1. At +20V, what is the output Clamper Circuit for numbers 1 to 4. voltage? O 48V -28V Vin Vout OV BV -10V O 20v 2. At-10V, what is the output 3. At OV, what is the output voltage? voltage? O 28V O -48V O 18V O 28V O 38V O 18V O -8V O 38V

Q: (b) Compare and construct the band energy diagram of conductor, insulator and semiconductor material...

A: In conductors, insulators, and semiconductors, the " Band theory " explains the electronic conductiv...

Q: Emitter-Bias Configuration 8. For the emitter-stabilized bias circuit of Fig. 4.122, determine: IBC ...

A:

Q: I need help sloving for I2 1100I2 - (3300)(10 + 3300I2)/4500 = - 10

A: To solve for I2 from the given equation 

Q: 3. A series circuit consists of a (4.7k , 5.6k2 , 9k2 and 10k2 ) resistor. Which resistor has the mo...

A: Given            The series circuit consists of 4.7 kΩ,5.6 kΩ,9kΩ and 10 kΩ    

Q: An analog voltmeter is used to measure voltage of 60V across a resistor.         The reading value ...

A: The error between the actual value to the measured value can be analysed with the help of various er...

Q: QUESTION 2 a) Consider the grain supply bin as shown in Figure Q2a. The control system is to maintai...

A: CLOSED-LOOP SYSTEM    Closed-loop system in which the control action is dependent on the output. The...

Q: Find the unknown currents 'I2' and 'I5' if l1 = 9 A, I3 = 4 A and l4 = 3 A. %3D

A: To solve above problem, we will use Ohm's law and Kirchhoff's law: Ohm's law state that in a current...

Q: Q4: Draw the sketch of the following signal: a) u(t +4) u(-t +4) b) r(t) – 2r(t – 1) + r(t – 2)

A:

Q: Draw and explain the block diagram of the temperature measurement system using RTD.

A: RTD- RTD is the acronym for Resistance Temperature Detector. It has a positive value of temperature ...

Q: A band stop filter is designed to stop or eliminate all frequencies within a band of frequencies, 0j...

A:

Q: A brass wire, that has a cross sectional area of 0. 12m² and its resistance is 80µ ohms. Find the vo...

A:

Q: 2. Calculate the total resistance of the circuit below and its total current. R1 3 R4 6 R7 9 R5 12 R...

A:

Q: 5. A long copper wire carries a current of 20A which is evenly distributed in each cross-section of ...

A: It is given that: I=20 AD=4mmr=2mmresistance per unit length=5Ωkm=5×10-3Ωm

Q: 400V 50HZ system connected to a full controlled rectifier through a delta to star transformer. The r...

A:

Q: 1.Draw the DC equivalent circuit. 2.Draw the fixed bias base emitter circuit. Derive IB. 3.Draw fixe...

A: The given amplifier circuit is an Emitter biased CE amplifier. The required circuit and parameter ca...

Q: With suitable sketch ,explain in detail the calibration procedure of differential pressure transmitt...

A: Differential Pressure Transmitter- Differential pressure transmitter is a device which is used measu...

Q: Find I, in the network in the figure using mesh analysis. Io 6 kN 4 kN +) 20 V 6 V 6 kN Io (+)

A:

Q: 1. Determine the current flowing to the resistive network below if the supply is 12V. Solve for the ...

A:

Q: What do you think is the effect of high temperature to metallic conductor?

A: Note that the metallic conductor have positive temperature coefficient as the temperature increases ...

Q: (a) A pitot-static probe shown in Figure 1 is a device that can be used to measure flowing liquid or...

A: Answer - 

Q: VCC +3 V Rc RB 1.8 k. 33 kN BpC = 90

A: Collector to Base Bias circuit The supply to the base terminal is given from the collector terminal ...

Q: A short circuit test was performed on a 20 kVA, 2000/200 V single-phase transformer, with the second...

A: Given data : Power loss in copper Pcu= 300 W Irated=20,00200=10A V=100V

Q: 1. A certain communication system is defined by following impulse response n h(n) = и(п) + и(-п - 1)...

A:

Q: a 12 ohms resistor is connected in parallel with a series combination of 8ohm and 16ohms. if the dro...

A:

Q: A series circuit consisting of a variable resistor in series with a capacitance of 80UF is connected...

