1. Determine the operating point of the diode in figure 14 below and compute the power output of the 12 V battery. The I-V graph of the 1N914 diode is given in figure 15. Hint: Find the Thevenin equivalent seen by the diode and use a load line to find the Q- point. Once you find the diode current and voltage, you can solve for the current through the battery to find the power output. R1 R3 2 I 500 200 .V1 =12 V R2 100 D1 1N914 V R4 200 Figure 14. Simple circuit with one diode

Q: 2. The current flowing in a circuit containing four resistors connected in series is I = 1.0A. The p...

A:

Q: Emf = 8.8V, r = 1.46 ohms, E = 887.6 Joules, t = 2.1hour  What is the V(terminal) and the Current f...

A: All  u need to know are the fundamental formulas and relationships

Q: complete solution

A:

Q: Using Multisim, design RC HPF considering R=5KN, C=4nano farad. Simulate the design and find out cut...

A:

Q: 1. Using Superposition theorem, solve for current I ww ww. 12V 2A I

A:

Q: 2 of 15 02:45/02:30 Determine the equivalent resistance across the terminals. 30 36 72 9. II

A: Given ; all resistance value are given Calculate the value of equivalent resistance.

Q: Your task The initial design for the pin fin has been suggested. This states that the pin fin should...

A: The answer is

Q: The forward path transfer functlon of unity feedback control system is given by Obtain an expression...

A:

Q: 1. Determine the resistance of a conductor 0.10m long, with a uniform diameter of 1.0 cm and having ...

A: Given A conductor ofLength L=0.1 m=0.1×100 cm=10 cmDiameter D=1 cmResistivity ρ=0.003+10-4 L2 ohm-cm

Q: Refer to the circuit. Consider ideal model Vp=0) of diode circuits. (Express your answers in 2 decim...

A: The given circuit is positive clamper circuit .we need to find out output voltage when diode is off ...

Q: 2. In terms of general dielectric permittivity tensor, describe the linear, nonlinear media. For the...

A: The Answer is

Q: For the circuit shown below (B1-B2-150), determine: - 1. the de values (V1. V82, Ves, Vez, VE1, VEz,...

A: DC analysis - The DC operating points of circuits are calculated using DC analysis. DC simulation ma...

Q: Design synchronous mod 5 counter State table, K-map, boolean equations, and logic circuit. (coding ...

A:

Q: s + 2 F (s) = (s +2)² + 10²

A:

Q: From the following test results, determine the voltage regulation of a 346 kVA, 2,000V, 3 phase Y al...

A:

Q: Q1: Determine the value of capacitance required in the shunt arm of a low pass T section if the indu...

A: Given, The shunt arm of a low pass T section has, Inductance in each of the series arms, L/2 = 40 mH...

Q: Transform v(t) = -4sin (30t + 50)V to phasor. Express v(t) = 7 cos (2f + 40) to phasor Find the sinu...

A:

Q: Let f(t) be a periodic function with period T=4, where f (t) = |t|, -2 <t < 2. Which of the followin...

A:

Q: 1. Determine lç. Express your answer in mA. 2. Determine VCE 3. Plot the quiescent point for the cir...

A:

Q: Find I total R total V across each resostor I in each resistor R5 R8 R1 R3 R9 0.Sn 0.52 R2 R4 12V 0....

A:

Q: In the given circuit, what resistor R will absorb maxium power and what is this power? R is equal to...

A:

Q: Problem 1: Given the unity feedback system in the figure below, where K(s+6) (s+2)(s² + 10s +29) G(s...

A:

Q: 4 2 1Ω ЗА 16 2 10 N Vo 12 V

A: Thevenins equivalent circuit 

Q: Convert the Hexa number (E4)16  to Decimal number. a. 229 b. 230 c. 227 d. 228

A: Given number  A = ( E4 ) 16 We have to convert it into decimal  Steps  Find the sum of multiplicati...

Q: 2. Use superposition theorem to calculate the current and voltage drop across the 3 ohm resistor. O ...

A:                          Fig: Given circuit Case 1: when upward 15A current source is ON  In the mo...

