1. Explain with a neat block diagram the measurement of temperature using RTD (measuring system).

Q: 1. Are the theoretical calculations and measured values are equal? Explain?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: What is the voltage drop across RC, VC, in volts?  (Enter the number, not the units.)

A: Given circuit is -

Q: What are the differences between pressure sensor, pressure gauge and pressure transmitter?  Explain…

A: Pressure sensor : It is a device that measure the pressure of gas or liquid. Generally pressure…

Q: Explain any four dynamic characteristics of   measurement system

A: Every instrument is sensitive towards some factors like heat, pressure, resistance etc. due to these…

Q: Identify a real life device/control system application configured as Open-loop Control System and…

A:

Q: Compare the operation of a Nuclear power plant with the Thermal power plant?

A: In this question , we will compare the operation of nuclear power plant to thermal power plant..

Q: With neat sketch explain the types and operation of oil circuit breaker

A: Types of the circuit breaker, 1. Low oil circuit breaker 2. Bulk oil circuit breaker Plain break…

Q: Differentiate analog systems from digital systems. Provide points to your claims.

A: Both digital and the analog systems are used to transmit and received information (or signals). The…

Q: Compare the operation of a Nuclear power plant with the Thermal power plant.

A: As per bartleby guidelines for more than one question asked only first is to be answered please…

Q: How IGBT is classified based on its layer of construction? Compare the characteristics of the device…

A: Insulated-Gate Bipolar Transistor(IGBT) IGBT combines the physics of each BJT and energy MOSFET to…

Q: (i) With neat sketch explain the dynamic turn OFF characteristics of the device which is used in…

A: A SCR (thyristor) is the device used in high power applications. Before learning about the turn off…

Q: ckt diagram of refrigerator

A: In refrigerator, split single phase induction motor is used to run the compressor unit. Compressor…

Q: Explain any four dynamic characteristics of measurement system.

A: The explanation is as follows.

Q: Part 2: Analysis and selection of the Wind Turbine. The team decides at install a 30 MW wind farm.…

A: 1: Analysis and selection of the Wind Turbine.The team decides to install a 30 MW wind farm. The…

Q: 1- For the Automatic Nighttime Thermostat circuit, describe how the sub-circuits should be connected…

A: Thermostat circuit - Thermostat circuit is used to on and off heating system depends upon air…

Q: Make a list of 20 items in your environment that contain electronics. A PC and its peripherals are…

A: The list of 20 items in our environment that contain electronics are as follows; 1. Refrigerators…

Q: Draw the block diagram of a Pressure measurement system .Also identify the names of the  functional…

A: The block diagram of a Pressure measurement system is as follows:

Q: Briefly explain the operation of a counter controlled ADC

A:

Q: Explain the elements of measurement system in detail

A: Measurement system : measurement system is combination of various component which measures the…

Q: Discuss briefly the classification of electrical heating method

A: The classification of electrical heating method:

Q: 1. For Power Electronic devices, please answer the following questions. (1) In year , power…

A:

Q: What are the Rules in Performing Laboratory experiments in the Electrical Engineering Laboratory?…

A: It's vitally important to take safety precautions when working with electricity. Safety must not be…

Q: About the electrical circuit using the ladder diagram (PLC Ladder)? 24G 4 G

A:

Q: Explain clearly whether the system

A:

Q: What are the risks associated with NOT implementing ISO 27001 in an organization ? What are some…

A: ISO 27001: It provides a standard framework to manage information and data for a modern…

Q: ne of the major functions of transfer switches and equipment is to _____? A. Prevent the dangerous…

A: A transfer switch is a type of electrical switch that allows a load to be switched between two power…

Q: Draw the block diagram of a Temperature measurement system .Also identify the names of the…

A: Temperature Measurement System - The temperature measurement system is a device that is used to…

Q: 3. With the help of a solar panel name plate, explain each and every parameter displayed in it in a…

A: Solution3 - Generally, a solar panel nameplate contains the following parameters - 1. Maximum…

Q: Microwave level sensor

A:

Q: С1 Define circuit breaker and write any two types. (Б)

A: Generation, distribution, and transmission are the three components of the electric power system.…

Q: Explain with a neat block diagram the measurement of temperature using RTD

A: On the principle of metal resistance increasing with temperature we use a device which is Resistance…

Q: What should the K range be for the system to be

A:

Q: Q2 / Draw block diagram for AM demodulation?

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: 11. If DS1 shorted, what is the voltage across the terminals of DS1 if a multi-tester set at 600V AC…

A: If DS1 shorted, what is the voltage across the terminals of DS1 if a multi-tester set at 600V AC…

Q: Explain how Electrical Testing can be useful in identification of defects of electrical equipment or…

A:

Q: Explain how to wire residential panels, lighting, receptacles, GFCI circuit breakers, and 240 Vac…

A: Electrical wiring is done in residential buildings to provide power for lights, fans, pumps, and…

Q: Q/ Do you observe any relation between the system damping ratio and the system settling time.

A: We need to tell about relationships between damping ratio and settling time

Q: Draw the block diagram of a CPU showing the basic units. Explain the functions of each unit shortly.

A:

Q: How do the different parameters vary with ic?

A:

Q: Name three parameters that a no-load/open circuit test could measure for you

A: No-load test: This test is carried out on the low voltage side when the high voltage side is open…

Q: What happens to availability as the MTTR rises, implying that repairing a device becomes more…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 5. Labeling the pin numbers of 7432 IC

A: 7432 has 4 OR gates of 2 inputs in 1 package.

Q: In what circumstances would ICs be required?  Discuss three points.

A: Given :  Brief description: In the above question they want to know the advantages of the integrated…

Q: Identify the troubleshooting procedures to determine the serviceability state of the circuits

A: Answer :- Trouble shooting of an electronic circuit is a process of having an inspiration on…

Q: xplain the essential features of Indicating Instruments Please do not write the answer on a…

A: Indicating Instruments - An indicating instrument is simply a movable mechanism pivoting on jewel…

Q: Draw a freehand sketch of the model of the structure that will house electronic circuit

A: Brief concept Electronic circuits are those circuits which deals with high frequency and low…

Q: Explain the important functions of the condenser in a thermal power station.

A: Condenser is a part of regenerative feed heating system. It is also called as condensate recovery…

Q: In this section, you will describe the major responsibilities that must be fulfilled during the…

A: With the advancement of microprocessor, microcontroller,  Intergrated IC, Design of Electronics…

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.