the equiva Ο 6.8750 Ω O 5.8750 Q O 5.2589 Q O 6.2589 Q a R1 5 Ohms R4 3 Ohms R2 3 Ohms R5 6…

Question

1. A Carnot engine operates between reservoirs at 610 and 315 K. If the engine absorbs 75 J per cycle at
the hot reservoir.
Calculate
(a) The efficiency, e, of the engine
e=
✓
(b) The work output per cycle
W
per cycle
✓ J

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A Carnot engine operates between 550 and 20 baths and produces 300 kJ of energy in each cycle. Find the change in entropy of the (a) hot bath and (b) cold bath, in each Carnot cycle?
Steam locomotives have an efficiency of 17.0% and operate with a hot steam temperature of 425C. (a) What would the cold reservoir temperature be if this were a Carnot engine? (b) What would the maximum eficiency of this steam engine be if its cold reservoir temperature were 150C ?
How could you design a Carnot engine with 100% efficiency?
In an isochoric process, heat is added to 10 mol of monoatomic ideal gas whose temperature increases from 273 to 373 K. What is the entropy change of the gas?
A Carnot engine operates in a Carnot cycle between a heat source at 550 and a heat sink at 20 . Find the efficiency of the Carnot engine.
Check Your Understanding A Carnot engine operates between reservoirs at 400 and 30 . (a) What is the efficiency of the engine? (b) If the engine does 5.0 J of work per cycle, how much heat per cycle does it absorb from the high-temperature reservoir? (c) How much heat per cycle does it exhaust to the cold-temperature reservoir? (d) What temperatures at the cold reservoir would give the minimum and maximum efficiency?
A Carnot engine is used to measure the temperature of a heat reservoir. The engine operates between the heat reservoir and a reservoir consisting of water at its triple point. (a) If 400 J per cycle are removed from the heat reservoir while 200 J per cycle are deposited in the triple-point reservoir, what is the temperature of the heat reservoir? (b) If 400 J per cycle are removed from the triple-point reservoir while 200 J per cycle are deposited in the heat reservoir, what is the temperature of the heat reservoir?
A Carnot engine working between two heat baths of temperatures 600 K and 273 K completes each cycle in 5 sec. In each cycle, the engine absorbs 10 kJ of heat. Find the power of the engine.
Suppose 20 g of ice at 0 is added to 300 g of water at 60 . What is the total change in entropy of the mixture after it reaches thermal equilibrium?
Does the entropy increase for a Carnot engine for each cycle?
Discuss the change in entropy of a gas that expands (a) at constant temperature and (b) adiabatically.
The gasoline internal combustion engine operates in a cycle consisting of six parts. Four of these parts involve, among other things, friction, heat exchange through finite temperature differences, and accelerations of the piston; it is irreversible. Nevertheless, it is represented by the ideal reversible Otto cycle, which is illustrated below. The working substance of the cycle is assumed to be air. The six steps of the Otto cycle ale as follows: i. Isobaric intake stroke (OA). A mixture of gasoline and air is drawn into the combustion chamber at atmospheric pressure P0 as the piston expands, increasing the volume of the cylinder from zero to VA . ii. Adiabatic compression stroke (AB). The temperature of the mixture rises as the piston compresses it adiabatically from a volume VA to VB . iii. Ignition at constant volume (BC). The mixture is ignited by a spark. The combustion happens so fast that there is essentially no motion of the piston. During this process, the added heat Q1 causes the pressure to increase from pB to pc at the constant volume VB(=Vc) . iv. Adiabatic expansion (CD). The heated mixture of gasoline and air expands against the piston, increasing the volume from VC to VD . This is called the power stroke, as it is the part of the cycle that delivers most of the power to the crankshaft. v. Constant-volume exhaust (DA). When the exhaust valve opens, some of the combustion products escape. There is almost no movement of the piston during this part of the cycle, so the volume remains constant at VA(=VD) . Most of the available energy is lost here, as represented by the heat exhaust Q2 . vi. Isobaric compression (AO). The exhaust valve remains open, and the compression from VA to zero drives out the remaining combustion products. (a). Using (i)e=W/Q1; (ii)w=Q1Q2; and (iii)Q1=nCv(TCTB),Q2=nCv(TDTA), Show that e=1TDTATCTB. (b). Use the fact that steps (ii) and (iv) are adiabatic to show that e=11r1 where r=VA/VB . The quantity r is called the compression ratio of the engine. (c) In practice, r is kept less than around 7. For larger values, the gasoline-air mixture is compressed to temperatures so high that it explodes before the finely timed spark is delivered. This preignition causes engine knock and loss of power. Show that for r=6 and =1.4 (the value for air), e=0.51 , or an efficiency of 51%. Because of the many irreversible processes, an actual internal combustion engine has an efficiency much less than this ideal value. A typical efficiency for a tuned engine is about 25% to 30%.