1. Consider an ideal Carnot Cycle with water as the working fluid using operating conditions shown. a. Complete the following chart with relevant state properties. Turbine Temperature (°C) Entropy (kJ/kg K) Pressure Boileri State Quality (bar) Cooling water Pump Condenser 50 0.50 3 0.50 50 Sketch the process on a T-s diagram, including the liquid-vapor dome. How much work per kg of flow does the turbine produce, in kJ/kg? How much total work per kg of flow does the entire cycle produce, in kJ/kg? b. с. d. What is the thermal efficiency of the cycle? How would you expect that thermal efficiency to change for a Rankine cycle operating similarly, but with state 3 a saturated liquid at the same pressure, and state 4 a compressed liquid at the same pressure? Would it increase, decrease, or stay the same? Explain. е. f. 1. 4.

1. Consider an ideal Carnot Cycle with water as the working fluid using operating conditions shown. a. Complete the following chart with relevant state properties. Turbine Temperature (°C) Entropy (kJ/kg K) Pressure Boileri State Quality (bar) Cooling water Pump Condenser 50 0.50 3 0.50 50 Sketch the process on a T-s diagram, including the liquid-vapor dome. How much work per kg of flow does the turbine produce, in kJ/kg? How much total work per kg of flow does the entire cycle produce, in kJ/kg? b. с. d. What is the thermal efficiency of the cycle? How would you expect that thermal efficiency to change for a Rankine cycle operating similarly, but with state 3 a saturated liquid at the same pressure, and state 4 a compressed liquid at the same pressure? Would it increase, decrease, or stay the same? Explain. е. f. 1. 4.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In thermodynamic cycles explain adiabatic and isobaric. And state thier differences.
Two reversible cycles operate between hot and cold reservoirs at temperatures TH and TC, respectively. (a)If one is a power cycle and the other is a refrigeration cycle, what is the relation between the coefficient of performance of the refrigeration cycle and the thermal efficiency of the power cycle? (b)If one is a refrigeration cycle and the other is a heat pump cycle, what is the relation between their coefficients of performance?
Part C only A gas-turbine power generator operates on an ideal air-standard Brayton cycle 1 → 2 → 3 → 4 shown in Fig. 1. The gas temperatures at the compressor inlet, compressor exit, and turbine inlet are T1 = 300 K, T2 = 600 K, and T3 = 1200 K, respectively. Solve Part C below using the variable specific heat assumption. Part C - Determine the heat input qin in the process 2 → 3, the work wC used by the compressor, and the work wT produced by the turbine per kg of air.
PART B ONLY A gas-turbine power generator operates on an ideal air-standard Brayton cycle 1 → 2 → 3 → 4 shown in Fig. 1. The gas temperatures at the compressor inlet, compressor exit, and turbine inlet are T1 = 300 K, T2 = 600 K, and T3 = 1200 K, respectively. Solve the problem below using the variable specific heat assumption. PART B - Determine the pressure ratio rp = P2/P1 and the temperature at the turbine exit, T4 (in K).
Rannkin cycle 1_The value of enthalpy at point 1 is ( h1 =?) 2_ value of enthalpy at point 2 is ( h2 =?) 3_ value of enthalpy at point 3 is ( h3 =?) 4_value of enthalpy at point 4 is ( h4 =? 5_ value of steam mass flow rate in kg/s is 6_rate of heat supplied7_ power developed by Turbine (WT) in kW is : 8_ Thermal efficiency of Rankine cycle is:
THERMODYNAMICS Consider an air-standard Otto cycle with a heat addition of 800 Btu/bm of air, a compression ratio of 7, and a pressure and temperature at the start of the compression process of 13 lbf/in2, 50 F to simulate an actual spark-ignition engine. Determine the maximum pressure and temperature of the cycle, the thermal efficiency of the cycle, and the mean effective pressure assuming the variation of specific heat with the value from table A-19E Show Complete solution on a paper.
Steam is the working fluid in the ideal Rankine cycle 1–2–3–4–1 and in the Carnot cycle 1–2–3’–4’–1 that both operate between pressures of 1.5 bar and 60 bar as shown in the T–s diagram in Fig. below. Both cycles incorporate the steady flow devices shown in Fig. For each cycle determine (a) the net power developed per unit mass of steam flowing, in kJ/kg, and (b) the thermal efficiency. Compare results and comment.
