1. Complete the diagrams (. a. Draw the internal normal force diagram of the rod. (* 3 kN 6 kN 2 kN SkN В b. Draw the internal torque diagram of the shaft. 600 N-m 200 N-m 200 N-m 200 N-m B c. Draw the shear and moment diagrams for the beam. A a 2. A frame is subjected to a force F of 30 kN, and the cross sectional areas of rod 2 is equal to 5x10 m'. Determine the average normal stress in rod 2. Take 0 = 30° .

1. Complete the diagrams (. a. Draw the internal normal force diagram of the rod. (* 3 kN 6 kN 2 kN SkN В b. Draw the internal torque diagram of the shaft. 600 N-m 200 N-m 200 N-m 200 N-m B c. Draw the shear and moment diagrams for the beam. A a 2. A frame is subjected to a force F of 30 kN, and the cross sectional areas of rod 2 is equal to 5x10 m'. Determine the average normal stress in rod 2. Take 0 = 30° .

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

What is the Maximum moment in kN-m. Given: W = 10, a = 2, b = 6, and P = 50.
9.Calculate the shear at right end of span BC in kN.0
Draw the shear and moment diagrams for the shaft, and determine its required diameter to the nearest 14 in. if sallow = 30 ksi and tallow = 15 ksi. The journal bearings at A and C exert only vertical reactions on the shaft. Take
Rod AB is fixed to a smooth collar D, which slides freely along the vertical guide. Determine the internal normal force, shear force, and moment at point C, which is located just to the left of the 60-lb concentrated load.
Set P=0.6 kN and w=1.20 kN/m. Consider A is a roller support and B is a pin support. Illustrate the shear and moment diagram of the beam below.
The shaft is supported by a smooth thrust bearing at A and a smooth journal bearing at B. Draw the shear and moment diagrams for the shaft (a) in terms of the parameters shown; (b) set w = 500 lb/ft, L = 10 ft.|
The shaft is supported by a journal bearing at A and a thrust bearing at B. Determine the normal force, shear force, and moment at a section passing through (a) point C, which is just to the right of the bearing at A, and (b) point D, which is just to the left of the 3000-lb force.
Draw the Shear and Moment Diagram of the beam with the values: P=2 L=0.61
Calculate the shear at right end of span BC in kN.0
Ans - Normal force is -41.25 kN. Also find moment at C.
Solve Prob. 7.53 when 0=60°.(Reference to Problem 7.53):Two small channel sections DF and EH have been welded to the uniform beam AB of weight W = 3 kN to form the rigid structural member shown. This member is being lifted by two cables attached at D and E . Knowing that 0= 30° and neglecting the weight of the channel sections, (a) draw the shear and bending-moment diagrams for beam AB, (b) determine the maximum absolute values of the shear and bending moment in the beam.
1. Calculate the maximum positive moment in span BC in kN.m.0