1. Determine the dynamic (ac) resistance of thediode at a forward current of 10 milliAmpereusing the equation below.26 mVr'd%3DIDThe dynamic (ac) resistance (in ohms) is(put values only, put up to 2decimal places)

Answered: Image /qna-images/answer/264073bf-1bcd-4132-af09-e62a2c075a15.jpg

Answered: 1. Determine the dynamic (ac)…

1. Determine the dynamic (ac) resistance of the diode at a forward current of 10 milliAmpere using the equation below. 26 mV Ip The dynamic (ac) resistance (in ohms) is (put values only, put up to 2

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter8: Electromagnetism And Em Waves

Section: Chapter Questions

Problem 21Q

See similar textbooks

Related questions

Q: 1.4 Analyze the circuit shown in Figure 1.35. Assume circuit and diode parameters of VDD=5V, R=5kQ,…

A: Kirchhoffs Voltage Law or KVL, states tha the algebraic sum of all voltages within the loop must be…

Q: Do Impurities are desired in any type of diodes? Explain

A: The material whose conductivity lies between the conductor and insulator is known as the…

Q: 1. Determine the static or dc resistance of the commercially available diode at a forward current of…

A: this question is about to find dc resistance.

Q: Activity 1: A rectifier circuit is used to charge a 12 Vde battery using a 40 Vp-p AC source,…

A: Here we will use "Power Electronics " concept. Consider output with 'R-E' Load . Diode will only do…

Q: Q4: Consider a Zener diode with a nominal voltage (10v @ 10mA) and a resistance of 50 ohm. Calculate…

Q: 1-At room temperature (VT = 26) what will be the approximate value of resistance diode when n=1 and…

A: (1). Given values, VT=26n=1I=100 mA = 100×10-3 Aby this formula R=n.VTIR=1×26100×10-3 AR=260 ohms

Q: Fully explain a p-type semiconductor, including which element is used as an example

Q: EXAMPLE 25 The potential difference across the collector of a transistor, used in common emitter…

Q: Question 11: A p-n photodiode is fabricated from a semiconductor with band gap of 2.8 ev. Can it…

A: Given value--- energy band gap = 2.80 eV. wavelength = 6000 nm. We have to find--- can it detect…

Q: Q3A sample of silicon 2volt is impressed of it has 0.25mm long and area (0.25x.3mm ) the current…

Q: Silicon is doped with 3×1017 arsenic atoms/cm3. (a) Is this n-or p-type silicon?(b)What are the hole…

Q: In the circut shown in Figure 3 ynu repince the z 1l renistor betaeen points band dwtha 1.52…

Q: 10. What are the emitter, collector, and base in a transistor?

A: we know that transistor is made of by 3 parts 1)Emitter: Emitter terminal is the heavily doped…

Q: I want the detailed Procedure for this Experiment P-N JUNCTION DIODE CHARACTERISTICS

Q: 1. What are the two conditions under which a diode is operated? 2. Under what condition is a diode…

A: A diode is a semiconductor material which has region and region.

Q: Calculate the thermal voltage of a diode at room temperature about 27°C . Calculate diode dynamic…

A: A) The thermal voltage , is defined as Vth = kTq where k is Boltzmann's constant, T is the absolute…

Q: 3- What will be the diode resistance if the current in the circuit is zero? 4-Using the ideal diode…

A: a) As the current in the circuit is zero, there will be no flow of charge. So, definitely there will…

Q: 1. Deduce the band structures of a diode and solar cell based on P-N junction.

Q: What do you mean by power dissipation in the zener diode?

Q: 4. Someone proposes to make a new LED using gallium and antimony. What would you predict about its…

A: The bandgap energy of a semiconductor is related to its composition. The important trend that can be…

Q: 2 ki Question-2: For the circuit shown: (Answer five only) + 10 V- Iz * Vz- SV 10 1. Which diode…

Q: What is PN Junction diod? Explain the formation of depletion region in PN Junction diode.

Q: 1. Determine Vrout for the circuit in below and draw Vours assume the diode is the silicon type. R…

A: As the diode is one way allowance device because for other half diode will be in reversed bias so no…

Q: 1. For an n-channel silicon FET with a = 3x 10*cm, Np = 10'electrons/cm', and the relative %3D…

Q: 2. Calculate the Fermi energy for the valence electrons in sodium metal given that the valency of…

A: Fermi energy; EF=h28π2m3π2n2/3 ANS: The fermi energy is 5.073×10-21 Joule or 0.032 eV

Q: Q/ Put (T) in Front of the Correct Sratement and an (F) in Front of the incorrect Statement. 1.…

A: (As per the guidelines, we are supposed to answer only the FIRST THREE questions. So please don't…

Q: Explain in your own understanding why Semiconductors are Negative Temperature Coefficient…

A: To describe: Semiconductors have negative temperature coefficient for resistance.

Q: Q6:- (a) Using diode equation, determine the diode current at 20°C for a silicon diode with n=2,…

A: Q6. (a) The relation between temperature in kelvin and the temperature in Celsius is: Therefore,…

Q: A common emitter amplifier circuit, built using an npn transistor, is shown in the figure. Its dc…

A: Given Dc current gain = 250 Rc = 1kohm Vcc = 10 volt

Q: 1. Describe forward bias of a diode.

