Find VDc if VAN = VBN = VCN= 120 volts... Half-wave Three-phase Rectifier Conduction Waveform Periodic Time (T) A B 180 350 90° 450 540 time 270 VAN VeN VAN VEN Voc 30 120 150 270 390 510 time Output Voltage Waveform B

Q: 2. A 100-hp, three-phase, wye-connected, 50-Hz, 470-V, four-pole, cylindrical-rotor synchronous moto...

A:

Q: Two alternators A and B operate in parallel and supply a load of 15MW at 0.5 power factor lagging. a...

A: It is given that: Total load=PT=15 MW=15×106 WPower factor=cosϕT=0.5 laggingso, ϕT=cos-10.5=60°

Q: The rating of transformer is a) kW b) kVA c) KVAR d) V

A: From the given options we need to determine that that rating of transformer is given in which units.

Q: Question # 3 For given circuit, Vs = 25 Volts, R1 = 22002, R2 = 25,0002, R3 = 10002, R4 = 50,0002, R...

A: Current and voltage division is an important techniques to find the current in parallel branches and...

Q: Determine Vout in the following circuits with R, = R, =R3 = 1 k2, V, = 10 V, and V2 = 5 V. Assume id...

A:

Q: Given a one line diagram below. Determine the Apparent power and power factor of Alternator A. A 4,5...

A:

Q: A dc Shunt machine has amature and field vEGistances of 0.025w Ond 80w respectively When comected to...

A: In this question we need to find a speed of dc machine when running as motor .

Q: 6. A 125 kVA transformer having a primary voltage of 2000 V at 50 Hz has 182 primary turns and 40 se...

A: In this question, =  Primary voltage Vp= 2000V Primary side , Number of turn N1= 182 Secondary side,...

Q: (*- z) if 0 <rS 2r, f(x) = f(r +27) otherwise. Find its Fourier series.

A: We need to find Fourier series coefficient for given signal

Q: Find the resultant angle when given a pure sine phasor with magnitude 10 and a pure cosine phasor wi...

A: In this question, Find the resultant angle when given a pure sine phasor with magnitude 10 and a pur...

Q: 1.- Consider the following circuit. Find the equivalent impedance between nodes: 200 a) a and g b) b...

A:

Q: Find the no-laad phase and line valtapge of a star- Comected. 4-pole altemator having flux per pole ...

A: GIVEN: double layer winding             flux=0.15             slots per pole per phase (m)=4        ...

Q: series circuit consists of a resistance of 10 ohms and a reactance of 5 ohms. Find the equivalent va...

A: We need to find out conductance and susceptance

Q: 3. Tristate buffers can also be used for bi-directional bus operation. This is the ability to transm...

A: Control system: In a system when the output quality is controlled by varying the input quality, the ...

Q: Given the circuit fed by 50HZ voltage source Vs, knowing that Z, is an inductive load with 0.8 power...

A:

Q: Please show a complete solution to the problem 7. A 100-hp, three-phase, wye-connected, 50-Hz, 450-...

A:

Q: Construct digital circuit for Boolean expression Q=A’B+C using only NAND gates.

A:

Q: By adopting COSINE as the base function for phasors, what part of the Euler's identity is used? A ca...

A: In this question we need to choose a correct option.

Q: percent

A:

Q: write verilog code for following 2 to 4 decoder yı yo 3. 2 tou91 decoder 0 0 -

A: In this question we have to write the verilog code for 2 to 4 decoder

Q: One branch A of a parallel circuit consists of a 60-µF capacitor. The other branch B consists of a 3...

A: Kirchoff's law and ohms law are the two important tools to analyze the electrical circuits. Accordin...

Q: An inductor (L = 390 mH), a capacitor (C = 4.43 µF), and a resistor (R = 400 $2) are connected in se...

A:

Q: When investigating the charging/discharging mode of the RC Circuit, do you think the internal resist...

