1. An AC generator has 85 rectangular loops on its armature. Each loop is 11 cm long and 8 cm wide. The armature rotates at 1500 rpm about an axis parallel to the long side. If the loop rotates in a uniform magnetic field of 0.8 T, which is perpendicular to the axis of rotation, what will be the maximum output voltage of this generator? Volts

1. An AC generator has 85 rectangular loops on its armature. Each loop is 11 cm long and 8 cm wide. The armature rotates at 1500 rpm about an axis parallel to the long side. If the loop rotates in a uniform magnetic field of 0.8 T, which is perpendicular to the axis of rotation, what will be the maximum output voltage of this generator? Volts

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 67AP: A coil with 50 turns and area 10cm2 is oriented with its plane perpendicular to a 0.75-T magnetic...

See similar textbooks

Similar questions

A magnetic field of magnitude 0.300 T is oriented perpendicular to the plane of a circular loop. (a) Calculate the loop radius if the magnetic flux through the loop is 2.70Wb. (b) Calculate the new magnetic flux if the loop radius is doubled.
A 120-V, series-wound dc motor draws 0.50 A from its power source when operating at full speed, and it draws 2.0 A when it starts. The resistance of the armature coils is 10 , (a) What is the resistance of the field coils? (b) What is tire back emf of the motor when it is running at full speed? (c) The motor operates at a different speed and draws 1.0 A from the source. What is the back emf in this case?
Unreasonable Results The 335 kV AC electricity from a power transmission line is fed into the primary coil of a transformer. The ratio of the number of turns in the secondary to the number in the primary is Ns/Np = 1000. (a) What voltage is induced in the secondary? (b) What is unreasonable about this result? (c) Which assumption or premise is responsible?
A 75-turn, 10.0 cm diameter coil rotates at an angular velocity of 8.00 radius in a 1.25 T field, starting with the plane of the coil parallel to the field. (a) What is the peak emf? (b) At what time is the peak emf first reached? (c) At what time is the emf first at its meet negative? (d) What is the period of the AC voltage output?
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
The healing coils in a hair dryer are 0.800 cm in diameter, have a combined length of 1.00 m, and a total of 400 turns. (a) What is their total self-inductance assuming they act like a single solenoid? (b) How much energy is stored in them when 6.00 A flows? (c) What average emf opposes shutting them off if this is done in 5.00 ms (one-fourth at a cycle for 50 Hz AC)?
An 820-turn wire coil of resistance 24.0 is placed on lop of a 12 500-turn, 7.00-cm-long solenoid, as in Figure P20.57. Both coil and solenoid have cross-sectional area of 1.00 104 m2. (a) How long does it take the solenoid current to reach 0.632 times its maximum value? (b) Determine the average back emf caused by the self-inductance of the solenoid during this interval. The magnetic field produced by the solenoid at the location of the coil is one-half as strong as the field at the center of the solenoid. (c) Determine the average rate of change in magnetic flux through each turn of the coil during the stated interval. (d) Find the magnitude of the average induced current in the coil. Figure P20.57
What is the peak emf generated by a 0.250 m radius, 500turn coil is rotated one-fourth of a revolution in 4.17 ms, originally having its plane perpendicular to a uniform magnetic field. (This is 60 rev/s.)
(a) A bicycle generator rotates at 1875 rad/s, producing an 18.0 V peak emf. It has a 1.00 by 3.00 cm rectangular coil in a 0.640 T field. How many turns are in the coil? (b) Is this number of turns of wire practical for a 1.00 by 3.00 cm coil?
The 4.00 A current through a 7.50 mH inductor is switched off in 8.33 ms. What is the emf induced opposing this?
A 2.00-m length of wire is held in an eastwest direction and moves horizontally to the north with a speed of 0.500 m/s. The Earths magnetic field in this region is of magnitude 50.0 T and is directed northward and 53.0 below the horizontal. (a) Calculate the magnitude of the induced emf between the ends of the wire and (b) determine which end is positive.
A coil with 50 turns and area 10cm2 is oriented with its plane perpendicular to a 0.75-T magnetic field. If the coil is flipped over (rotated through 180°) in 0.20 s, what is the average emf induced in it?