1. a) The plates of a Fabry-Perot interferometer are coated with silver of such a thickness that for each plate the reflectance is 0.9, the transmittance is 0.05, and absorption is 0.05. Find the maximum and minimum transmittance of the interferometer. b) Find the resolving power of the above Fabry-Perot interferometer if the plate separation is 1 cm and the wavelength is 500 nm.

1. a) The plates of a Fabry-Perot interferometer are coated with silver of such a thickness that for each plate the reflectance is 0.9, the transmittance is 0.05, and absorption is 0.05. Find the maximum and minimum transmittance of the interferometer. b) Find the resolving power of the above Fabry-Perot interferometer if the plate separation is 1 cm and the wavelength is 500 nm.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Millimeter-wave radar generates a narrower beam than conventional microwave radar, making it less vulnerable to antiradar missiles than conventional radar. (a) Calculate the angular width 20 of the central maximum, from first minimum to first minimum, produced by a 220 GHz radar beam emitted by a 54.0-cm-diameter circular antenna. (The frequency is chosen to coincide with a low-absorption atmospheric "window.") (b) What is 20 for a more conventional circular antenna that has a diameter of 1.64 m and emits at a wavelength of 1.6 cm?
If you check the voltage at one-half wavelength from the end of an RF transmission line, what voltage would you measure? A. Peak B. Infinite C. Minimum D. Zero
A 9GHz signal propagates inside the rectangular waveguide that is filled with lossy dielectric material with dielectric conductivity 10-15 mhos/m, dielectric permittivity 2.2 and dielectric permeability 1.0. Use the appropriate formula to determine the guide attenuation factor if the cutoff frequency is 4.5GHz.
A radar antenna used for both transmitting and receiving has a gain of 200 at itsoperating frequency of 9GHz.it transmits 100KW and is aligned for maximumdirectional radiation and reception to a target 2 km away having a radar cross sectionof 3 m2.The received signal matches the polarization of the transmitted signal. Find thereceived signal.
A radar antenna used for both transmitting and receiving has a gain of 150 at itsoperating frequency of 5 GHz.it transmits 100KW and is aligned for maximumdirectional radiation and reception to a target 1 km away having a radar cross sectionof 3 m2.The received signal matches the polarization of the transmitted signal. Find thereceived signal
A satellite at an altitude of 37654 km transmits a signal of 17 GHz to a ground station directly below it. The following data is given. • Total atmospheric losses = 40dB • Transmit antenna gain = 55dBi • Receiver antenna gain = 60dBi • Signal to noise ratio of received signal = 6dB • Receiver signal noise power = 25pW • Receiver sensitivity = -90dBW I. Calculate the power transmitted. II. Find the Fade Margin for the link and comment on your result.
An antenna, having a directive gain of 2.5 dB is radiating at a wavelength of 1 m. What will be the effective aperture of the antenna?
1. Which is not true regarding SPR biosensors? It allows real-time monitoring of bioaffinity interactions Refractive Index changes with different media and when molecules are immobilised or displaced from the surface It is label-free Angle is identified from the spot on the detector array where there is a sudden increase in the intensity of the reflected light 2. It represents the repolarization of the ventricles, where the reduced electrical signal increases from its previously lowered position to a peak. Q wave T wave R wave S wave
Solve the this problem and drawing the radiation patern. lesson: Antenna Propagation
Calculate the numerical aperture of A step-index fiber has specified parameters for a refractive index of fiber core and cladding as 1.50 and 1.46, respectively.
A geo-synchronous satellite is transmitting a TV signal to an earth based station at a distance of 40,000km. Assume that the dish antennas of the satellite and the earth station have the diameter of 0.5m and 5m, and aperture efficiency of 60%. If the satellite’s transmitted power is 6W and the downlink frequency is 4 GHz, calculate the antenna gain in dB and the amount of received power.
1. In a Long range microwave communication system operating at a 9GHz, the transmitting and receiving antennas are identical and are separated by 10000 meter. To meet the signal to noise ratio of the receiver the received power must be at least 10µw.Assuming the two antennas are aligned for maximum reception to each other including being polarization matched, what should the gains (in dB) of transmitting and receiving antennas be when the input power to the transmitting antenna is 10W