A: Solution - When capacitors and resistors are interconnected, the resistor prevents the transfer of c...

Q: 8.6 Find values of ve and v, in the circuit of Fig. 8.23 at t equal to (a) 0; (b) 0; (c) 1.3 ms.

A:

Q: Ax = 2 N, Ay = -8 N , Az = 5 N Find: a) 4 ; b) A, ; and c) Au

A:

Q: The voltage applied to a coil having R = 200 ohms, L= 638 mH is represented by e= 20 sin 100 pi × t....

A:

Q: 10 ohm resistor is connected in parallel with an inductive reactance of 10 ohms. The combination is ...

A: We need to find out resonance frequency for given circuit.

Q: The infrared frequency spectrum falls between 30 and 400 THz. Determine the range of wavelength fro ...

A: As we know that the relationship between wavelength and frequesncy is given as Wavelength(x)= 1/freq...

Q: What is the MUX1 select input while the "sltu" instruction is executing?     01     00     10 ...

A: Answer - C - 10

Q: n ful-load. develope a useful torque of 162n-r nd it is observed that the rotor electramotive ford a...

A: Solution- Ns =120×506= 1000rpmslip speed = 90 rpms=901000 =0.09Nr = 1000-90 =910 rpm Pshaft out = 16...

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and b if R...

A:

Q: 50 Hz, 250 V single phase power line has the following loads placed across it in parallel; 4 kW at a...

A: Using power triangle relations find  active and reactive power of each load then add them to get tot...

Q: R + R R R-Ar R vo Find the expression for the gain, = f(R, Ar), using an ideal op amp model. vs

A:

Q: A- What is the total cost of using the following at 6c per kilowatthour? (5 a) 1200 W air conditione...

A:

Q: 8. Determine the truth table of the digital eircuit shown in the figure below and explain its operat...

A: We need to find out logic Operation of given circuit

Q: Calculate the currents through and voltages over C1,C2,L1,R1 and R2

A:

Q: 1. One of the complicated parts of solving for the input impedance is the hyperbolic tangent of the ...

A:

Q: Point charges of 16 μC, -22 μC, and 3 μC are located at (-1, 3, -8), (1, 4, 9), and (5,9,8) respecti...

A:

Q: 2K blue IK R R Sr wr

A: We should the find the value of voltage across resistor ,VR.

Q: A particular MOSFET has VA = 10 V. For operation at 10 μA and 100 μA, what are the expected resistan...

A:

Q: b) Determine the slew rate and 3 dB frequency from the graph shown in Figure 2(b). V (mV) 850 190% 1...

A:

Q: An unbalanced, three-phase, delta-connected load, is supplied by an alternator three-phase system gi...

A:

Q: What is the equation of half adder with inputs X, Y, Z (carry in) and outputs C carry out using a NA...

A:

Q: Determine the magnitude of the current through the capacitor in the circuit below. VT = 97V RMS, ZT ...

A:

Q: the circuit includes a 48-volt power supply and three resistors r1-250 ohms r2= 250 ohms r3=375 ohms...

A:

Q: The plot shows the location of poles for a second-order system. If the poles move from position 1 to...

A: The plot shows the location of poles for a 2nd order system. If the poles moves from position 1 to p...

Q: A 2.5 kVA, 200V/40V single-phase transformer has the primary resistance and reactance of 3 and 12 Q,...

A:

Q: Two 75 MVA 3-phase alternator are connected in parallel. The speed load characteristic of the first ...

A:

Q: 1. Given i =-10 sin(31 – 85°) a. Convert to cosine form. p. Transform to phasor c. What is the ampli...

A: Given current equation, i=-10 sin3t-85°

Q: (a) 0; (b) 0+; (c) 1.3 ms. 250 n 600 0 100 n t=0 4 uF 1250 1 2 kn E 400 1 120 V IFIGURE 8.23 Ans: 10...

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.