1. Find the voltages across the following components (a and b) after 1 second. The Capacitor is initially charged at 10V while the voltage source is 1V. Resistor R is 103 ohm while capacitor C is 1mF. a. Capacitor C b. Resistor R c. What is the best 1st order DE Method applicable to this problem?

1. Find the voltages across the following components (a and b) after 1 second. The Capacitor is initially charged at 10V while the voltage source is 1V. Resistor R is 103 ohm while capacitor C is 1mF. a. Capacitor C b. Resistor R c. What is the best 1st order DE Method applicable to this problem?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 2PA: You are working in an industrial plant. You have been instructed to double the capacitance connected...

See similar textbooks

Related questions

Q: Q.9: The initial charge on the capacitor is 100µCoulomb: 1. Write the transient current equation. 2.…

Q: Electrical Engineering --question 1-- Calculate the theoretical voltages across the resistor and…

Q: Identify from the following statement when the capacitance can be discharged? a. If resistor is…

A: In this question , we will find when capacitor discharged..

Q: An air filled capacitor of Co-2.0 µF is fully charged with Qo-51.0 µC using an electromotive force…

A: It is given in the question that an air-filled capacitor is charged with a charge Qo using an…

Q: A variable capacitance and a resistance of 290 2 are connected in series across a 110-V; 60-Hz…

A: In this question, We need to draw the impedance complex locus and current locus. Also find the…

Q: Design a simple charging circuit using a 100 V source, a 1M resistor and a capacitor. The circuit…

A: The capacitor will not reach its final immediately after giving the input it will take five times…

Q: Q 1: A variable capacitance and a resistance of 300 2 are connected in series across a 240-V; 50-Hz…

Q: Q13 A variable capacitance and a resistance of 290 2 are connected in series across a 110-V; 60-Hz…

A: In this question, A resistance R= 290 ohm and capacitance C(6uF -32uF) are connected to the voltage…

Q: A charge Q is placed on a capacitor of capacitance C. The capacitor is connected into the circuit…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: What is a true statement about the capacitors connected in series illustrated below? C 30 AV O The…

A: Energy stored in capacitors is calculated as

Q: 41. A fluorescent lamp (commonly known as tube light) employs a choke coil (an inductor) and a…

A: The voltage drop in an element is given by the current through it multiplied by the impedance. The…

Q: a) A variable capacitance and a resistance of 160 2 are connected in series across a 240-V; 50-Hz…

A: In this question, We need to draw the impedance curve and current locus. We know I= V/Z Z= R-jXc…

Q: 4) Analyze the circuit given below to determine the charge stored in capacitor C4. C2 2uF C1 12UF C5…

Q: How do you describe the relationship of the value of the capacitance of a capacitor to the charge it…

A: This question belongs to circuit theory . It is based on the concept of relation among capacitance ,…

Q: mine the value of the capacitor C to be connected in parallel with the total load to he PF to unity.…

Q: A 0.68k2 В + 5V 220nF

Q: The circuit in the figure below has been connected for a long time. Let R1 = 7.80 Ω and R2 = 4.20…

Q: Determine the total capacitance, total charge, individual voltage drop and charges across each…

A: given circuit We have to calculate total capacitance, total charge, individual voltage drop an d…

Q: alC a) variable capacitance and a resistance of 160 Q are connected in series across a 240-V; 50-Hz…

A: In this question, We need to draw the impedance or locus of impedance and current as per change of…

Q: Assume the capacitor is initially uncharged. Find the mathematical expressions and plot the…

A: We need to find out the voltage and current for given circuit

Q: J01] The current in a 150 µH inductor is known to be as follows: iL = 25te S0X A for t 0. %3D a)…

A: In this question we will find voltage and power in inductor... Note:- as per our guidelines , i will…

Q: A- Find the charge on the capacitor at t = 30 B- Find the voltage on the capacitor at t = 50 C-…

Q: 10. In the figure, suppose the switch has been closed for a time interval sufficiently long for the…

A: The voltage across a capacitor will not change suddenly unless an impulse source is applied. Under…

Q: Obtain the equivalent capacitance in pF. Determine the charge Q1 (nC) at the capacitor C1.…

A: The solution can be achieved as follows.