Q#1. A gas-turbine plant operates on the regenerative Brayton cycle, the schematic diagram of whichis shown in Fig. Q 1, with two stages of reheating and two-stages of intercooling between the pressure limits of100 and1200 kPa . The working fluid is air. The air enters the first and the second stages of the compressor at 300 K and 350 K , respectively, and the first and the second stages of the turbine at 1400 K and 1300 K , respectively. Assuming both the compressor and the turbine have an isentropic efficiency of 80%. The regenerator has an effectiveness ofεregen=75% . Assume variable specific heats (i.e., use the concept of relative pressures) and the intermediate pressuresof intercooling and reheating is the square root of the product of inlet and exit pressures for intercooling and reheating. Make other the necessary assumptions and determine(a) the back work ratio,β , and the net work output,, wnet(b) the thermal efficiency (that is the first-law efficiency,ηi ) and(c) the…
PART D only A gas-turbine power generator operates on an ideal air-standard Brayton cycle 1 → 2 → 3 → 4 shown in Fig. 1. The gas temperatures at the compressor inlet, compressor exit, and turbine inlet are T1 = 300 K, T2 = 600 K, and T3 = 1200 K, respectively. Solve PART D below using the variable specific heat assumption PART D - Evaluate the thermal efficiency η of the cycle and the back work ratio rBW = wC/wT.
With ph, ts diagram A refrigerator based on ideal vapor compression cycle operates between the temperature limits of -20 deg C and 40 deg C . The refrigerant enters the condenser as saturated vapor and leaves as saturated liquid . The enthalpy and entropy values for saturated liquid and vapor at these temperatures are given in the table below: T(OC) hf (KJ/kg) hg (KJ/kg) Sf (KJ/kg.K) Sg (KJ/kg.K) -20 20 180 0.07 0.7366 40 80 200 0.3 0.67 If the circulation rate of the refrigerant is 0.025 kg/sec , the refrigeration effect is equal to A) 1.2 kW B) 2.5 kW C) 3.2 kW D) 2.1 kW
In a simple Rankine cycle, the steam throttled condition is 8 MPa and 480 °C. The steam is then reheated to 2 MPa and 460 °C. If turbine exhaust is 60 °C. Determine: Heat Added Turbine Work Heat Rejected Pump Work Net Work Efficiency, in % Use: 8 MPa and 480 C (Table 3. Vapor) h1 = 3348.4 kJ/kg s1 = 6.6586 kJ/kg – K 2 MPa (Table 3. Vapor; note: s1 = s2) h2 = 2963.145 kJ/kg 2 MPa and 460 C (Table 3. Vapor; note: s3 = s4) h3 = 3379.5 kJ/kg s3 = 7.3147 kJ/kg – K 60C (Table 1. Saturation Temperatures) P5 = 0.019940 MPa = 19.94 kPa hf = 251.13 kJ/kg = h5 hfg = 2358.5 kJ/kg sf = 0.8312 kJ/kg – K sfg = 7.0784 kJ/kg – K vf = 0.0010172 m3/kg = v5 Solving for h4 s3 = s4 = sf + xsfg 7.3147 kJ/kg – K = 0.8312 kJ/kg – K + x (7.0784 kJ/kg – K) x = 0.9159555832 h4 = hf + x(hfg) h4 = 251.13 kJ/kg + 0.9159555832 (2358.5 kJ/kg) h4 = 2411.411243 kJ/kg Solving for h6 h6 = v5 (P6 – P5) + h5 h6 = 0.0010172 m3/kg (8000 kN/m2 – 19.94 kN/m2) + 251.13 kJ/kg h6 = 8.117317032 kJ/kg + 251.13 kJ/kg…
Thermodynamics Answer the following questions with complete solutions. write legibly An engine operates with air on the cycle shown with isentropic processes 1 - 2 and 3 - 4, and constant volume processes at 2 - 3 and 4 - 1. If the compression ratio (r) is 12, the minimum pressure is 200 kPa, and the maximum pressure is 10 MPa, determine the net cycle work (Wcycle) in terms of the final volume of isentropic compression process (V2). (Note: r = V1/V2 = V4/V3).