1. A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of 10 nA. Solve for the following: a. the diode current at room temperature b. the reverse current when the temperature increased to 50 °C

1. A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of 10 nA. Solve for the following: a. the diode current at room temperature b. the reverse current when the temperature increased to 50 °C

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: 1. A coil with 1.0 mH inductance and 2.0 N series resistance is connected in series with a capacitor...

Q: Given the operation of sinusoids. 20 sin 400: + 10 cos(400r + 60%) – 5 sin/400 – 20-) a. Solve using...

Q: * what ---- their phone number?( are, is, does, have) are is O does O have O

A: It is given that: What -------- their phone number?

Q: C3 C4 C1 C2 C6 C9 C8

A: Given breadboard connections are

Q: INPUTS OUTPUTS O, O, 1 1 1 1

A: The standard form of a decoder n×2n n = number of input 2n = number of output ...

Q: 1Ω (a)

Q: a lossless transmission line, determine the value of the input impedance given: = 25 +j72, Zo = 452,...

Q: choose the right answer and show your solution 5. THREE CAPACITORS HAVING THE SAME CAPACITANCE (C = ...

A: In this question we need to find a total capacitance and voltage across each capacitor.

Q: Assume that there is a Fourier series converging to the function f(t) defined by the graph below -3 ...

Q: 3. A3 (W,X, Y, Z) = IM(0,5,7,10, 14, 15) + d(4,8, 11, 13) a. Using a Karnaugh-map, find the minimal ...

Q: Three infinite uniform sheets of charge are located in free space as follows: -7 nC

Q: Given the potential difference between the terminals of a battery as 6 Volts, calculate the number o...

A: Given the potential difference between the terminals of a battery as 6 Volts, calculate the number o...

Q: What is the total capacitance of capacitors connected in series? A. The total capacitance is the sam...

A: Option : C ( answer )

Q: In the figure below, what value of RS will provide an LED current of 20 mA?

A: Replace the red LED with its voltage drop and apply ohm's law to find the value of the resistor to a...

Q: Ro Rs -1 V Figure P5.43

A: Finding The Source Voltage Vs

Q: The MOTOROLA MRD821 photodiode has an optimum wavelength of 940 nm. Determine the optimum operating ...

Q: The infrared frequency spectrum falls between 30 and 400 THz. Determine the range of wavelength fro ...

A: As we know that the relationship between wavelength and frequesncy is given as Wavelength(x)= 1/freq...

Q: The maximum value of the sinusoidal voltage wave generated in one coil of an alternator is 12v. How ...

Q: 4) A 40-kW induction motor, with a lagging power factor of 0.76 is supplied by a 120-Vrms, 60-Hz sin...

Q: Question 1. A periodic signal r(t) has the Fourier series represntation 12nt 5+ jn r(t) 1+ The input...

A: Given: A periodic signal x(t) has the Fourier series representation: xt=1+∑n=-∞∞15+jnej2nt The input...

Q: choose the right answer and show your solution 5. THREE CAPACITORS HAVING THE SAME CAPACITANCE (C = ...

A: In this question we need to find a total capacitance of the given circuit.

Q: 5.2. Determine Vout as a function of I (provided by a current source) and the resistor values for ea...

A: Given op amp circuit shown

Q: Determine Vo and I pfor the networks 20 V 12 V Si Ge Şi GaAs V 4.7 k2 2.2 k2 4 V (a) (b)

A: (a) The network is shown below: In the above circuit, one of the diodes is the Si diode while the ...

Q: choose the right answer and show your solution A.) CALCULATE THE ENERGY STORED IN A CAPACITOR IF THE...

A: I am answering only energy of capacitor other part is not complete. As we know that the energy in ca...

Q: Example: Suppose that an analog signal is given as x(t) = 5cos (2n x 10 t) and is sampled at the rat...

Q: Given į =-10 sin(3t-85degree) e. Find the Frequency of the current f. Calculate at i at t= 2 ms.

Q: a) Design the 4-bit R-2R ladder network D/A converter shown in Figure 2(a) such that Vo = -5 Vref at...

Q: Determine the magnitude of the current through the capacitor in the circuit below. VT = 97V RMS, ZT ...

Q: Obtain the Norton equivalent at terminals a-b of the circuit in Fig. 13.85.

A: The Norton equivalent current can be obtained by applying kirchhoff's voltage law to the loop after ...

Q: Q6/ A 10-poles, 3-phase alternator is coupled to an engine running at 600 r.p.m. It supplies 3- phas...

Q: 1.82 In the circuit of Fig. P1.82 let R, R, = 13 kN. (a) Assuming the Zener diode has V, = 5.1 V and...