A: Power observed in resistor = current2×resistance.  First calculate expression for current in terms o...

Q: Is 0.2 2 1.8 Ω I'R m IM 0.32 VS(LN) 250 2 40 Q S Given the above approximate equivalent circuit for ...

A: The solution is given below 

Q: s(s Figure Q.3a (i) Determine the gain K for the system operates (ii) Determine the range of gain K ...

A:

Q: Apply DeMorgan's Theorem to the following expressions 1. ((A + B)' + C')' 2. ((A' + B) + CD)' 3. (A ...

A: In this question we need to apply Demorgan theorem in the given expression.

Q: 3. The figure below shows two tiny charged spheres q1 = +5 µC and q2 = -7.5 µC separated by 8.0 cm. ...

A:

Q: 1. Determine Vo for each of the circuit shown below 22 ka Si SV 10 V 1.2 ka 4.7 ka -10 V (a) (b)

A: The solution is given below 

Q: given the following points: A(3,-2,0) B (4,5,2) C (-3,2,1) Determine RAB ⋅ RAC

A:

Q: Domain sampling theory tells us that:  the more items you have, the higher utility you have the mo...

A: Domain Sampling Theory- Domain sampling theory tells that the selected item of any test is consider ...

Q: A 5-hp 230-volt shunt motor takes 18 amp when operating at full load. The shunt field resistance is ...

A:

Q: Fill in the VIR chart for the circuit below.  I need to also reduce the original circuit to a single...

A:

Q: Using 8-bit 2's compliment number, add 14 and -29 together, then verify the result.

A: First convert the 14 and -29 into the 8 bit binary form obtain the 2's completement of the -29 perfo...

Q: 1. Find the z transform and the ROC of the following signals a. x[n] = ("u[n – 3] b. x[n] = "u[n] + ...

A: The solution is given below 

Q: a. Vrms = 120445°,Z = 35 +30j Determine the Real Power, Reactive Power, Complex Power, Apparent Powe...

A: This question belongs to basic electrical . It is about calculation of different types of power when...

Q: Find the voltage at node P in the figure shown.

A: The given circuit is shown below:

Q: Evaluate the following and write it in rectangular form a.) j7 (-5+j2)  b.) (1-j5)(-9+j2) c.) (4+...

A:

Q: Three Inductive loads each of resistance R = 28 ohms and inductance L = 0.03 H are connected in star...

A: GIVEN:                  R=28ΩL=0.03HV=430VF=50Hz FIND: (1) Inductive reactance            (2) imped...

Q: R Si

A:

Q: b) Consider the object shown in Fig. 1(b). Calculate: i. The length of CD ii. The surface area ABCD ...

A:

Q: Three capacitors C1 C2 and C3 whose values are 10 µF. 5 µF. and 2 µF respectively, have breakdown vo...

A: This question belongs to circuit theory . It is about breakdown voltages of the capacitors when capa...

Q: 7. z (A+B'C)' 8. x= (A+C(B)(A+B) X= A tB AB 00 01 11 10 9. x= (A+B+C+D'{(A+B)(C+D) 10. z (A)(B)(A'+B...

A: This question belongs to digital electronics . It is based on demorgans' law for simplification of B...

Q: For the given circuit, the Thevenin voltag at the terminals a-b is: 1Ω 1 H ww o a rell 5 cos t V (+ ...

A: Given circuit shown 

Q: The Wheat stone Bridge circuit is used to measure the unknown resistance Rx. At balance condition, ...

A: Wheatstone bridge is an arrangement for calculating  the value of unknown resistance by connecting f...

Q: A 60 W power transistor is to be cooled by attaching it to a heat sink. Calculate the maximum therma...

A: Thermal resistance = (temperature difference)/ power loss. Use above formula to find maximum thermal...

Q: The equivalent decimal number for the binary number 1010.1010 is ____________. a. 13.625 b. 12.625 c...

A: The given binary number is: 1010.10102    

Q: The two-stage amplifier employed a FET source-follower configuration prior to a voltage divider conf...

A:

Q: Using mesh analysis, calculate the mesh currents /, and 1, of the network. Use the measured resistor...

A: The mesh analysis is used to find the unknown mesh current by applying Kirchhoff's voltage law to th...

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.