What do you think is the effect of high temperature to metallic conductor?

Q: Vipk R Vo Vị E -Vipk'

A:

Q: If the memory chip below is used in a system with a 16-bit address bus, then address lines A13 – A15...

A: According to the question, we need to find the address range.

Q: The duty cycles for 3rd harmonic injection PWM is given by: da = ki sin(wt)+k2 sin(3wt) 1 + 2 kį sin...

A: Given: The duty cycle for 3rd harmonic injection PWM is given by: dA=12+k1sinωt+k2sin3ωt2dB=12+k1sin...

Q: 3. Solve for the total resistance of the network below. 4Ω

A: In this question we will find total resistance of circuit....

Q: A coil has X, = 1000 Q and 5 N internal resistance. Its Q is equal to ?

A: solve above ques.....

Q: A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resisto...

A: This question belongs to circuit theory . It is based on the relation between r.m.s. and maximum val...

Q: Find I, in the network in the figure using mesh analysis. Io 6 kN 4 kN +) 20 V 6 V 6 kN Io (+)

A:

Q: You are installing a feeder to a 200 amp 3Phase/4 wire Panel board. What size conductors are you goi...

A: It is given that a feeder is being installed to a 200 amp 3 Phase/4 wire Panel board. We need to cal...

Q: Solve for the currents in various branches of the circuit shown in the figure below: V1= 25 V; V2= 1...

A: Given circuit, V1=25 VV2=10 V

Q: Consider the following system [コu4) y - [I 2]X find the response Componding to {ult)= I and X(6)= [!...

A: Solve the problem

Q: 2. what is the maximum input voltage in Figure 1 to maintain the output voltage to 10 V without dama...

A: At maximum source voltage , zener diode will draw maximum current . 

Q: A. The field winding of a DC generator is wound with 900 turns and has a resistance of 50 ohms. If t...

A:

Q: 5. Find i(t) in the circuit. i(t) 1.5 kN 40 sin 3000t V ell

A: This question belongs to circuit theory . It is about calculation of current in the circuit by calcu...

Q: C(s) function, T(s) R(s) G2 R(s) G1 G3 G5 C(s) H1 G4 Figure Q.1

A:

Q: Three Inductive loads each of resistance R = 28 ohms and inductance L = 0.03 H are connected in star...

A:

Q: (a) Determine the DC voltage VCE- (b) Determine hie. (c) Determine the equivalent resistance Ro' (d)...

A:

Q: The resultant DC signal from a half-wave rectifier circuit was investigated, the following trace was...

A:

Q: Determine Rx and Ry if Ix=160 Ampere and Iy=140 Ampere 2. Determine the Total Power of the circuit

A:

Q: Draw the circuits for the below functions: F(X, Y, Z) = XY + Z F(X, Y, Z) = Y + Z̅ X F(X, Y, Z) =...

A: The solution is given below 

Q: A balanced 3 phase star connected load draws power from a 410 V supply. Two wattmeter's indicate 920...

A: Here, we have given some information about the balanced three-phase star-connected load.  the load i...

Q: Find the following: a) Impulse response b) Step response c) Ramp response    show full solution

A: The solution is given below 

Q: Measure the current through R3. List the result as I. R1 R2 1K 0.33K A R3 + Е1 0.5K E2 9V 9V +

A:

Q: A short circuit test was performed on a 20 kVA, 2000/200 V single-phase transformer, with the second...

A: Given data : Power loss in copper Pcu= 300 W Irated=20,00200=10A V=100V

Q: Given that A = 2ax – az, B = 3ax + ay and C = - 2ax + 6ay – 4a

A: It is given that: A=2ax-azB=3ax+ayC=-2ax+6ay-4az    

Q: For the given circuit    (A) Find the TOTAL IMPEDANCE Zr in polar form, the CURRENT I and the VOLTA...

A: Power Factor- Power factor is defined as the ratio of active power to apparent power. P.F.=Cos∅=Acti...

