1. Com plete the data below for the experiment: Measurement ENGLISH (inch) 1/16 METRIC ( cm) Smallest scale division No. of vernier scale division Least count of caliper Length of cylinder Diameter of cylinder Volume of cylinder 0.1 10 77/96 65/96 In 1.99 1.73 cm Therefore: one inch True Value 1 in'=16 3871 cm³ 1 in16.3871 cm Amount of error Percent error

1. Com plete the data below for the experiment: Measurement ENGLISH (inch) 1/16 METRIC ( cm) Smallest scale division No. of vernier scale division Least count of caliper Length of cylinder Diameter of cylinder Volume of cylinder 0.1 10 77/96 65/96 In 1.99 1.73 cm Therefore: one inch True Value 1 in'=16 3871 cm³ 1 in16.3871 cm Amount of error Percent error

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter1: Introduction: The Nature Of Science And Physics

Section: Chapter Questions

Problem 7PE: Mount Everest, at 29,028 feet, is the tallest mountain on the Earth. What is its height in...

See similar textbooks

Similar questions

A house is 50.0 ft long and 26 ft wide and has 8.0-ft- high ceilings. What is the volume of the interior of the house in cubic meters and in cubic centimeters?
Answer each question yes or no. Must two quantities have the same dimensions (a) if you are adding them? (b) If you are multiplying them? (c) If you are subtracting them? (d) If you are dividing them? (e) If you are equating them?
Answer each question yes or no. Must two quantities have the same dimensions (a) if you are adding them? (b) If you are multiplying them? (c) If you are subtracting them? (d) If you are dividing them? (e) If you are equating them?
If you live in the United States, you probably know your height in feet and inches. In other countries, metric units are commonly used for measuring such quantities. First, find your height in inches. Then determine your height in a. centimetens and b. meters
Answer each question yes or no. Must two quantities have the same dimensions (a) if you are adding them? (h) If you are multiplying them? (c) If you are subtracting them? (d) If you are dividing them? (e) If you are equating them?
Suppose the three fundamental standards of the metric system were length, density, and time rather than length, mass, and time. The standard of density in this system is to be defined as that of water. What considerations about water would you need to address to make sure that the standard of density is as accurate as possible?
When non-metric units were used in the United Kingdom, a unit of mass called the pound-mass (lbm) was employed, where 1 lbm = 0.4539 kg. (a) If there is an uncertainty of 0.0001 kg in the pound-mass unit, what is its percent uncertainty? (b) Based on that percent uncertainty, what mass in pound-mass has an uncertainty of 1 kg when converted to kilograms?
Assume it takes 7.00 min to fill a 30.0-gal gasoline tank, (a) (Calculate the rate at which the tank is filled in gallons per second. (b) (Calculate the rate at which the tank is filled in cubic meters per second. (c) Determine the time interval, in hours, required to fill a 1.00-m3 volume at the same rate. (1 U.S. gal = 231 in.3)