Q: Determine lo of Figure 3 42 10Ω 8Ω 60 V 3i, Figure 3 ww

A: Given

Q: Consider the system i = Ax + Bu, y = Cx with 1 -1 A = 1 -1 ‚B= ,C = [1 0 0] 1 1 Design a controller ...

A:

Q: DETERMINE THE RESISTANCE BETWE TERMINALS A and B 702 A LAAA 202 40오

A:

Q: A pure sinusoidal current is being rectified. For the given maximum value of half wave rectified cur...

A: Given: Half wave rectified current is Irms=50 A    

Q: Problem no.2 The Boolean Function: F(X,Y,Z) = Em(1,3,4,5,6,7) Need to be represented in a K-map %3D ...

A: K-map 

Q: 3. Find for the Norton Equivalent or find Vth, Rn and In of the Circuit at a) Terminals a-b and b) T...

A:

Q: What electric field is necessary to drive a 8.0 A current through a silver wire 0.75 mm in diameter?...

A: Given: Current through silver wire is I=8.0 A Diameter of wire is d=0.75 mm

Q: In the following figure, rate the points a, b, c & d in the order of increasing Electric Potential (...

A: The Order of increasing electric potential (lower potential to higher potential) is given by     a&l...

Q: For this Assessment, design an armature winding with the following information: 1. your choice of wi...

A: For the design we assuming following parameters 1) winding : Lap 2) simplex 3) Number of slots : 20 ...

Q: Transform v(t) = -4sin (30t + 50)V to phasor. %3D Express v(t) = 7 cos (2t + 40) to phasor Find the ...

A: Given:  Note: Please note that here we have considered the phase of the given functions are in degre...

Q: Problem (3) Find Vo 4Ω 2 H ll lll 16 sin 47 V 1Ω 2 cos 4t A 6Ω ww

A: given

Q: Identify the number of symbols used in BCD code. a. 16 b. 8 c. 2 d. 10

A:

Q: 9. Four cubic meters of water is to be heated by means of four 1.5kw, 230V immersion heating element...

A:

Q: QUESTION 1 What is the built-in voltage in an abrupt pn junction with p-side doping of 8.1*10^14/cc ...

A: Givendonor concentration(ND)=8.1*1014/ccacceptor concentration=6.25*1014/cctemperature=300 Kintrinsi...

Q: 8. From the circuit shown, determine the resistance between terminals a and b 42

A: First we will name the nodes and than we will redraw the circuit and than we will find equivalant re...

Q: s+3 (s+1)(s+2) G(s)= s+4 s+1

A: The given transfer matrix is: G(s)=s+3s+1s+2s+4s+1  

Q: Fd he Theucnin equivalent extanal to RL in the ciranit · Uhe the equivalont oirauit to pund Va and R...

A:

Q: using initial value theorem find value of f(0).

A: Given function, Fs=s+2s+22+102

Q: Calculate the total impedance. R1 200 R2 R4 200 20Ω L2 L1 C2 j5 j10 -j5 C1 E- j10 Lightshot

A: Given  The impedance circuit find the total impedance. 

Q: Determine Reg in Ohms at the (a,b) terminals for the following circuit. Round your answer to the nea...

A:

Q: Use a computer algebra system to find u x v and a unit vector orthogonal to u and v. u = 7.1k V = 4....

A: Given vectors, u=7.1kv=4.3i+7k

Q: 1. Superposition Method. Determine the voltages at the 5-ohm resistor due to the 24-Volt, 38-Volt an...

A:

Q: The switch in this RC circuit has been closed for a long time, and it is opened at t=0. Find v(t) fo...

A: Since the switch in the RC circuit had been closed for a long time, so the circuit can be drawn as: ...

Q: Using nodal analysis estimate Vị and v2 in circuit shown below.

A: First, convert the circuit into the frequency domain. Identify the nodes Label the node voltages wit...

Q: n Volts for the following circuit. Round your answer to the nearest tenths).

A: Perform the following steps to solve the given example using nodal analysisIdentify the nodesLabel t...