Q: Q3 / calculate the voltage across AB in the network shown in fig.(3) and indicates the polarity of t...

A:

Q: ix Device 11. A device is shown, with reference polarities for voltage and current, in Figure 1. A p...

A:

Q: For the current shown in the figure below, find the charge waveform and then find the value of charg...

A: The solution is given below 

Q: \Design a decade Counter as an Asynchronous Counter

A:

Q: The equivalent decimal number for the binary number 1010.1010 is ____________. a. 13.625 b. 12.625 c...

A: The given binary number is: 1010.10102    

Q: 2. The manufacturer of a 9[V] flashlight battery says that the battery will deliver 20[mA] for 80 co...

A:

Q: 5. By applying Mesh analysin, find current in the 150 resistor of the network shown in Fig 15 10 200

A: 5. The given circuit is,  

Q: Use Thevenin's theorem to find the current flowing in the 142 resistor of the network shown in the f...

A: Please find the detailed solution in below images

Q: 10.6 Determine V, in Fig. 10.55. + ll 20 Ω 20 2 0.2V j10 2 60/0° V ell

A: The given circuit is,  

Q: Two batteries, A and B, are connected in parallel, and an 80W resistor is connected across the batte...

A:

Q: Find the value of R2 in the diagram if the bridge is balanced. R- 20 0 of the Birst wire air t R= 35...

A:

Q: Find vo using Superposition in the circuit:

A: Here, we have given an electrical circuit having no. of resistors, one voltage source and two curren...

Q: Sketch the atomic structure of copper and discuss why it is a good conductor and how its struc-ture ...

A: Why copper is good conductor  So the atomic number of copper is 29 It has 2 electron in innermost sh...

Q: For the given network diagram find the current and voltage across R1, L1, R2 and C2 using any method...

A: Brief description: In the above given AC circuit we need to compute the value of current & volta...

Q: QUESTION 2 a) Consider the grain supply bin as shown in Figure Q2a. The control system is to maintai...

A: CLOSED-LOOP SYSTEM    Closed-loop system in which the control action is dependent on the output. The...

Q: 2. Draw a circuit schematic indicating how you will connect your DC power supply to provide +8 V,-8V...

A: Brief description:  Note : Since the above mentioned questions are not interlinked to each other, he...

Q: Determine the range of valus of A that will maintain the 2tener diode of the ct belowin the n state ...

A:

Q: In Fig. 35.15, the d.c. level of Ig is (tran- sistor is of silicon) B = 90 %3D RB 240 k2 RE 2 k2 VEE...

A: The solution is given below 

Q: 1 Use the inverse Fourier sine transformation to find f(x) from F (a)= ,a>0 a

A: We need to find the inverse Fourier Transform of Fs(α)=1αe-aα , a>0  

Q: 4. Consider the data below From (bus) To (bus) x (inductance) B (susceptance) 1 2 0.25 1 4. 0.4 1 0....

A: Given  The data flow  From(bus) To(bus) X(Inductance) B(susceptance) 1 2 0.25   1 4 0.4   1...

Q: 1. A point charge, -3µC is placed at the point (0,2) m while a charge +2µC is placed at (2,0) m. Fin...

A: Brief description: In the given question they have mentioned two point charges of having charge 2 u ...

Q: Find /and Vo in the given circult. Assume R= 60 0. R 24 2 50 Ω ww ww 25 2 20 V 20 2 30 Ω 60 Q ; 20Ω ...

A: Given 20Ω is parallel to 60Ω=20×6020+60=15Ω  

Q: Three Inductive loads each of resistance R = 28 ohms and inductance L = 0.03 H are connected in star...

A:

Q: 1.a. A fiber optic cable has a minimum bend radius of 8 cm and will be mounted in an expansion loop ...

A:

Q: Question 1: Determine the 3-db bandwidth for the following signal: (a) g(t)-exp(-alt|)

A: Brief description: In the given question they have mentioned a continuous time domain on periodic si...

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.