Q: Roll no =24 Determine the minimum and the maximum load currents for which the zener diode in Figure…

Q: Q 5 / Explain the mechanism of the work of the field-effect transistor FET and the metal-oxide…

A: A FET is worked as a conductive semiconductor channel with 2 contacts – the ‘SOURCE ‘ and the…

Q: Q2. If the band gap of silicon is 1.1 ev, show that green light (^ = 5 x 10-7 m) can excite…

A: The wavelength of the green light is λ=5×10-7 m, The energy is 1.1 eV, the energy in joules is 1.1…

Q: One of the success of the free :electron model that it could describe Differences between insulator,…

A: The free electron model states that the valence electrons of the constituent atoms of the crystal…

Q: 5. Determine the current I for each of the configurations of Fig. 2.155 using the approximate…

Q: 2. Is it necessary to add a series resistance with the diode or not? Explain why?

A: A series resistance is necessary in forward bias because it cannot overflow the current. The maximum…

Q: Q. 1. When a transistor is used in CB circuit, current gain is 0-987. If it is used in common…

A: Given data: - The current gain when a transistor is used in CB circuit is α = 0.987.

Q: 2. If the conductivity of the pure Germanium change with temperature according the fol- lowing…

A: If Eg = band gap of germanium T is temp K = Boltzmann constant = 1.38*10^(-23) Conductivity…

Q: 5- In real diode the Velution Ship between Cuvvent diede and feveword voltoge is-

A: For real diode we have Ir'drop with V0 barrier potential.

Q: 4. What is the average zero point energy of electrons in metals?

A: In this question we have to answer what is zero-point energy. Please give positive feedback if the…

Q: 5- In real diode the relationshiP between current diode and Rore word Voltageis

A: 1 If temperature increase, the reverse saturation current in silicon diode increases. This is…

Q: 06:- (a) Using diode cquation, determine the diode current at 20°C for a silicon diode with n-2,…

A: (a) The relation between temperature in kelvin and the temperature in Celsius is: Therefore, the…

Q: 1. Determine Vpout for the circuit in below and draw Voas assume the diode is the silicon type. R 10…

A: When a diode is forward biased, it acts as a short circuit. When a diode is reverse biased, it acts…

Q: 1-At room temperature (VT = 26) what will be the approximate value of resistance diode when n=1 and…

Q: 4-Using the ideal diode model of a silicon diode and taking E=10 V and R=1k, what is the value of…

A: Using the approximate equivalent model silicon diode (vr =0.7 V) E=10V, R=1K ohm We have to use…

Concept explainers

Microscopic view of current

In physics, the term current is expressed as the rate of flow of electric charges across the area per unit time (I=q/t). It propagates along in the direction of the motion of positive charges. When the current is caused by the motion of electrons, the direction of the current is opposite to the flow.

Question

1. Determine the dynamic (ac) resistance of the
diode at a forward current of 10 milliAmpere
using the equation below.
26 mV
r'd
%3D
ID
The dynamic (ac) resistance (in ohms) is
(put values only, put up to 2
decimal places)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Saltwater contains an equal number of positive and negative ions. When saltwater is flowing through a pipe, does it constitute an electric current?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A simple electric circuit consists of a constant-voltage power supply and a variable resistor. What effect does reducing the resistance have on the current in the circuit and on the power output of the power supply?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A 20-A fuse in a household electric circuit burns out. What catastrophe could occur if it is replaced by a 30-A fuse?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Explain what current, resistance, and voltage are.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Alternating current with a frequency of 1 million Hz flows in a wire. What in particular could be detected traveling outward from the wire?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Explain how electromagnetic waves are a natural outcome of the principles of electromagnetism.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . There are two basic methods for connecting more than one electrical device in a circuit. Name, describe, and give the advantages of each.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . If a new material is found that is a superconductor at all temperatures, what parts of some common electric deices would definitely not be made out of it? Explain.
A copper transmission cable 34 km long and 19.5 cm in diameter carries a current of 11 A. How much electrical energy (in MJ) is dissipated as thermal energy in 9 hours? Note: = 1.72x10-8 m show the complete and organize solution and dont round off show the final asnwer in 4 decimal places if possible
A Van de Graaff generator (see Problem 24) produces a beam of 2.00-MeV deuterons, which are heavy hydrogen nuclei containing a proton and a neutron. (a) If the beam current is 10.0 A, what is the average separation of the deuterons? (b) Is the electrical force of repulsion among them a significant factor in beam stability? Explain.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . A power supply is connected to two bare wires that are inserted into a glass of saltwater. The resistance of the water decreases as the voltage is increased. Sketch a graph of the voltage versus the current in the water showing this type of behavior.
Imagine a company offering a line of hair dryers that operate on different voltages, say, 12, 30, 60, and 120 V. Assume that all of the dryers are rated at 1,200 W and find the current that would flow in each as it operates. What would he different about the heating filament wires and the motors in the various hair dryers?