Q: Q 1: A variable capacitance and a resistance of 300 2 are connected in series across a 240-V; 50-Hz…

A: In this question, Draw the impedance diagram and current locus. Find the value of capacitance C if…

Q: A utility company plans to connect a total of 20 mF of capacitance to a 7200-V line. To make this…

Q: For the circuit shown below, find an expression for the voltage drop across the inductor after the…

A: Find the current through the inductor for t < 0.

Q: switch In the figure, suppose the switch has been closed for a time interval sufficiently long for…

A: Given- Voltage = 42 V R1 = 8 ohm R2 = 6 ohm R3 = 3 ohm C = 4 μF

Q: Q)3 A variable capacitance and a resistance of 290 N are connected in series across a 110-V; 60-Hz…

A: In this question, We need to find the capacitance to give a current of 0.6 A and also find the…

Q: Take note that for the capacitor, the input in the software must be the capacitance in nano-Farad…

Q: t = 0 3R1 kohm ww R1 kohm Ci µF +1

Q: A capacitor of 10pfarad consist of two parallel plates each having an area of 200 cm^2, separated in…

Q: What we are mean by the string efficiency and what you think its value for three insulator string if…

A: Given, for three insulator string The string efficiency is the ratio of the total voltage across the…

Q: For the circuit, now keep switch J2 closed, close switch J1. Determine the expressions for the…

Q: 3. For the circuit, (i) Find the voltage vc and the current ic if the capacitor was initially…

A: At steady state capacitor acts as open circuit

Q: 10. A resistor of 50-ohms, inductor of 2-henry and a 0.005-farad capacitor are connected in series…

Q: 7. Find the voltages across the following components (a and b) after 1 second. The Capacitor is…

A: Here, we are given a circuit that consists of a series connection of a resistor (R) and a capacitor…

Q: Between the plates of a flat capacitor there is a tightly fitting glass plate (e = 7). The capacitor…

A: Given data: ε=7 U=100 V

Q: a) Find the mathematical expression for the voltage VR (t).

A: Find the mathematical expression for the voltage VR (t).

Q: For the following circuit, obtain the table of voltages in the capacitor, for when the power supply…

A: As we have given : Vp-p=170 VR=1 kΩC=220 μF

Q: Sendent current s pute 100 mH Sketch the current waveform b. At what instant of time is the current…

A: Given Current source current at t<0, i=0 at t>0 , i=10…

Q: ** 18. The following questions refer to the circuit represented by the diagram at right. Think of R,…

A: According to the question we have to calculate, a) Immediately after the switch is closed,…

Q: H.W: for the circuit shown in figure find: (a) the charge in each capacitor. (b) The energy in each…

Q: a) Obtain the equivalent capacitance in pF b) Determine the charge Q1, Q2, and Q4 (nC) at the…

Q: Determine the total capacitance, total charge, individual voltage drop and charges across each…

A: According to question: The capacitance of branch 'ab' is calculated as…

Q: a. Draw an RC circuit diagram where a capacitor can be charged and discharged in the same circuit…

Q: 3_ Google for any catalogue for a power factor correction control and mention the main components of…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

1. Find the voltages across the following components (a and b) after 1
second. The Capacitor is initially charged at 10V while the voltage source
is 1V. Resistor R is 103 ohm while capacitor C is 1mF.
a. Capacitor C
b. Resistor R
c. What is the best 1st order DE Method applicable to this
problem?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
A 100-volt electromotive is applied to an RC-series circuit in which the resistance is 200ohms and the capacitance is 10-4 farad. Find the charge q(t) on the capacitor if q(0) = 0.Find the current i(t).
A small capacitor of 100 pF is charged by a steady current of 1 µA for 1 ms. At that time, the charging circuit is disconnected. a) What is the voltage across the capacitor when the charging finishes? b) A 10 MΩ resistor is connected across the capacitor to discharge it. Sketch a graph of the voltage V across the resistor as a function of time, with appropriate numbers and units marked on the axes.
A 100-volt electromotive force is applied to an RC-series circuit in which the resistance is 400 ohms and the capacitance is 10^-4 farad. Find the charge q(t) on the capacitor if q(O) = 0.q(t) = Find the current i(t).
The circuit in the figure below has been connected for a long time. Let R1 = 7.80 Ω and R2 = 4.20 Ω.(a) What is the potential difference across the capacitor? which is 6.03 (b) If the battery is disconnected from the circuit, over what time interval does the capacitor discharge to one-half its initial voltage? in eed b