A: Answer -

Q: Calculate the voltage at the node

Q: z? X(z) = (z-0.5)(z-1)2

Q: (a) 0; (b) 0+; (c) 1.3 ms. 250 n 600 0 100 n t=0 4 uF 1250 1 2 kn E 400 1 120 V IFIGURE 8.23 Ans: 10...

Q: For a particular n-channel MOS technology, in which the minimum channel length is 0.2 μm, the associ...

Q: Q2. Explain the effect of changing excitation (normal, under and over-excitation) on a synchronous m...

Q: voltmeter

A: 5.Given-For short shunt method-Voltmeter reading= 250 VVoltmeter resistance= 5 kohmResistance value=...

Q: What is the equation of half adder with inputs X, Y, Z (carry in) and outputs C carry out using a NA...

Q: Voltage input Vin R = 10kN sin(2n X 8t) C = 10µF

A: The given circuit is an RC circuit, with a sinusoidal supply. So, here two types of response exist ...

Q: PROBLEM 4.1 Consider the circuit containing a nonlinear element N as shown in Figure 4.54. The v-i r...

A: The operational point of technical equipment is a precise point within its functioning characteristi...

Q: AM signal from a PAM signal

A: If an input signal's height varies with the loudness of a user's voice and then adds this to the car...

Q: Design 0-9 counter with JK flip-flp a) Draw the state diagram b) Draw the state table c) Draw t...

A: 0-9 counter means it is UP counter. Some points regarding up counter: (1JK flip-flop used different ...

Q: 2. A sensor gives output in the range 20.0 to 250 mV as the process variable varies over its range. ...

A: Op-amp- An op-amp is a very high gain DC amplifier designed to provide low input voltage offset erro...

Q: C1 5nF R1 R2 12ko 12ΚΩ AMP SIMP C2 5nF V1 1Vpk OHz-10kHz 0° RA 30KQ RB :112kΩ ..... . ... . .... .

Q: Question #3.2 Consider a compensated n-type silicon at 300K having a conductivityo=16 /NCm and Na=10...

Q: 4.41 Determine the equ a 32 20

Q: Discuss the effect of the sensor position in the pt326 controller on the open-loop system response (...

A: The process contained in the pt326 involves air that is drawn from the atmosphere by a centrifugal b...

Q: C1 L1 4.3µ 7.7m =>f = 23 kHz V1 C2 R1 6.8k 5.9µ AC 0.84 0 R2 140

Q: 1. A power transformer rated 7MVA, 34.5 kV/230 V is connected delta-delta.What is the current of the...

A: The solution is given below

Q: The characteristic equation of a control system is given as 1 + KG (s) H (s) = s +8s2 + 10s + K = 0,...

A: Given: Characterstic equation:1+KG(s)H(s)=s3+8s2+10s+K=0

Question

1. A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of
10 nA.
Solve for the following:
a. the diode current at room temperature
b. the reverse current when the temperature increased to 50 °C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
What is the difference between a diode and rectifier?
What is CEMF?
A silicon diode has a reverse saturation current of 1.17 nA and forward bias voltage of 0.4 mA at a temperature of 25°C, find d. The ideality factor; e. The Thermal Voltage; a. The forward bias current
Suppose we have a junction diode operating at a constant temperature of 300 K. With a forward current of 1 mA, the voltage is 600 mV. Furthermore, with a current of 10 mA, the voltage is 700 mV. Find the value of n for this diode.
If the current flowing through a P-N junction diode increases 10 times what is the increase in diode voltage? Assume forward-biased Si diode operating at room temperature
The diode current in a p-n junction is modeled exponentially (given below.) When the p-n junction is polarized with 0.7V and 0.75V, the currents flowing through the diode are again measured on the basis of 1.36 mA and 7.20 mA. Accordingly, what is the ideality factor? (Note: Take the thermal voltage as mV)
A diode with n =1.6 conducts 45 mA at 0.75V at room temperature. Find the saturation current Is at room temperature (using the exponential model).
A silicon diode has a reverse saturation current of 1.17 nA and forwards bias voltage of 0.4 V at a temperature of 25°C, find a) The ideality factor; b) The Thermal Voltage; c) The forward bias current
With constant current flowing in the forward direction in a small-signal silicon diode, the voltage across the diode decreases with temperature by about 2 mV/K. Such a diode has a voltage of 0.650 V, with a current of 1 mA at a temperature of 25°C. Find the diode voltage at 1 mA and a temperature of 175°C.
In the circuit shown, determine the current flowing through the resistor R1. (Use 2nd approximation and assume all diodes are silicon for all the problems)
Find the value of dc and ac resistance of a Germanium junction diode if the temperature is 25 degree Celcius, Reverse Saturation Current is 20 microAmperes and applied voltage of 0.1V.