1. each pane in a double-hung wood window measures 20" x 16". calculate the rough opening for this window.   a. 26" x 42"   b. 22" x 50"   c. 38" x 50"   d. 52" x 42"

Q: 5. Suggest a tool to be used when installing formwork for a thick wall to hold the two sides of the…

A: In building, formwork refers to using support structures as well as castings to produce structures…

Q: what is the maximum elevation of the top of the pipe?

A: Givendata: G1 = -2.00%     G2 = 4.00%     A = 6.00% Length of curve = 420 m PVI at station = 160+00…

Q: In a 5.00m x 7.00m room, compute the number of tiles necessary to cover the floor if the tiles to be…

A: Size of floor=5*7m Size of tile=25*25cm

Q: Describe about the Sliding Block Analysis.

A: The sliding block analysis method used by the Newmark is an engineering which determines permanent…

Q: The singly reinforced concrete beam section shown in the figure (not drawn to the

A:

Q: At roof slab level over the DPC, are provided.

A: Answer: A : Tiles Tiles are provided to reduce the dampness.

Q: To make a peg adjustment, the following notes were taken. Wye level at 1 Wye level at 2 Rod reading…

A:

Q: Dimension of the exterior ceiling is 4 - 1.00m x 15.00m. How many pieces of plywood is necessary to…

A: Size of ceiling=1*15m

Q: A rough opening for a window measures 36 3/8 inches. The window to be placed in the rough opening…

A: given data:

Q: What distance does the block slide before stopping?

A: This question has been taken from engineering mechanics. The  explanation is given below:

Q: In a 5.00m x 7.00m room, compute the number of tiles necessary to cover the floor if the tiles to be…

A: Size if room=5*7m Size of tile=30*30cm

Q: ped general house.

A:

Q: 2. The gate shown opens when the water reaches a certain height. Determine that height. 5 ff Hinge 4…

A: Given:- The gate is shown which opens when the water reaches a certain height To determine:- The…

Q: Q5/ In the plan below there is a Spiral stair, the distance between slabs is 3m, there is the space…

A: Solution:-The Given data is shown below,The  Height between slabs H = 3 m  Radius  R = 100 cm  The…

Q: Question #12 Determine the centerline length_{wall is 600 mm thick, Ø=20800 not R) 7600 7400 |-…

A: thickness of wall, t = 600mm Diameter of semicircle, ∅ = 20800mm

Q: figure, Draw up a level book page and reduce the levels by the height of instrument method.

A:

Q: Q5/ In the plan below there is a Spiral stair, the distance between slabs is 3m, there is the space…

A: Solution:-Given values are as follow The height between slabs H = 3 m The  Radius  R = 100 cm  The…

Q: A wall of 5 m x 2 m contains a window of area 2 m2. The SRIS are : 50 dB for the brickwork and 18 dB…

A:

Q: In an 6.00m x 12.00m room, compute the number of tiles necessary to cover the floor if the tiles to…

A: The flooring is a significant piece of any inside plan, which is the reason at whatever point a…

Q: 10. Which among the following is used to determine the angle of repose?

A: Angle of repose Minimum angle at which body kept on inclined plane starts sliding due to its own…

Q: flowchart detailing the deisgn of One-way Slab

A: One-way Slab: - It is a slab in which longer span is equal or greater than 2 times of shorter span…

Q: If 2x8 wall studs were requested to be installed for a 90' long wall, what would be the number of…

A: Given data: Length of the wall = 90' = 12 x 90 =1080" Spacing = 24"

Q: External wall 2x4 sill plate runs along the perimeter 6m 1.5m 2m 2x4 studs spaced at 300mm o.c. 0 25…

A:

Q: Pls provide an isometric drawing for a gatehouse with an inclined roof and rectangular gateway…

A: Brief concept introduction- Isometric drawing- Isometric drawing is a type of three-dimensional…

Q: To make peg adjustment, the following notes were taken: Wye Level at 1 Wye Level at 2 Rod reading at…

A:

Q: 9- www d D F e

A:

Q: To make a peg adjustment, the following notes were taken. Wye level at 1 Wye level at 2 Rod reading…

A: Introduction- A way of setting a dumpy-level levelling instrument to bring the lines of collimation…

Q: What are the framing notes indicated in drawing of framing plan.

A: A framing plan is a drawing that shows the locations, sizes, spacings, materials (e.g., wood,…

Q: Q5/ In the plan below there is a conventional L shape stair, the distance between slabs is 2.9m find…

A: Solution: Given: Area for staircase provision: 2 m x 3 m staris width = 90 cm landing area = 90 cm x…

Q: 3. Defermine how many pieces of wood needed for window frame that requires 30 pieces having a 2 x 6…

A: Windows are fixed into the wall openings in the buildings for entry of daylight and air circulation.…

Q: Dimension of the interior ceiling is 9.00m x 2.00m. How many pieces of plywood is ecessary to cover…

A: To find number of plywood required to cover ceiling

Q: 70 27 52 18 27 14 34 OC

A: Handmade drawing are attached for better understanding.

Q: Find the number of 4" x 4" tiles that are needed for the kitchen floor (the shaded region.)

A: Total numbers of tiles needed = Total shaded area / Area of each tile Detailed solution below . Hope…

Q: Illustrate the roof framing layout (using wood rafters) for a 5.00m x 6.00m bungalow with gable roof…

A:

Q: What is the area of a rectantular floor that is 7'-3" long and 4'-2" wide?

A: Solution given That Length of rectangular floor= 7'3" Width of rectangular Floor=4'2"

Q: Identify the brick orientations depicted below. А E C 1. Sailor 2. Rowlock 3. Stretcher 4. Header 5.…

A:

Q: Q1-Calculate the number of steps for a concrete stair with a space 290 x 310 cm to go up from ground…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 4. To make a peg adjustment, the following notes were taken. Wye level at 1 Wye level at 2 Rod…

A: Let the error on the rod Q  when the instrument is of 1 be 'a'.   Case - 1 = Reading of rod P -…

Q: Q3: find the earth work of given original compound wall shown in fig below:- N.GL 024 PLAN 00 0.80

A:

Q: Draw the FBD

A:

Q: draw the floor framing in isometric

A: Isometric view eliminates the distortion of shape which is created by true perspective. It…